Design & Application Notes


Means of Coupling to the Dielectric ResonatorThere are two typical techniques for coupling into the
field radiating from a dielectric resonator.
Cavity Method
The most commonly used technique for coupling into a
dielectric resonator is through the use of coaxial
couplings which are mounted through holes in the
cavity wall. Cavity design must take into account
characteristics of the dielectric resonator; however, in
post production, tuning elements may also effect the
coupling and temperature stability of the design.
Many filter designs require multiple resonators to be
coupled together in one housing, this can be achieved
by continuing the coaxial loop design in cavities
positioned directly next to each other. This allows
propagation of the field between the individual cavities
and can produce a filter band, rather than an individual
resonator response.
Resonators used in cavity filters are commonly mounted
on a low εrceramic support (D6 or D9).
Substrate Method (Micro Stripline coupled)
The resonator is typically mounted onto the surface of
the substrate using a thermally cured epoxy adhesive.
In order for the resonator to be effectively coupled when
using Micro Stripline it should be placed adjacent to the
Stripline without making any direct contact (with the
line).
In order to maintain a stable frequency response of the
resonator (with temperature variation) it is advisable to
‘lift’ the resonator off the substrate by using a low εr
ceramic stand off (D6) or by using a monolith solution
(resonator with integral stand off). Typically for a 10 GHz
DR, the stand off height should be approximately
1.5 mm.
Frequency Tuning
The ceramic dielectric resonator will often be machined
to a thickness in order to achieve a specific resonant
frequency. However when the dielectric resonator is
mounted into a cavity filter it may be necessary to fine
tune the frequency by perturbing the fringe fields
around the resonator. The fine tuning can be achieved
by mechanically moving a ceramic (or metal) disc
closer to the resonator.
There is a limit to the frequency shift (tuning)
achievable by this method before it adversely effects
Q and temperature stability - this limit is often found to
be no more than 5% of resonant frequency.

FreqDistance from resonator
21

Losses of the Parallel-Plate Dielectric Resonator_材料科学_工程科技_专业资料...Coupling antenna Calculated QT of I & R Model Measured QT Fig.2 ...
Index Terms-Dual mode, mode selective, dielectric resonator, coupling structure, compact I. INTRODUCTION Fig. 1 4th order Dielectric Loaded Dual Mode filter...
1(d). Furthermore, in order to maximize energy coupling from the HMSIW interior to the dielectric resonator, the slot is positioned at a distance of ...
Improved Tuning Prediction for the Microstrip Coupled Dielectric Resonator Using Distributed Coupling Xiaoming Xu and Robin Sloan Abstract—In this paper, ...
in the same configuration except for the coupling configuration of the dielectric resonator (DR) in order to empirically demonstrate the phase noise reduction...
I for p = 0 of the first mode of the cylindrical dielectric resonator. ...概述 Figure 6.13 Coupling to microwave resonators. (a) A microstrip ...
Rapid Optimization of Dielectric Resonator_信息与通信_工程科技_专业资料。2011 Loughborough Antennas & Propagation Conference 14-15 November 2011, Loughborough,...
coupling between twocavitiesandportcoupling coupling, whereinelectriccouplingismadeofS-shapemetalarCtocross—couplingdielectricresonatorcavityusedintheis enhancethe ...
I for p = 0 of the first mode of the cylindrical dielectric resonator. ...概述 Figure 6.13 Coupling to microwave resonators. (a) A microstrip ...
The proposed DRO integrates a novel coupling mechanism to excite the TE0og mode of a cylindrical dielectric resonator in the presence of a conducting ...
热门文档