The visible band (band A) of Photoluminescence spectra of high-purity synthesized diamond is analyzed by deconvolution technique. A set of eight lines with distinct peak energy are found. The peak energy and the width of these lines were either constant or
FIG. 1. PL spectra at room temperature, corrected for the measurement sensitivity. The shoulder at 220 nm is due to Rayleigh scattering and Raman peak of diamond. The inset shows the peak intensity dependence on input power; open circle, visible band (at 520 nm); close circle, FE emission (at 235 nm). The line is drawn to guide the eye.[4]
The vacancies and their related properties in diamond and Diamond-Like Carbon (DLC) both in theoretical aspect[1] and experimental results[2] are fascinating subjects. DLC produced by di erent techniques, arti cial diamond produced by high pressure and high temperature show peculiar Photoluminescence (PL)[3,4], Cathodeluminescence (CL)[5] and absorption[2]. There are di erent peaks and cranks in the absorption, PL and CL spectra of these materials, which some of them are related to the vacancies present in them. Many of these peaks are not simple and are a combination of di erent absorption or emission lines[2]. Undisturbed vacancies have almost all the rotational symmetry of the main crystal, which for diamond is Td . The zero phonon line at 1.673eV and the line at 3.145eV which reported by many groups, are associated to undisturbed neutral vacancies (V )[6] and undisturbed negatively charged vacancies (V )[7] respectively. Much work has been done on the e ect of uniaxial stress in natural diamond to explain the lines of the general radiation centers band (GR1) that has many peaks from 1.5eV up to 2.8eV. Strong internal stress exist in DLC lms[8]. It has been reported that for lms there is a strong correlation between PL intensity and stress[9]. In this article, we show that for arti cial diamond similar e ect is possible due to local stress e ect. The data analyzed here, is for the sample that was grown by high pressure and high temperature
-gradient method where nitrogen-getter was added to the solvent. The nitrogen concentration was estimated to be less than 0.1 ppm by infra-red(IR) absorption spectroscopy. The full width at half maximum of diamond Raman peak at 1333 cm 1 is 1.6 cm 1 and smaller than that of typical natural type IIa diamond, 1.9 cm 1, which indicates a low concentration of defects in the sample. Still the e ect of these defects (vacancies surrounding metallic atoms) is small but visible in Photoluminaces spectra. The PL spectra of this crystal at several temperatures from 400 K down to 8.4 k were measured and reported by K. Horiuchi and his coworkers[4]. The complete spectra at room temperature is shown in Fig. (1). The strong exiton line in the room temperature spectra of 2

Band of the Ordered Macroporous WO3 Films_电子/...the visible regions have been highly desired, ...Recently, the synthetic methods of an ordered ...
the synthetic V light curves for a circular spot...(i.e. one visible at all phases) whose total... especially in the cores of strong lines of ...
Introduction There are at present many synthetic ... reflections of the roofs are hardly visible (...(this is not exact but since the lines are ...
band gap lead to visible light absorption which ...A typical synthetic procedure is as follows: 0....(EDX) for the determination of metal composition....
lled diamonds: both C and N lines visible. ...The synthetic non-LTE models were constructed ...6 Heber The ?nal composition of the envelope is...
synthetic methodology involving (i) Au nanoparticle...visible dislocations, where a defect-free interface...confirmed the composition of the designed ...
synthetic methodology involving (i) Au nanoparticle...visible dislocations, where a defect-free interface...confirmed the composition of the designed ...
热门文档