Novel carbon nanotube reinforced aluminum composite assisted by polymer-
binder
J. Z. Liao*, M. J. Tan, I. Sridhar, L. G. Yu
School of Mechanical and Aerospace Engineering, Nanyang Technological University, 50 Nanyang Avenue, Singapore 639798, Singapore
*Corresponding author. Tel.: +65 67906123; fax: +65 67924062
E-mail address: liao0025@e.ntu.edu.sg (J. Z. Liao)
Keywords: Aluminum (Al), Carbon nanotubes (CNTs), Mixing
Abstract
A novel polyether binder-assisting (PBA) method was used to disperse CNTs into aluminum (Al) matrix, and a 0.5 wt.% CNTs reinforced Al composite was processed by powder metallurgy (PM) technique. The CNTs were almost not damaged during PBA-mixing. The tensile strength of the composite reached 195 MPa, with minor decreased ductility by comparison with the pure Al.
Introduction
In recent years, carbon nanotube (CNT) reinforced metal matrix composites (MMCs) have attracted increasing attention [1-7]. The strong in-plane chemical SP2 bonding between carbon atoms make CNTs extraordinarily stiff and strong against axial strain whilst very flexible against non-axial strains [8]. However, CNTs dispersion problem, is a major obstacle which inhibits the imparting of the nanotubes exceptional properties into the matrices. CNTs have a tendency to agglomerate due to the strong van der Waals forces of attraction between them. At present, the dispersion methods adopted in metal powders and CNTs are mainly mechanical mixing methods, such as roll-milling [1], planetary ball-milling [5], attrition-milling [9], friction stir processing (FSP) [6], blending [7], etc. One of the great disadvantages of these mechanical mixings, however, is that entangled CNTs are difficult to disperse without damage by the mechanical separation. As a consequence the mechanical properties of the CNT reinforced composites would be affected due to the inferior quality of CNTs.
The current investigation aims to develop a mixing approach to avoid the problem of CNTs damage. A polyester binder-assisting (PBA) mixing technique is used to mix aluminum(Al) powders and CNTs. This process involves mixing Al-CNTs powders assisted by polyethylene glycol (PEG) in a twin-screw mixer. The mixed Al-CNTs powders were processed by powder metallurgy (PM) technique to obtain a bulk composite. The PBA-mixing effect was examined. Effect of CNTs on the processing and mechanical properties of the aluminum composite was discussed.
9 July MS&T Novel carb... 5页 免费 Microstructures and te... 暂无...carbon nanotube reinforced aluminum nanocomposite fabricated by plasma spray ...
9 July MS&T Novel carbon... 5页 免费 Nanocomposite polymer hy... ... CARBON NANOTUBE/SPACE DURABLE POLYMER NANOCOMPOSITE FILMS FOR ELECTROSTATIC ...
carbon nanotube (CNT) reinforced aluminum nanocomposite coatings were prepared ... Carbon Nanotube Mediat... 5页 免费 9 July MS&T Novel carb... 5页 ...
Synthesis and characterization of manganese oxide-carbon nanotube nanocomposite for supercapacitor application Roger Amade, Eric Jover, Burak Caglar, Toygan ...
carbon nanotube reinforced copper nanocomposites ... aluminum (surface tension of 865 mN/m), ...The yield strength of CNT/Cu nanocomposite with ...
of carbon nanotube reinforced Cu matrix ... nanocomposites are fabricated by a novel ...resistance of fabricated CNT/Cu nanocomposite were ...
of carbon nanotube reinforced Cu matrix ... nanocomposites are fabricated by a novel ...resistance of fabricated CNT/Cu nanocomposite were ...
热门文档