

doc.guandang.net

doc.guandang.net
e previously investigated nonsolvents W
[ 15 ] and showed that impeding for polysul des
chemical equilibria could allow the full reduction of sulfur into Li S in a Li–S cell. 2
It is interesting to observe that the opposite approach of exacerbating these chemical equilibria between polysul de intermediates can also lead to the same result. Whereas nonsolvents compromise the cell energy den-sity due to a signi cant increase in polariza-[ 15 ]tion, EPD solvents exacerbate solvation,
Figure 5. Schematic representation of Li S electro-oxidation: a) in the absence of any 2
and chemical equilibration between redox-solubility—which is the case in glymes—triple-phase boundaries (conductive substrate/Li 2S/
electrolyte) are required; b) in the case of EPD-solvent-assisted phase transfer, all electroactive active sulfur species. This assisted phase-S to soluble polysul des, species are in solution, hence only necessitating a good wetting of the conductive substrate transfer, from Li 2
by the electrolyte.translates into a decreased cell polarization
and an improved rate capability.
For all the reasons detailed above, the use of low volatility below 3.0 V owing to optimum material particle dimensions,
cial in a catholyte-type or redox-the reversibility is only 78% on the rst cycle (Figure 4 b, black EPD solvents would be bene
1 ow type battery, where Li line), so that the practical capacity is limited to 1100 mAh g S .S deposition is controlled by surface 2
In contrast, no overpotential is observed in DMA (Figure 4 b, interactions; but detrimental when trying to limit diffusion by blue line), while a reversibility of 99% and a capacity retention physically entrapping sulfur species in a mesoporous carbon of 98% are achieved on the rst cycle and on the second cycle, matrix. Instead, we believe that the combination of highly respectively. Two main factors contribute to the unique behavior adsorptive electrode material with a highly dissociative solvent of Li could be extremely advantageous. Obviously, chemical interac-S in EPD solvents: rst, the partial solvation of Li 2 2Sin
des onto polar host materials DMA alleviates the problem of electrochemically disconnected tion and adsorption of polysul
[ 17 ] yet we foresee Li S (because it can be accessed anywhere in the electrolyte, see would need to be re-evaluated in EPD solvents, 2
Equation (9) .As illustrated in Figure 5 , phase-transfer also alle-that this kind of concerted chemical approach will enable us to viates the need for triple-phase boundaries to initiate and carry overcome the current 1200 mA h g S 1 capacity threshold in out electrochemical oxidation of Li S. Second, the stabilization Li–S batteries today. 2
· of the radical S 3 provides additional chemical pathways to
assist the electrochemical processes (via Equations (2) ,(5) ,(7) ). The question of reactivity of sulfur intermediates toward
Experimental Section electrolyte solvents is well-founded, given the reported decom-Materials : Solid Li position of carbonates, and the analogy with Li–O 2S6 was synthesized by reacting elemental sulfur 2 cell chem-and lithium superhydride (1 MLiEt 3 BH in anhydrous THF, Sigma-istry. Although many electrolytes were initially thought to be
Aldrich) at room temperature for 1 h inside an Ar- lled glovebox. The · , degradation of DME, [ 8,26 ] stable to the superoxide radical O 2 [ 4] THF and by-products were removed in vacuo as reported previously. [ 27 ] and later EPD-solvents were all demonstrated TEGDME, Ultramarine pigment of composition Na .1Al 3.5Si 8.5O24S3* (SO 4)0.2 4.1Ca 0.1K0
experimentally using NMR or FTIR spectroscopies, and the was purchased from Kama pigments and used as-received. Lithium
[ 8,28 ] The stabilization of S ·–mechanisms were elucidated. perchlorate (LiClO ) and lithium nitrate (LiNO ) were dried at 120 °C 3 in 4 3
under vacuum for 48 h, while DMA and TEGDME solvents were distilled DMA, as evidenced by XANES (Figure 2 ), offers us the oppor-tunity to assess its reactivity not only toward glymes, but also and stored over 4 A molecular sieves prior use. Sulfur Electrode Preparation : A 70 wt% sulfur containing composite to EPD solvents. To probe this, Li 2S6 was synthesized in
was prepared by via a melt diffusion method in Vulcan carbon at 155 °C. [ 11 ]DMSO-d 6, and then contacted in an equimolar ratio with DOL, The composite was dispersed with Super P into a 2-propanol and water
DME, and diethyl carbonate (DEC) for 48 h at 40 °C. As shown mixture (1:2 volume) by ultrasonication. Next, PTFE was added (60 wt% in Figure S2 (Supporting Information), no decomposition prod-dispersion in H O, Sigma-Aldrich) such that the sulfur:carbon:PTFE 2
1 ucts could be detected by H NMR in DME. However, acetate mass ratio was 54:34:12, and mixed well. The lm was cast onto AvCarb
[ 7,29 ]P50 carbon paper (Fuel Cell Store) to reach a nal sulfur loading of 1.5 was formed in DEC (as expected from previous studies), but
2
also in DOL. This contrasts with experiments where polysul des mg cm and dried at 60 °C overnight.
