文档下载 文档下载导航
设为首页 | 加入收藏
搜索 请输入内容:  
 导航当前位置: 文档下载 > 所有分类 > 工程科技 > 交通运输 > Investigation of the Bed and Rear Flap Variation for a Low-Drag Pickup Truck Using DOE
侵权投诉

Investigation of the Bed and Rear Flap Variation for a Low-Drag Pickup Truck Using DOE

Investigation of the Bed and Rear Flap Variation for a Low-Drag Pickup Truck Using Design of Experiments

Investigation of the Bed and Rear Flap Variation fora Low-Drag Pickup Truck using Design ofExperiments

Jongsoo Ha, Shinkyu Jeong and Shigeru Obayashi

Tohoku University

2010-01-0122

Published04/12/2010

Copyright © 2010 SAE International

ABSTRACT

The drag reduction effect was investigated with regard to thebed and rear flap variation for a pickup truck through designof experiments process. The design factors were the bedlength, bed height, rear flap length, and flap inset with threelevels, and the noise factor was the yaw angle. The signal-to-noise ratio calculation was introduced to evaluate the low-drag performance under a crosswind. Analysis of varianceindicated the significant interaction effect between the bedlength and bed height. Since the bed flow of the short withlow bed was attached to the tailgate, which increased the dragcoefficient and lowered the S/N ratio. The rear flap add-on atthe rear edge of a roof was effective to reduce the dragcoefficient. However, the sensitivity of the flap lengthvariation on the drag reduction was not significant. The flapinset had a negative effect on the drag reduction as it loweredthe inset area pressure of the cabin back surface.Consequently, in order to reduce the drag coefficient of apickup truck, the rear flap should be installed without anyoffset.

the cab shear layer and no recirculating flow region behindthe tailgate in the symmetry plane, which is believed to bedue to the downwash from streamwise vorticity in the nearwake. Yang et al.et al.et al.performed numerical analyses of the flow characteristics of apickup truck using their own computational fluid dynamics(CFD) schemes, and reported that CFD data qualitativelymatched well with the experimental results. Mohktar et al.performed a computational investigation of the effect of thepickup truck configurations (flat bed, tailgate-off, tailgate-down, tailgate-up) on the structure of the flow around thevehicle and on the generated aerodynamic drag force. Theyfound that there is a large separation region downstream ofthe cab, and that it controls the drag coefficient. The size ofthe separation region above the bed is directly related to thebed configuration. Based on the results of full-scale windtunnel experiments, Cooperlowering of the tailgate increases the drag force. However,the earlier published works involve simply analysis of theflow structure around the pickup truck, and are not sufficientfor the drag reduction, which is one of the major issues inautomobile engineering.

The purpose of this present study is to investigate the dragreduction effect for a low-drag pickup truck through theTaguchi's method in design of experiments process. Fourvariables (bed length, bed height, flap length, and flap inset)are considered as design factors, and are combined togetherfor the bed and rear flap variation. Drag coefficients of themodel regarding the variation are measured with varying yawangles, and treated mathematically to evaluate the low-dragperformance.

Investigation of the Bed and Rear Flap Variation for a Low-Drag Pickup Truck Using DOE

INTRODUCTION

A pickup truck, a light motor vehicle with an open-top rearcargo area, is one of the best selling vehicle types around theworld, especially in North America. The flow field around apickup truck is complex due to the open bed behind the cabin,and it is difficult to understand the flow characteristics.Therefore, there is increasing research interest regarding theaerodynamics of pickup trucks. Al-Garni et al.experimental data set of the flow structure in the near wakeregion of a generic pickup truck to gain a betterunderstanding of the flow field around the vehicle. Theyreported a recirculating flow region over the bed bounded by

第1页

你可能喜欢

热门文档

相关文档

站点地图 | 文档上传 | 侵权投诉 | 手机版
本站所有资源均来自互联网,本站只负责收集和整理,均不承担任何法律责任,如有侵权等其它行为请联系我们.
文档下载 Copyright 2013 doc.guandang.net All Rights Reserved.  -  email