关于旋转复合材料板的振动分析
Vibration Analysis of Rotating Composite Cantilever Plates
325
six dimensionless natural frequencies for rotating plate with fiber orientations[0, 45, -45, 90h. The solid lines represent the results of considering the extensional-bending coupling effects and the dotted lines represent the results of ignoring the coupling effects. When laminates are symmetrically stacked up with respect to neutral axis as shown in Fig. 5 (a), the results obtained by considering coupling effects are almost identical to those obtained by ignoring coupling effects. On the other hand, Fig. 6 (b) shows the variations of the lowest six dimensionless natural frequencies for a rotating plate with unsymmetrical fiber orientations[10, 20, 30, 40, 50, 60, 70, 80]. It shows that the results obtained by considering the coupling effects are significantly different from those obtained by ignoring the coupling effects. Therefore, if laminates are unsymmetrically stacked up with respect to neutral axis, the coupling effects influence the modal char3D
acteristics considerably. In this case, B ii which is the coupling stiffness matrix from Eq. (4) is not zero. T
he variations of dimensionless natural frequencies of a square plate for the fiber orientations[0, 8, -8, 90h are shown in Fig. 7. The effect of the fiber angle 8 is shown in Fig. 7. Figure 7 (a) shows the dimensionless natural frequency variations without rotation and Fig. 7 (b) shows the dimensionless natural frequency variations with dimensionless angular speed (J)= 10. These figures indicate that the natural frequencies of bending modes decrease as the fiber angle increases. Those of the chordwise bending modes, however, increase as the fiber angle increases.
4. Conclusions In this paper, a modeling method for the modal analysis of rotating composite plates is presented. Using the modeling method, the effects of angular speed and the fiber angle orientation on the modal characteristics are obtained. As dimensionless angular speed and laminated angle are varied, natural frequencies loci veering, loci crossing, and associated mode shape variations are observed. Especially, when laminates are unsymmetrically stacked up with respect to neutral axis, it is found that the accurate results can be obtained by using equation of motions which consider the coupling effects between extensional motions and the bending motion. Finally, it is concluded that various mode shape variations can be observed by changing a laminate angles of layers. The presenting modeling method can be usefully employed for the design of rotating composite plate structures.
I: j 15
Bl-T
j: 0 0 35
IT 16 10 3l 3D «l
50
Ell
JO
III
!lIl
PnJe(deg)
(a) w=O
l~ i
Bl-T
2B
ll: 2S 3l
I:: 5
j o
2CB
-lCB IT 16
Acknowledgment 3l 3D «l
o
50
Ell
JO
Ell
!lIl
Mje(deg)
(b) w= 10 Fig.7 Variation of the lowest six natural frequencies due to fiber angle change
This research was supported by Center of Innovative Design Optimization Technology (iDOT), Korea Science and Engineering Foundation.

Optical vibration and deviation measurement of rotating machine parts_专业资料。维普资讯 http://www.cqvip.com oPTOELECTRoNI LETTERSCS Vo-No..1jn.2l41a008 ...
a comparison of several higher-order theories for laminated composite plates....Vibration analysis of rotating pre-twisted blades with a concentrated mass. ...
Journal o]:Sound and Vibration (1982) 83(1), 1-10 LARGE AMPLITUDE ...on the dynamic analysis of layered composite plates with rectangular cutouts....
Modeling and Free Vibration Behavior of Rotating Composite Thin-walled Closed-section Beams wit_专业资料。CHINESJE0URNAL0FMECHANI CAL ENGIEERINNG Vo.512,No...
[3] investigated the vibration control of functionally graded plates (FGPs) ...[9] provided buckling analysis of functionally graded hybrid composite plates,...
Free Vibration Analysis of Functionally Graded Plates with Multiple Circular and Non-circular Cu_专业资料。CHINESJE 0URNALOFMECHANI CAL ENGINEERING V12,.,02o...
Analysis and suppression of fan blade vibration_...of rotating fan blade and studied on the ...vibrations of rotating thin-walled composite beams[...
Vibration characteristics analysis of a 20high Sendzimir mill with localized ...Constant rotating speed was applied along the center axis of the two ...
Green quasifunction method for vibration of simply-supported thin polygonic plates on Pasternak_专业资料。维普资讯 http://www.cqvip.com Api teai n cai(...
Free vibration of functionally graded sandwich plates using four-variable refined plate theory_专业资料。Ap.t.c.EgE.3()9592(01p1MahMeh一n 1d27,2—...
热门文档