PMDG_MD11_FSX

PMDG MD-11 1.20.0055 Update Notes
Changes that apply to both the FSX and FS9 versions
1. Virtual Cockpit: Fixed brakes pressure needle disappearing when PNL lights were turned on.
2. Added safeguard against "bad" flight plan files that caused freezing when origin/destination ICAO codes were entered in the F-PLN INIT page fields.
3. Fixed CTD issues with airports that had a very large number of SID/STAR procedures (e.g. LFPG in AIRAC-0901 that includes 159 SIDs).
4. The MCDU FIX page was displaying the course to the FIX instead of the FIX radial at the top of the page.
5. In case of a non-precision approach the "MIN PROF" label was not displayed on the F-PLN
page (small fonts above the first waypoint with an estimated altitude lower than the MIN PROF altitude).
6. "NO TAXI" indication now displays on both PFDs when any of the three IRU systems is in the align phase. In previous versions it was displayed only on the captains PFD when IRU-1 was
aligning and only on the F/Os PFD when IRU-2 was aligning.
7. Fixed issue of ALT HOLD mode and ATS speed-on-thrust engaging on the ground during
preflight when the FCP altitude was set within 20ft of the current altitude.
8. Added missing electrical dependencies for Radio Altimeters. RA1 is powered by AC1 bus and
RA2 by AC3 bus. When either RA is unpowered an amber "X" will display on the corresponding PFD in place of the RA readout. Autoland mode requires both RAs available, so if either RA fails the land mode will be APPR ONLY. Also, CAWS RA callouts and DH "Minimums" callouts will not be available when both RAs fail.
9. Autoland is now possible with one IRU inoperative in SINGLE LAND mode.
10. Corrected electrical dependency for GPWS to be AC1 bus (was DC Battery Bus in previous versions).
11. Auto Ground Spoilers is unavailable with AC1 bus unpowered ("DISARM SPOILERS" and "USE MAN SPOILERS" alerts apply).
12. Automatic Slats Extension (during stall conditions) is unavailable with AC3 bus unpowered.
13. In case of a landing performed with ATS disengaged, "Approach Idle" thrust was not removed
until on ground, preventing spoilers deployment and autobrakes engagement at touchdown. Now "approach idle" is removed at 50 ft AGL.
14. Reversers are operated by corresponding engine pneumatic (GE engines) or hydraulic (PW
engines) system. This was not modeled in previous versions and it was possible to operate the reversers (sleeve movement) even in a cold & dark situation.
15. Fixed issues with Altitude Hold when simulation rate is set at 2x.
16. Fix for descend path calculation for the case of a forced soft restriction followed by several
speed only restrictions.
17. Fixed predicted wind heading/speed values following interpolation through climb/descend
forecast table.
18. Fixed wind forecast effect on top-of-descend and descend path calculation.
19. Fixed issue with reconfiguration of DUs in case one DU fails. In previous versions when the
SDCP SD switch was pressed the ND display was replaced by a second SD display.
PMDG MD-11 FSX Update Notes Version number: v1.10.0051 External Model 1...33. Changes in APU inflight start up logic: In previous versions APU ...
-- User Defined Command Aliases -Make any changes or additions to the ... *tel_editc pmdg, *TEL_SOCKSEC scpm, *tel_symsec gbtj, (ITgDwgLib "03...
Make any changes or additions to the default AutoCAD command aliases in ;... *tel_editc pmdg, *TEL_SOCKSEC scpm, *tel_symsec gbtj, (ITgDwgLib "03...
Make any changes or additions to the default AutoCAD command aliases in ;... *tel_editc pmdg, *TEL_SOCKSEC scpm, *tel_symsec gbtj, (ITgDwgLib "03...
热门文档