We have previously shown that a saw-tooth surface with only horizontal vibration, simple planar and symmetric, can feed along microparts. The microparts move forward because they adhere to the saw-tooth surface more in the backward direction than in the fo
ICMDT 2007 JSME-KSME Joint International Conference on Manufacturing, Machine Design and Tribology
Feeding of Submillimeter-sized Microparts Along a Sawtooth Surface Using Only Horizontal and Symmetric Vibration: Effect of the Differences of Two Types of Capacitors on Feeding Velocity, Stability, and Rotational Motion* Atsushi Mitani** Toshiatsu Yoshimura*** and Shinich Hirai*** **Department of Design, Sapporo City University 1 Geijyutsu-no-mori, Minami-ku, Sapporo, Hokkaido, Japan E-mail:a.mitani@scu.ac.jp *** Depatment of Robotics, Ritsumeikan University 1-1-1 Noji-higashi, Kusatsu, Shiga, Japan
Abstract We have previously shown that a saw-tooth surface with only horizontal vibration, simple planar and symmetric, can feed along microparts. The microparts move forward because they adhere to the saw-tooth surface more in the backward direction than in the forward direction. Previously, we studied the effects of the pitch of the saw-tooth surface and the vibration frequency on the movement of 2012-type capacitors (2.0 x 1.2 x 0.6 mm, 7.5 mg). In the present study, we investigated the movement of smaller 0603-type capacitors (0.6 x 0.3 x 0.3 mm, 0.3 mg), and compared them with those of the larger capacitors. For the smaller capacitors, the fastest feeding was realized when the pitch was 0.05 mm. The smaller capacitors moved slower than the larger capacitors because the former were affected more by adhesion. In addition, feeding velocity of the smaller capacitors dispersed more than the larger capacitors. We observed the motion of a fed capacitor of each type. The smaller capacitor rotated around axis along groove of saw-tooth, because the micropart length to saw-tooth pitch ratio was smaller. We analysed rotational motion of the smaller capacitor. Key words: Sawtooth surface, Microparts, Feeding, Directionality, Vibratory linear feeder, Symmetric vibration
1. Introduction Devices to feed along submillimeter-sized microparts such as ceramic chip capacitors and resistors have become more common, as they are used for sorting microparts, which have become massed produced. We have previously shown that a saw-tooth surface with simple planar and symmetric vibration can be used to feed along microparts[1]. Because the contacts between the microparts and the sloping side of the tooth and between the microparts and the point of the tooth are different, the microparts adhere more strongly in one direction than in the other. This results in the microparts moving in one direction, since the adhesion force caused by electrostatic force, van deer Vaals force, intermolecular force, surface tension, and humidity,

热门文档