The need for mapping small objects in such areas as archaeology, museum collections, medicine, and industry may be met by using close-range photogrammetric techniques. Requirements of these disciplines demand, in some instances, extremely high accuracy in
A NOVEL SYSTEM FOR THE 3D RECONSTRUCTION OF SMALL
ARCHAEOLOGICAL OBJECTS
V. TSIOUKASa, P.PATIASb, P.F. JACOBSc
ab
Demokritos University of Thrace, Dept. of Architectural Engineering, vtsiouka@arch.duth,gr Aristotle University of Thessaloniki, Faculty of Surveying Engineering, patias@topo.auth.gr
c
Mississippi State University, Cobb Institute of Archaeology, pfj1@ra.msstate.edu
Commission V, WG V/4
KEY WORDS: Reconstruction, Archaeology, Visualization, Virtual reality, Model
ABSTRACT:
The need for mapping small objects in such areas as archaeology, museum collections, medicine, and industry may be met by using close-range photogrammetric techniques. Requirements of these disciplines demand, in some instances, extremely high accuracy in an automated process for recording the geometry of objects, while in instances which involve numerous objects to be mapped an error-free but rapid procedure is necessary. Laser scanning techniques are likely the best and most reliable for these purposes. However, the costs associated with these techniques prohibit their use in many of the applications mentioned above.
The authors have constructed a device to take advantage of the properties of a laser beam; by using the optical properties of a vertical laser line beamed from an off-the-shelf laser level, standard photogrammetric methods determine locations of these points on objects. Costs are kept low because measurement is done without the use of a laser beam detector to measure distance (hence, position) of points on objects.
The cost of this system—a typical desktop PC, an electronic circuit attached to the parallel port, a digital camera, a laser level, and a rotator mechanism—is relatively low.
access is legally prohibited or because of distance 1. INTRODUCTION
needed to travel to the location of the artefacts;
In the matter of documentation of small artefact finds, the d) Creation of virtual museums; these virtual museums archaeological scientific community faces important issues that would provide not only digital images (2D arise from several factors: presentations) of objects, but also accurate 3D models
1) The objects, because often they are too fragile for and visualizations using VRML object files.
repeated handling or because access to investigators has been prohibited, require special treatment in measuring, archiving, and preservation; 2. CURRENT TREND 2) Because many small artefacts are only partially
To date the techniques applied to the restitution of small preserved, modelling and mapping are difficult to
archaeological objects are based on the exhausting calculation accomplish in a scale of 1:1;
of 3D point clouds, which represent the outer surfaces of the 3) Because the numbers of small artefacts from a single
objects. The most popular are (Boehler, W. and Marbs, A., excavation may be quite numerous, it is clear that an
2002): automatic mapping procedure is needed to cut human
1) Laser scanning. The measuring of the 3D points involvement to a minimum.
coordinates is implemented through a laser beam that
is transmitted towards the object and reflected back to Such mapping systems exist, of course, though they are often
the source. The time that is needed for the beam to expensive and difficult to perform; however, the matters of
travel from the laser beam source to the object and expense and difficulty of manipulation ought not to prevent the
back, multiplied by the speed of laser light, yields the application of one of these several modern techniques to fulfil
distance of the points from the source; hence their the needs of documentation of the artefacts. The output
location on an arbitrarily defined 3D coordinates produced by modern digitization applications will be useful in
system. one or more of the following scenarios:
2) Optical scanning. Special structured light devices and a) Internal use; i.e., the creation of a complete database
laser diodes producing straight (horizontal or vertical) archive for use within an archaeological institution or
line tracks are used for the exact definition of 3D within an excavation staff for its own research;
points on the object. Sophisticated photogrammetric b) Replica creation (Skarlatos, D., et. al. 2003)
procedures may lead to the calculation of a dense c) External use; detailed study of objects by members of
point cloud that describes the outer surfaces of the the academic community, who otherwise would not
objects. have direct access to the artefacts, either because
Reconstruction of Fragmented Objects_专业资料。...curvature graphs for the two outlines in gure (... Using visualization in the archaeological ...
The paper introduces a data collection system ...for fully automatic 3D reconstruction of urban ...archaeological sites, including both geometry and ...
A work-flow and data model for reconstruction,... and visualization of archaeological sites Stefan ...the scene by objects that have been found ...
3D video recorder a system for recording and ...capturing temporal changes of scenes and objects. ...time of the 3D reconstruction (see Figure 7). ...
scene geometry reconstruction and novel view ...[5] built a 6-camera system for on-the-?y ... those with a small number of cameras can ...
objects can be seamlessly inserted into the ...The result is a dense reconstruction of the ... develop a novel procedure for matching images to...
The facts that these mostly depict objects which ...photogrammetry in architectural or archaeological ...In the framework of the 3D reconstruction of a ...
Classification of Archaeological Fragments Using a ...The classi cation and reconstruction of ancient ...the 3d- acquisition system, the archive-database ...
A Novel Method for Modeling Complex 3d ...INTRODUCTION 3D geographic information system (GIS)...be optimized by reconstruction of GTP components. ...
热门文档