Fibers and Polymers 2009, Vol.10, No.2, 209-216DOI 10.1007/s12221-009-0209-3
Effect of Washing Cycles on Behavior of Core Spun
Cotton/Spandex Interlock Structures
Herath C. N. and Bok Choon Kang*
Department of Textile Engineering, Inha University, Incheon 402-751, Korea(Received January 20, 2007; Revised August 1, 2008; Accepted August 25, 2008)
Abstract: Effect of machine washing on structural behavior of core spun cotton/spandex interlock fabrics made with high,medium and low tightness factors has been investigated. Results are compared with those for similar fabrics knitted from100% cotton. Structural behavior of cotton/spandex and cotton fabric samples was observed under full relaxation and wash-ing treatments up to 10th cycle. Based on these data, dimensional constants (U-values) were predicted under 95% signifi-cance level. Higher course and wale densities, stitch densities, dimensional constant values, linear and area dimensionalshrinkages are reported with cotton/spandex interlocks. After treatment levels, cotton/spandex showed the dimensional con-stants with lesser CV%. With increasing fabric tightness, decreasing of length shrinkages and area shrinkages and increasingof width shrinkages are reported in cotton/spandex interlock structures. Cotton/spandex interlocks showed longitudinally andhighly deformed shapes after treatments. Fabric tightness affects significantly on structural behavior of cotton/ spandex andcotton structures during relaxation.
Keywords: Structural behavior, Interlock, Cotton/spandex, Dimensional change
Introduction
Double jersey structures are widely used for outer wears andstructures like interlocks have been traditionally used forfoundation garment field. However, finishing it to a stable stateis one of the main difficulty with double jersey clothes. Owingto high mechanical forces applying during manufacturing,knitted loops are easily distorted. During relaxation, theseconsequent strains imposed on knitted loops are relieved. Inpractice, only the through finishing processes, it cannot beexpected a complete relaxation. Aftermath, residual structuralchanges are resulted during laundering, which makes thegarment to unfit for use and serious quality and aestheticproblems. For these reasons, many attempts have been made tofind better dimensional stability of double jersey structuresmostly made of wool and worsted yarns [1-7].
Two main forces are affected on relaxation mechanism of aknitted structure. One is the resiliency force of the knitted yarn,which try to straighten the yarn, to change its configuration andbring the structure into more balanced state. The second one isthe yarn friction force, which influences on yarn movement ina stitch [2,5,6]. Interlock structures have more inter yarnfrictions and therefore vigorous treatments are required to getcomplete relation [1-3,5,7]. Thus, core spun cotton/spandexyarns show higher resiliency property than 100% cotton yarns,due to its soft and rubbery isocyanate segments, which has arandom coil structure, in the spandex yarn [8].
This property helps to get better relaxation state in weftknitted structures.
In this experiment, interlock fabrics of core spun cotton-spandex fabrics were subjected to full relaxation and machinewashing regimes up to 10 cycles. Thus, in order to observe
*Corresponding author: bckang@inha.ac.kr
209
any effect with increasing cycle intervals, the cycle intervalwas changed to three between 5th and 8th washing cycles.Otherwise, cycle interval from 1st to 10th washing cycleswere kept as two. Investigated factors are course-, wale- andstitch-density, dimensional constants, linear and areadimensional changes. Results are compared with those forsimilar fabrics knitted from 100% cotton.
Experimental
Material
100% cotton (abbreviation: CO) and core spun cotton/spandex (abbreviation: CO/SP) with 93% cotton and 7%spandex were used to knit interlock structures in a circularknitting machine in high, medium and low tightness factors. Inorder to achieve the better fabric properties and uniformity,tension and feed rate of cotton/spandex yarns were controlledcarefully. Table 1 gives the specifications of cotton and cotton/spandex yarns used for knitting interlock structures. Spandexfilaments with 40dtex were used in producing of core spuncotton/spandex yarns. Table 2 gives the machine details of theknitting process.
Table 3 gives SCSL (structural knit cell stitch length - i.e.yarn required to knit one structural knit cell [SKC])specifications and robbin back effect values for CO and CO/SP interlock structures. It is shown that higher robbin backeffect values were given by CO/SP interlock fabrics than COinterlocks. Reason would be the higher resiliency propertyof CO/SP yarns. Thus, robbin back effect decreases withincreasing fabric tightness in CO/SP interlocks. But, COinterlock fabrics are given an opposite behavior to that. Based on this, produced interlock fabrics were categorizedinto three fabric tightness classifications such as low tightness(L-TF), medium tightness (M-TF) and high tightness (H-TF).
热门文档