文档下载 文档下载导航
设为首页 | 加入收藏
搜索 请输入内容:  
 导航当前位置: 文档下载 > 所有分类 > 工程科技 > 建筑/土木 > Finite Element Modeling of Reinforced Concrete Beams Strengthened Strengthened with FRP Laminates
侵权投诉

Finite Element Modeling of Reinforced Concrete Beams Strengthened Strengthened with FRP Laminates

Finite Element Modeling of Reinforced Concrete Beams Strengthened Strengthened with FRP Laminates

European Journal of Scientific Research

ISSN 1450-216X Vol.30 No.4 (2009), pp.526-541 © EuroJournals Publishing, Inc. 2009 doc.guandang.net

Finite Element Modeling of Reinforced Concrete Beams

Strengthened with FRP Laminates

Amer M. Ibrahim

Asst. prof, College of engineering

Diyala University, Iraq

Mohammed Sh. Mahmood Asst. lecturer, College of engineering

Diyala University, Iraq

Abstract

In this paper an analysis model is presented for reinforced concrete beams externally reinforced with fiber reinforced polymer (FRP) laminates using finite elements method adopted by ANSYS. The finite element models are developed using a smeared cracking approach for concrete and three dimensional layered elements for the FRP composites. The results obtained from the ANSYS finite element analysis are compared with the experimental data for six beams with different conditions from researches (all beams are deficient shear reinforcement). The comparisons are made for load-deflection curves at mid-span; and failure load. The results from finite element analysis were calculated at the same location as the experimental test of the beams. The accuracy of the finite element models is assessed by comparison with the experimental results, which are to be in good agreement. The load-deflection curves from the finite element analysis agree well with the experimental results in the linear range, but the finite elements results are slightly stiffer than that from the experimental results. The maximum difference in ultimate loads for all cases is 7.8%.

Keywords: Finite Element Modeling; Reinforced Concrete Beams; FRP Laminates

Introduction

Externally bonded FRP laminates and fabrics can be used to increase the shear strength of reinforced concrete beams and columns. Figure1 shows examples of possible FRP shear strengthening configurations. It can be seen that the shear strength of columns can be easily improved by wrapping with a continuous sheet of FRP to form a complete ring around the member. Shear strengthening of beams, however, is likely to be more problematic when they are cast monolithically with slabs. This increases the difficulty of anchoring the FRP at the beam/slab junction and increases the risk of debonding failure. Nevertheless, bonding FRP on either the side faces, or the side faces and soffit, will provide some shear strengthening for such members. In both cases, it is recommended that the FRP is placed such that the principal fiber orientation, , is either 45º or 90º to the longitudinal axis of the member. There is some evidence that the shear resistance of beams can be further improved by bonding additional sheets with their fibers orientated at right angles to the principal fiber direction. In

第1页

你可能喜欢

热门文档

相关文档

站点地图 | 文档上传 | 侵权投诉 | 手机版
本站所有资源均来自互联网,本站只负责收集和整理,均不承担任何法律责任,如有侵权等其它行为请联系我们.
文档下载 Copyright 2013 doc.guandang.net All Rights Reserved.  -  email