ublox 软件编程手册

Receiver Description
1 Overview
The Receiver Description Including Protocol Specification is an important resource for integrating andconfiguring u-blox positioning chips and modules. This document has a modular structure and it is not
necessary to read it from the beginning to the end. There are 2 main sections: The Receiver Description and theProtocol Specification.
The Receiver Description describes the software aspects of system features and configuration of u-blox
positioning technology. The Receiver Description is structured according to areas of functionality, with linksprovided to the corresponding NMEA and UBX messages, which are described in the Protocol Specification.The Protocol Specification is a reference describing the software messages used by your u-blox GNSS (GlobalNavigation Satellite System: e.g. GPS, GLONASS, QZSS) receiver and is organized by the specific NMEA and UBX

messages.This document provides general information on u-blox GNSS receivers. Some information might not
apply to certain products. Refer to the product Data Sheet and/or Hardware Integration Manual for
possible restrictions or limitations.
2 Navigation Configuration Settings Description
This section relates to the configuration message UBX-CFG-NAV5.
2.1 Platform settings
u-blox positioning technology supports different dynamic platform models (see table below) to adjust thenavigation engine to the expected application environment. These platform settings can be changed
dynamically without performing a power cycle or reset. The settings improve the receiver's interpretation of themeasurements and thus provide a more accurate position output. Setting the receiver to an unsuitable platformmodel for the given application environment is likely to result in a loss of receiver performance and positionaccuracy.
Dynamic Platform ModelsPlatformDescription
Portable
Stationary
Pedestrian
Automotive
At sea
Airborne <1g
Airborne <2g
Airborne <4gApplications with low acceleration, e.g. portable devices. Suitable for most situations.Used in timing applications (antenna must be stationary) or other stationary applications.Velocity restricted to 0 m/s. Zero dynamics assumed.Applications with low acceleration and speed, e.g. how a pedestrian would move. Lowacceleration assumed.Used for applications with equivalent dynamics to those of a passenger car. Low verticalacceleration assumed.Recommended for applications at sea, with zero vertical velocity. Zero vertical velocityassumed. Sea level assumed.Used for applications with a higher dynamic range and vertical acceleration than apassenger car. No 2D position fixes supported.Recommended for typical airborne environment. No 2D position fixes supported.Only recommended for extremely dynamic environments. No 2D position fixes supported.
135 NMEA, UBX Protocol Specification, u-blox 5 GNSS Receiver GPS.G5-X-07036-E Public Release Table of Contents Page ix Receiver Description Overview ...
Receiver Signal (B-) FIRST LVDS Receiver Signal ...V IN _ MAX V IN _ MIN Description LVDS ...9-7. Appropriate Condition for Public Display - ...
4. Product Description 4.1. Block Diagram MT7601 VCC(3.3V) SMPS 3.3V...Receiver RF Front End External antenna 2.412~2.4835GHz LED XTAL 40MHz ...
Source description V=2 P SC PT=SDES=202 SSRC/CSRC 1 SDES items ... ...(s) Receiver Report Receiver Report SSRC SSRC report block(s) 1 report ...
(串口)方式,输出的 GPS 定位数据采用 NMEA-0183 协议(默认) ,控制协议为 UBX 协议(该协议的详细介绍请看 u-blox6_ReceiverDescriptionProtocolSpec_GPS.G6-SW...
(该协议的详细介绍请看 u-blox6_ReceiverDescriptionProtocolSpec_GPS.G6-SW-...(2) 定位状态,A=有效定位,V=无效定位 (3) 纬度 ddmm.mmmmm(度分) (4)...
PUBLIC DISPLAY ITEM Page 1 2 3 4 5 6 6 8 ...Ground LVDS Receiver Signal(-) LVDS Receiver Signal...V IN _ MAX V IN _ MIN Description LVDS ...
PUBLIC DISPLAY ITEM Page 1 2 3 4 5 6 6 8 ...General Description The LC420WXN is a Color Active...Receiver Clock Signal(-) LVDS Receiver Clock ...
‘H’ Description SECOND LVDS Receiver Signal (A...3. (N<M) ※ G to G Spec is average of ...9-7. Appropriate Condition for Public Display - ...
Wangcs YG-309M-A DESCRIPTION : CSR8605 (ROM )Module REV : 1.0 CHECKED...LTD Receiver Performance (Temperature 25°C) Issue Date :2013-05-08 17--...
热门文档