supl协议
3. Terminology and Conventions
3.1 Conventions
The key words “MUST”, “MUST NOT”, “REQUIRED”, “SHALL”, “SHALL NOT”, “SHOULD”, “SHOULD NOT”, “RECOMMENDED”, “MAY”, and “OPTIONAL” in this document are to be interpreted as described in [RFC 2119]. All sections and appendixes, except “Scope” and “Introduction”, are normative, unless they are explicitly indicated to be informative.
3.2 Definitions
Area ID
I-WLAN Area ID is the identity of an area in a wireless network. The interworking WLAN refers to the system for interworking between 3GPP/3GPP2 systems and
WLAN. The intent of 3GPP/3GPP2–WLAN Interworking is to extend 3GPP/3GPP2 services and
functionality to the WLAN access environment. The 3GPP/3GPP2–WLAN Interworking System provides
bearer services allowing a 3GPP/3GPP2 subscriber to use a WLAN to access 3GPP/3GPP2 PS based
services.
The Location ID defines the current serving cell, current serving WLAN AP or current serving WiMAX
BS information of the SET.
Major versions are likely to contain major feature additions; MAY contain incompatibilities with previous
specification revisions; and though unlikely, could change, drop, or replace standard or existing interfaces.
Initial releases are “1_0”. [OMAOPS]
Minor versions are likely to contain minor feature additions, be compatible with the preceding Major
version. Minor specification revision include existing interfaces, although it MAY provide evolving
interfaces. The initial minor release for any major release is “0”, i.e. 1_0 [OMAOPS]
The Multiple Location IDs parameter may contain current non-serving cell, current non-serving WLAN
AP or current non-sercing WiMAX BS information for the SET and/or historic serving or non-serving
cell, WLAN AP or WiMAX BS information for the SET.
A set of attributes associated with a request for the geographic position of SET. The attributes include the
required horizontal accuracy, vertical accuracy, max location age, and response time of the SET position.
Service indicators are intended to be compatible with the Major_ Minor release they relate to but add bug
fixes. No new functions will be added through the release of Service Indicators. [OMAOPS]
For positioning not associated with an emergency services call, SUPL roaming occurs when a SET leaves
the service area of its H-SLP. For positioning associated with an emergency services call, SUPL roaming
occurs when the SET is not within the service area of the E-SLP. The service area of an H-SLP or E-SLP
includes the area within which the H-SLP or E-SLP can provide a position estimate for a SET or relevant
assistance data to a SET without contacting other SLPs. It should be noted that an H-SLP or E-SLP
service area is not necessarily associated with the service area(s) of the underlying wireless network(s). In
the case of service from a D-SLP, the H-SLP will normally assign a geographic service area within which
the SET may access the D-SLP. Service from a D-SLP where the SET is roaming outside the assigned
service area of the D-SLP is not supported.
LPP implies use of LPP only
LPPe implies use of LPP and LPPe Location ID Major Version Minor Version Multiple Location IDs Quality of Position Service Indicator SUPL Roaming LPP LPPe
3.3 Abbreviations
AP
BS
CI Access Point (WLAN) Base Station (WiMAX) Cell Identity (3GPP)
SUPL 技术 [写在前面 写在前面]3G 除了将带来一个宽带、多媒体的无线互联时代...外部 LBS 应用 和定位平台的接口仍然遵循 OMA MLP 或 3GPP Le 接口协议。 二...
基于SUPL的A_GPS移动定位系统的研究与设计_工学_...(4 如何判 定终端是 否 支持 SU L 协议 本文...c v l Fi n i l ay e T c hn O 】 O ...
TS 03.40) 对这些信息的鉴权和管理功能,同时 ...(V1.0.0) 》 《基于CELLID的位置业务总体技术...比Control-plane方式节省投 资 OMA SUPL协议:适用于...
? OMA ,主要定义了 SUPL 协议流程; 3GPP,主要定义了 RRLP 消息和 A-GPS ...2D 位置误差、响应时间的定义及测试参数要 求均参照 3GPP TS34.171 第五章中...
采用基于应用层的A-GPS技术,使用OMA SUPL协议。 普通GPS接收机搜索卫星需要时间较长。AGPS系统首先根据 GPS接收机搜索卫星需要时间较长 普通GPS接收机搜索卫星需要...
终端能力判断模块记录终端是否为A-GPS 终端 (现阶段),支持SUPL 协议版本号(下...Le 接口:SP Proxy 模块对外与SP/CP 之间的接口,采用OMA 组 织的Le 接口。...
? OMA ,主要定义了 SUPL 协议流程; 3GPP,主要定义了 RRLP 消息和 A-GPS ...2D 位置误差、响应时间的定义及测试参数要 求均参照 3GPP TS34.171 第五章中...
热门文档