Abstract: In this paper modelling and queuing analysis of variable-bit-rate (VBR) MPEG coded video sources in B-ISDN networks based on ATM are studied. Modelling is performed by examining a low pass version of the aggregate MPEG sequence, capable of captur
Prediction of Cell Losses for VBR MPEG
Encoders
Anastasios Doulamis, Nikolaos Doulamis and Stefanos Kollias
National Technical University of Athens
Dept. of Electrical and Computer Engineering
email: adoulam@image.ntua.gr
Abstract: In this paper modelling and queuing analysis of variable-bit-rate (VBR) MPEG coded videosources in B-ISDN networks based on ATM are studied. Modelling is performed by examining a low passversion of the aggregate MPEG sequence, capable of capturing the video activity. A discrete state continuoustime Markov chain is then proposed to approximate the aggregate MPEG traffic. The previous model is used,combined with flow equivalent queuing analysis, to obtain analytical solution of cell losses. Experimentalresults are presented indicating that the proposed model is a good predictor of network resources.1. Introduction
No doubt, digital video is expected to be a major traffic component over B-ISDN networks.However, uncompressed video information is hardly transmitted, even over high-speed cables, dueto large bandwidth requirements and the increasing demands for video transmission. Several codingalgorithms have been proposed in the literature for achieving efficient video compression whilesimultaneously maintaining an acceptable picture quality. Recent efforts towards this goal havestimulated the MPEG-1/2 coding standards, which have been developed for storage of compressedvideo and TV transmission respectively and now appear in commercial exploitation.
Technological progress both in field of electronics and optics, as well as the requirement for aflexible telecommunication network design, able to integrate various services of different kind, ledthe CCITT to adopt the Asynchronous Transfer Mode (ATM) principle. However, this moderequires the development of effective congestion control schemes which are responsible formaintaining an acceptable quality of service (QoS) level that is derivable by the network. Accordingto the available network resources, these schemes ensure that the negotiated traffic characteristicparameters are not exceeded. To determine which congestion scheme should be used, modelling oftransmitted information is required.
In real time video or multimedia applications, the network should guarantee a minimum level ofpicture distortion. However, if a tolerated picture degradation level is given, encoder rate will betime varying, according to the scene complexity (variable bit rate-VBR-coding mode). The maindifficulty of transmitting VBR coded video streams through communication lines, which are ofconstant rate, is that they also require time varying bandwidth. To “tailor” VBR encoders into achannel of speed lower than the maximum coding rate, buffers are used which absorbs statisticalpeaks of the traffic by temporarily storing video information. In this case if the amount of dataexceed the buffer size, then losses occur.
Several video models for VBR coded sources have been proposed in the literature. The firstpioneer attempts were by Haskell and Limp who proposed and simulated statistical multiplexingvideo for picturephone encoders [6,9]. In [10] a single video stream of a telephone scene is analysedand two models are shown to fit well the experimental data. A more accurate model has beenproposed in [7] for VBR teleconference sequences. Scene modelling is performed by Frater et al.
[5] for video films whose the autocorrelation functions indicate a long-range dependence.Since traffic models depend on video statistical properties and characteristics, theaforementioned approaches cannot directly be applied to MPEG coded video sources. Recently,some works, mainly dealing with MPEG statistical properties, have been reported. An approach toefficient modelling of MPEG coded video sources has been proposed in one of our earlier work [4]by examining MPEG streams at three different layers. However, in this work computer simulationis required for estimating the network resources since the involved models are not susceptible ofanalytical solution. In this paper, we perform queuing analysis, based on Markov models, and ananalytical solution of estimating the appropriate buffer size and cell losses is derived. The proposedmethodology provides accurate prediction of the actual traffic for point to point connections.
Prediction of Core Losses of Three-Phase Distribution Transformer_农学_农林牧渔_专业资料。Journal ofEnergy and Power Engineering 7(2013)2347- Journal...
Modeling and Adaptive Prediction of VBR MPEG Video...before performing modeling of VBR MPEG encoders, ...cell losses versus bu er size for video Source ...
Prediction of Boiler D... 5人阅读 7页 2.00 Investigation of the s... 6人阅读 10页 2.00 A new adaptive backste... 12人阅读 6页 2...
we are interested in video traffic prediction. Experimental...VBR MPEG encoders to briefly describe the MPEG ...Table I presents the cell losses for each ...
Prediction of Macrobending and Splice Losses for Photonic Crystal Fibers based on the Effective Index Method G. S. KLIROS, J. KONSTANTINIDIS, C. THRASKIAS...
Prediction of Cell Losse... 暂无评价 6页 免费 Impact of Video Scheduli.....Joint impact of MPEG-2 encoding rate and ATM cell losses on video quality...
for future frames using adaptive linear prediction ...large delays, and excessive cell losses 1, 14]...3 4 Forecasting Empirical MPEG-I VBR Traces We ...
Most of the encoders will use this scheme and ...prediction of future frames based on motion ...overestimates the cell losses for larger bu er ...
since they can use prediction from both a previous...together before cell losses exceed a certain value...El Zarki, "Prioritized transmission of VBR MPEG ...
the average encoding bitrate for VBR MPEG2 video...Our work focuses on video quality prediction and ...Loss Propagation I Picture 1 Cell Losses Figure ...
热门文档