图1 :偏馈抛物面几何关系 In the case of an arbitrarily chosen segment of paraboloid, the problem is in
determining F/D ratio. Without going in some specificities and possible exhibitions of different manufacturers of offset dishes, generally it can be said that the focal distance F is approximately equal to the distance between focus (in SAT TV antenna: from the opening of the converter waveguide) and parabola’s geometric centre. For diameter D the smaller axis of the ellipse, i.e. the antenna’s wideness, is taken. In offset parabolic antennas F/D is usually two times greater than in classic ones.
如何选择抛物面的截面,取决于F/D的比率。一般来说,焦距F约等于焦点(在卫星电视天线是波导变换器开口处)和抛物线的几何中心之间的距离。至于D,如果口径面是椭圆形就取其短轴,也就是天线的宽度。通常偏馈抛物面天线的F / D是标准抛物面天线的2倍。
The optimal feed
最佳馈源
The optimal feed for some given parabola has to fulfill several important characteristics:
抛物面天线的最佳馈源必须具备以下重要特征:
1. The radiation angle of the main beam, between the points in which the radiated power is -10dB in relation to the maximal value, has to match the subtended angle. In fact, that is the angle with the angular point in focus and with the arms of the angles that touch the edges of parabolic reflector. The feed radiation angle both in horizontal and in vertical plane has to be the same, regardless the elipticity (貌似elipticity这个词拼错了,应该是ellipticity吧——译者注)of offset parabola.
1、主束的方向角,在增益为-10dB(相对于最大值)的两点之间的角度,必须与张角相配。实际上,张角的角顶在焦点上,角的边线连接抛物面边沿。馈源的方向角在水平和垂直都应当相同。而不管偏馈抛物面的椭圆率如何。
2. The phase center of the feed has to be well defined and stable with changes of
frequencies within the working range. The change of the phase within the whole angle of illumination has to be as small as possible.
2、在其工作范围内更换工作频率时,馈源的相位中心必须精准、稳定。整个辐射角度的相位变化必须尽可能地小。
3. The feed characteristics must not change much in the presence of the parabolic reflector and carrier structure.
3、在抛物面反射器和托架前面,馈源的特性参数不能有太大的变化。
4. Feed radiation diagram has to be very clean, i.e. with low side lobes and rear lobes.
4、馈源方向图必须非常干净,即,旁瓣和后瓣应非常低。
5. Feed structure has to encroach as little as possible in focal cones, i.e. in the space between focus and the antenna surface. Therefore, it is good when the feed phase center is on the front edge or directly in front of the feed antenna structure toward reflector.
5、馈源结构必须尽可能地少地伸进焦点椎体中,即,焦点和天线表面之间的空间。为此,馈源相位中心最好在前沿,或直接在馈源天线指向反射器方向的前面。
本文介绍用改进型3D角反射天线, 为6厘米业余无线电通信频段STA卫星电视 或WLAN频段5.8GHz频道的偏馈抛物面天线作馈源。 Introduction 引言 The problems that occur...
本文介绍用改进型3D角反射天线, 为6厘米业余无线电通信频段STA卫星电视 或WLAN频段5.8GHz频道的偏馈抛物面天线作馈源。 Introduction 引言 The problems that occur...
热门文档