European standard specifies requirements for the design of unfired pressure vessels
EN 13445-3:2002 (E) Issue 30 (2008-03)
Annex C (normative) Design by Analysis - method based on stress categories............................................550 Annex D (informative) Verification of the shape of vessels subject to external pressure..............................569 Annex E (normative) Procedure for calculating the departure from the true circle of cylinders and
cones........................................................................................................................................................576 Annex F (normative) Allowable external pressure for vessels outside circularity tolerance ........................579 Annex G (normative) Alternative design rules for flanges and gasketed flange connections.......................581 Annex GA (informative) Alternative design rules for flanges and gasketed flange connections................630a Annex H (informative) Table H-1 Gasket factors m and y..................................................................................631 Annex I (informative) Additional information on heat exchanger tubesheet design.......................................634 Annex J (normative) Alternative methods for the design of heat exchanger tubesheets..............................638 Annex K (informative) Additional information on expansion bellows design.................................................674 Annex L (informative) Basis for design rules related to additional non-pressure loads................................681 Annex M (informative) In service monitoring of vessels operating in fatigue or creep..................................683 Annex N (informative) Bibliography to Clause 18...............................................................................................685 Annex O (informative) Physical properties of steels..........................................................................................686 Annex P (normative) Classification of weld details to be assessed using principal stresses.......................693 Annex Q (normative) Simplified procedure for fatigue assessment of unwelded zones...............................706 Annex R (informative) Coefficients for creep-rupture model equations for extrapolation of creep-rupture strength.......................................................................................................................................706a Annex S (informative) Extrapolation of the nominal design stress based on time-independent
behaviour in the creep range.................................................................................................................706e Annex ZA (informative) Clauses of this European Standard addressing essential requirements or
other provisions of the EU Directives...................................................................................................707
4a
( 11 浙江大学 , 浙江 杭州 310027 ; 21 浙江省特种设备检验中心 , 浙江 杭州 310020) 摘 :2002 年 5 月颁布的 EN13445 欧盟 要 《非直接接触火焰压力...
在2002年3月为欧 盟成员国正式表决通过了修改后的标准EN13445, 并于同年5月30日颁布了该标准第一版。 EN13445-3有两个附录介绍分析设计 即附录B和C。 本文...
目前,一些防止容器设计塑性不稳定的国际准则已被提出,如 ASME(2007) 标准和 EN 13445-3(2002)标准。其中,ASME 规范提出三个标准,以防止容器的塑 性失稳:弹性...
在2002年3月为欧 盟成员国正式表决通过了修改后的标准EN13445, 并于同年5月30日颁布了该标准第一版。 EN13445-3有两个附录介绍分析设计 即附录B和C。 本文...
热门文档