Li S Electrode Preparation:Li2 S was synthesized by reacting 2 were formed in situ in DOL (while also allowed to react for
elemental sulfur and lithium superhydride and drying the mixture at [ 7]2 48 h at 40 °C). Therefore, only by promoting S 6 dissociation 300 °C under vacuum for 3 h. A 60 wt% Li 2S-containingcomposite· in an EPD solvent, are cyclic glymes found to undergo into S 3was prepared by ball-milling with Ketjenblack and titanium nitride
nucleophilic attack by sulfur radicals. Although the small con-nanoparticles. The composite was dispersed with Super P and PTFE
· centration of S 2 b) binder (1 µm powder, Sigma-Aldrich) in anhydrous THF such that the 3 in the DOL:DME-based electrolyte (Figure
S:carbon:TiN:PTFE mass ratio was 50:25:15:10, and mixed well. 2 limits the extent of DOL decomposition, it is likely that this Li
The slurry was drop-cast onto AvCarb P50 carbon paper (Fuel Cell reaction will occur over extended cycling. Meanwhile, stability 2 and dried at room Store) to reach a nal sulfur loading of 1.5 mg cm
of DMSO toward polysulfur radicals was con rmed (Figure S2, temperature overnight. All of the above procedures were carried-out in Supporting Information), implying that EPD solvents could be an Ar- lled glovebox. used in Li–S batteries, providing the lithium metal electrode is XANES Measurements : Spectra from sulfur K-edge X-ray absorption
[ 30 ]near edge spectroscopy (XANES) were acquired at sector 13-ID-E of the protected from reactivity with the solvent, and polysul des.
(5 of 6) 1401801
COMMUNICATION
Adv. Energy Mater. 2015, 1401801© 2015 WILEY-VCH Verlag GmbH & Co. KGaA, Weinheimwileyonlinelibrary.com
Simplifying Radical Expressions_建筑/土木_工程科技_专业资料 暂无评价0人阅读0次下载举报文档 Simplifying Radical Expressions_建筑/土木_工程科技_专业资料。...
Radical Substitutions SH2: abstraction A + B C A B C A A B A B C D B C + C A + D B C + D (addition-elimination) (1) Halogenation ...
Radical parallelism on projective lines and non-linear models of a?ne spaces Andrea Blunck Abstract We introduce and investigate an equivalence relation ...
更多>>文中给出了Radicaltotal环上投射模的分解定理。对一个uniform维数有限的Totalfree环R,该文证明R是一个总体维数≤1的诺特环,且R上的任何投射模必同构于(○...
Free Radicals Definition: Any chemical species with one or more unpaired electrons Examples of radical species O Na any atom with unpaired electrons NO &...
Masimo Radical与血气分析仪在择期脊柱外科手术中血红蛋白测量比较分析_临床医学_医药卫生_专业资料。龙源期刊网 http://www.qikan.com.cn Masimo Radical 与血气...
Masimo Radical与血气分析仪在择期脊柱外科手术中血红蛋白测量比较分析_基础医学_医药卫生_专业资料。中国实用医药 201 3年 7月第 8卷第 2 0期 China Prac Med...
内容来自 什么值得买:http://www.smzdm.com/ Head 海德 Radical Metallix 穆雷签名版 科技碳复合网球拍和 Nike 耐克 男式 透气网球鞋货到回头看看那些价格就有...
Free-radical_化学_自然科学_专业资料。European Polymer Journal 38 (2002) 147±150 www.elsevier.com/locate/europolj Free-radical crosslink...
RADICAL INNOVATION AND DESIGN RESEARCH_专业资料。innovation knowledge, innovation educationINTERNATIONAL DESIGN CONFERENCE - DESIGN 2002 Dubrovnik, May 14 - 17...
热门文档