supl协议
5. Message Flows
Of all the message flows supported in SUPL 3.0, only those which involve ILP are shown in this section. All other message flows are omitted. Please refer to [SUPL 3.0 TS ULP] for a complete description of all SUPL 3.0 message flows. Please also note that message flows shown in this section are limited to non roaming scenarios since roaming has no impact on ILP (and ULP) message flows1. Please refer to [SUPL 3.0 TS ULP] for a detailed description of roaming scenarios.
The message flow descriptions presented in this section are focused on ILP. A more general description of the message flows and services involved (immediate service, deferred service, etc.) can be found in [SUPL 3.0 TS ULP] and is not repeated here.
NOTE: In SUPL 3.0 it is possible to use LPP (by itself), LPP+LPPe or TIA-801 as positioning protocol. Therefore the
following convention applies: LPP implies use of LPP only (i.e. without LPPe), LPPe implies use of LPP and
LPPe and TIA-801 implies use of TIA-801 only. A SUPL POS (LPP/LPPe/TIA-801) message means a SUPL POS
message carrying either LPP, LPP+LPPe or TIA-801 positioning payload.
To simply the message flows, the mandatory ILP header parameter sessionID2 and the mandatory ULP header
parameter sessionID are not shown in the message flow diagrams.
ILP message flows described in this section are limited to the H-SLP and E-SLP, respectively. D-SLP ILP
message flow scenarios (i.e., message flows between the D-SLC and the D-SPC) are not shown since they are
identical to H-SLP ILP message flows.
Optional parameters in the call flow diagrams of this chapter are shown in gray. NOTE: NOTE: NOTE:
1 In roaming scenarios, the V-SLP is invoked whenever the H-SLP requires translation of enhanced cell/sector/AP
information into a position estimate due to SUPL roaming.
SUPL 技术 [写在前面 写在前面]3G 除了将带来一个宽带、多媒体的无线互联时代...外部 LBS 应用 和定位平台的接口仍然遵循 OMA MLP 或 3GPP Le 接口协议。 二...
基于SUPL的A_GPS移动定位系统的研究与设计_工学_...(4 如何判 定终端是 否 支持 SU L 协议 本文...c v l Fi n i l ay e T c hn O 】 O ...
TS 03.40) 对这些信息的鉴权和管理功能,同时 ...(V1.0.0) 》 《基于CELLID的位置业务总体技术...比Control-plane方式节省投 资 OMA SUPL协议:适用于...
? OMA ,主要定义了 SUPL 协议流程; 3GPP,主要定义了 RRLP 消息和 A-GPS ...2D 位置误差、响应时间的定义及测试参数要 求均参照 3GPP TS34.171 第五章中...
采用基于应用层的A-GPS技术,使用OMA SUPL协议。 普通GPS接收机搜索卫星需要时间较长。AGPS系统首先根据 GPS接收机搜索卫星需要时间较长 普通GPS接收机搜索卫星需要...
终端能力判断模块记录终端是否为A-GPS 终端 (现阶段),支持SUPL 协议版本号(下...Le 接口:SP Proxy 模块对外与SP/CP 之间的接口,采用OMA 组 织的Le 接口。...
? OMA ,主要定义了 SUPL 协议流程; 3GPP,主要定义了 RRLP 消息和 A-GPS ...2D 位置误差、响应时间的定义及测试参数要 求均参照 3GPP TS34.171 第五章中...
热门文档