文档下载 文档下载导航
设为首页 | 加入收藏
搜索 请输入内容:  
 导航当前位置: 文档下载 > 所有分类 > 工程科技 > 信息与通信 > Interference Coordination and Cancellation for 4G Networks
侵权投诉

Interference Coordination and Cancellation for 4G Networks

移动通信

LTE PART II: 3GPP RELEASE 8

Interference Coordination and Cancellation for 4G Networks Gary Boudreau, John Panicker, Ning Guo, Rui Chang, Neng Wang, and Sophie Vrzic, Nortel

ABSTRACT This article provides an overview of contemporary and forward looking inter-cell interference coordination techniques for 4G OFDM systems with a specific emphasis on implementations for LTE. Viable approaches include the use of power control, opportunistic spectrum access, intra and inter-base station interference cancellation, adaptive fractional frequency reuse, spatial antenna techniques such as MIMO and SDMA, and adaptive beamforming, as well as recent innovations in decoding algorithms. The applicability, complexity, and performance gains possible with each of these techniques based on simulations and empirical measurements will be highlighted for specific cellular topologies relevant to LTE macro, pico, and femto deployments for both standalone and overlay networks.

INTRODUCTION The growing demands on mobile networks to support data applications at higher throughputs and spectral efficiencies has driven the need to develop Orthogonal Frequency Division Multiplexing (OFDM) based 4th generation (4G) networks, including WiMAX and 3GPP Long Term Evolution (LTE). A key objective with respect to deployment of OFDM 4G networks is to utilize a frequency re-use of one (denoted by N= 1) or as close to N= 1 re-use as is practical. A frequency re-use of N= 1 implies that the base stations in cells transmit on all available time-frequency resource blocks (RBs) simultaneously. Due to transmit power limitations in mobile terminals, the constraint on the uplink link budget will necessitate the need for smaller cell sizes than is typically deployed for present 2nd generation (2G) and 3rd generation (3G) cellular systems. This requirement is driven by the need to meet targeted higher data rate throughputs for users not only near the base station, but also for cell edge users. The resulting interference limited system for N= 1 deployment will not achieve the full potential capacity that the LTE standard can support without the implementation at the base station and mobile terminal of one or more viable interference mitigation and/or cancellation techniques. Interference cancellation and mitigation techniques have been investigated and deployed

with varying degrees of success in terrestrial mobile networks for more than 20 years. Traditional approaches to interference mitigation between transmitted signals have focused on either ensuring orthogonality between transmitted signals in time, frequency as well as spatially, or by actively removing and canceling interfering signals from the desired signal if orthogonality between the desired signal and potential interferers cannot be achieved. In early 2G cellular systems such orthogonality was achieved primarily through static pre-planned allocations of radio resources. 3G systems introduced interference cancellation techniques

based mostly on a combination of blind information gathering at a base station such as spectrum usage monitoring and coarse exchange of interference indicators such as the Rise over Thermal (RoT) indicator employed in the 3GPP2 1xEV-DO standard. Typically interfering signals have been estimated using blind detection and their estimates subtracted from the desired signals. Good overviews of historical approaches can be found in[1] and the references contained therein. From a link perspective the downlink (DL) allows for a more tractable analysis since if the desired mobile terminal location is known, the distances to all potential interfering base stations can be easily determined based on the network geometry, and hence a probabilistic based estimate of the signal-to-interference-plus-noise ratio (SINR) can be calculated based on the channel fading conditions for the desired signal and the interfering signals. In addition to AWGN, both the desired signal and interfering signals will experience shadowing, which typically is log-normally distributed. Analysis of the uplink (UL) interference requires knowledge of not only the location of the desired mobile terminal under consideration, but also the relative locations of all potential interfering mobile terminals, for which both the locations of the interfering terminals, the number of potential terminals, and their spatial velocity will be random variables. LTE offers the capability to provide a flexible dynamic inter-base station approach to interference coordination through the use of inter-base station signaling capabilities, including the use of UL reactive overload indicators (OIs) and proactive high interference indicators (HIIs) that provide bit maps of interference conditions on a per

74

0163-6804/09/$25.00© 2009 IEEE

IEEE Communications Magazine April 2009

Interference Coordination and Cancellation for 4G Networks

第1页

你可能喜欢

热门文档

相关文档

站点地图 | 文档上传 | 侵权投诉 | 手机版
本站所有资源均来自互联网,本站只负责收集和整理,均不承担任何法律责任,如有侵权等其它行为请联系我们.
文档下载 Copyright 2013 doc.guandang.net All Rights Reserved.  -  email