10 ENGINEERING NOISE CONTROL
10
ENGINEERING NOISE CONTROL
Professor Colin H. Hansen
Department of Mechanical Engineering
University of Adelaide
South Australia 5005
AUSTRALIADr Berenice I.F. Goelzer*World Health Organization
10.1. INTRODUCTION
As with any occupational hazard, control technology should aim at reducing noise to acceptablelevels by action on the work environment. Such action involves the implementation of anymeasure that will reduce noise being generated, and/or will reduce the noise transmissionthrough the air or through the structure of the workplace. Such measures include modificationsof the machinery, the workplace operations, and the layout of the workroom. In fact, the bestapproach for noise hazard control in the work environment, is to eliminate or reduce the hazardat its source of generation, either by direct action on the source or by its confinement.
Practical considerations must not be overlooked; it is often unfeasible to implement a globalcontrol program all at once. The most urgent problems have to be solved first; priorities haveto be set up. In certain cases, the solution may be found in a combination of measures which bythemselves would not be enough; for example, to achieve part of the required reduction throughenvironmental measures and to complement them with personal measures (e.g. wearing hearingprotection for only 2-3 hours), bearing in mind that it is extremely difficult to make sure thathearing protection is properly fitted and properly worn.
This chapter presents the principles of engineering control of noise, specific controlmeasures and some examples. Reading of chapter 1 is indispensable for the understanding ofthis chapter. Note that many of the specific noise control measures described are intended as arough guide only. Further information on the subject can be found in ISO 11690 and in thespecialised literature. Also suppliers of equipment and noise control hardware can often providehelpful noise control advice.
10.2. NOISE CONTROL STRATEGIES (See ISO 11690)
Prior to the selection and design of control measures, noise sources must be identified and thenoise produced must be carefully evaluated. Procedures for taking noise measurements in thecourse of a noise survey are discussed in chapter 7.
___________________________________________________________________________
*Present address: 26, ch. Colladon
CH-1209 Geneva, Switzerland
of Mechanical Engineering University of Kentucky 20 Noise and Vibration Short Course 10 Tips for Controlling Noise Applied Noise Control ? Use plastic ...
It is best used in engineering control and hearing conservation applications. Engineering Controls: A physical means of reducing noise exposure which does not...
TOP 10 NOISE CONTROL TECHNIQUES_机械/仪表_工程科技_专业资料。十个很好的...This sheet was produced by the Engineering Industry Noise Task Group (see ...
22页 2财富值 10 ENGINEERING NOISE CON... 52页 免费 Chapter 3 - Noise and vi... 40页 5财富值 12_Applied Noise Control 暂无评价 28页 2财富值...
Vibration and Noise Co... 4页 免费 10 ENGINEERING NOISE C... 52页 免费 Chapter 3 - Noise and ... 40页 2下载券 Automotive Noise and V... 14...
Mobile Phone Control 12页 2下载券 10 ENGINEERING NOISE C... 52页 免费cellular phone-...
Engineering Standard SAES-A-105 Noise Control Environmental Standards Committee Members Hejazi, Ramzi Fouad, Chairman Abdulkader, Khaled Abdullah, Vice Chairman...
2-12 Noise control and hearing conservation directive 2-12 Noise control ...(2) Engineering controls 10. As far as is reasonably practicable, every ...
KINETICS Noise Control design and application guidelines_机械/仪表_工程科技_...(Chapter D1) KINETICS SEISMIC ENGINEERING Toll Free (USA only): ...
6.Noise Control Engineering Journal 7.Sound and Vibration 8.Journal of Low Frequancy Noize,Vibration and Active Control 9.Journal of Computational Acoustics ...
热门文档