14. D. J. Armstrong and A. V. Smith, “150-mJ 1550-nm KTA OPO with good beam quality and high
efficiency,” Proc. SPIE 5337, 71-80 (2004).
15. D. J. Armstrong and A. V. Smith, “Using a Newport refractive beam shaper to generate high-quality flat-
top spatial profiles from a flashlamp-pumped commercial Nd:YAG laser,” Proc. SPIE 5525, 88-97 (2004).
16. doc.guandang.net A complete package of numerical models for crystal
nonlinear optics is available in the SNLO software package from A. V. Smith at Sandia National Labs.
Models for the RISTRA OPO are available on request.
17. A. V. Smith, W. J. Alford, T. D. Raymond, and M. S. Bowers, “Comparison of a numerical model with
measured performance of a seeded, nanosecond KTP optical parametric oscillator,” J. Opt. Soc. Am. B 12,
2253–2267 (1995).
18. G. Anstett, M. Nittman, and R. Wallenstein, “Experimental investigation and numerical simulation of the
spatio-temporal dynamics of the light-pulses in nanosecond optical parametric oscillators,” Appl. Phys. B,
79, 305–313 (2004).
19. A. V. Smith and D. J. Armstrong, “Generation of vortex beams by an image-rotating optical parametric
oscillator,” Opt. Express 11, 868–873 (2003).
1. Introduction
OPOs based on the crystal ZnGeP2 (ZGP) are widely used for generating tunable IR radiation in the 2.5-12-μm region [1-5]. ZGP crystal possesses a set of unique properties such as high nonlinearity (d36=75 ± 8 pm/V), high thermal conductivity of 35-36 W/(m K) (higher than YAG) and relatively high hardness 5.5 (Mohs scale) [3].
ZGP requires a pump wavelength longer than 2 μm with typical sources being the 2-μm Ho-lasers and 3-μm Er-lasers. ZGP OPOs are usually operated either at low repetition rates < 60 Hz with mJ-pulse energies [2, 4] or at repetition rates >10 kHz with maximum pulse energies of 100s of μJ [1, 5].
A significant drawback of ZGP crystals (as well as other non-linear crystals used for IR generation) is a low damage threshold of <1-2 J/cm2 for nanosecond pulses. Nanosecond OPOs operating at pulse energy in 10-100-mJ range require large diameter pump beams to safely extract high energy levels without the risk of optical damage to the crystal. Conventional standing-wave or planar-ring OPO cavities operating with high cavity Fresnel numbers (NF = D2/λL, where D is the beam diameter, λ is the OPO signal wavelength and L is the cavity length) produce low-quality beams. Our ZGP OPO uses a non-planar geometry, where the cavity’s image rotation, working in conjunction with crystal birefringence, significantly improves the spatial quality of the beam. However, to achieve high optical efficiency and produce the best beam quality, an OPO cavity design is not sufficient by itself: the pump laser must also be efficient and have a high beam quality as well.
In this particular effort, we applied the Rotated Image Singly-Resonant Twisted RectAngle (RISTRA) concept to construct a mid-IR ZGP OPO to produce a 3.4-μm signal wave with > 10 mJ of energy with a near diffraction-limited beam quality.
ZGP OPO was pumped by a pulsed 2.05-μm master-oscillator power-amplifier (MOPA) Ho:YLF system. We used a Tm-fiber-laser-pumped MOPA approach to scale the output of a 2.05-μm Q-switched Ho:YLF laser oscillator to pulse energies > 55 mJ at the rates from single shot to 500 Hz (38 mJ at 1 kHz).
2. Ho:YLF master-oscillator/ power-amplifier
As a pump source for the Ho:YLF MOPA system we utilized a single-mode >100-W Tm-fiber laser (Model TLR-100-1940, commercially available from IPG Photonics (Oxford, MA)) which was wavelength-adjusted to the strongest Ho:YLF absorption line at 1940 nm. The fiber laser was operated in CW regime and produced diffraction-limited output beam with maximum average power of 120 W. The <3-nm linewidth of the Tm-fiber laser was sufficiently narrow to match the 1940-nm absorption line in Ho:YLF.
Recent progress in the development and commercialization of Tm-fiber lasers providing high CW output power (up to 415 W) [6], diffraction-limited beam quality, and wide operating wavelength range, makes these lasers ideal pump sources for Ho-doped lasers and laser systems. Tm-fiber lasers can be wavelength-tuned to match any Ho-doped laser material #87158 - $15.00 USD


Received 4 Sep 2007; revised 9 Oct 2007; accepted 10 Oct 2007; published 18 Oct 2007
(C) 2007 OSA29 October 2007 / Vol. 15, No. 22 / OPTICS EXPRESS 14405
3.4-μm ZGP RISTRA nanos... 暂无评价 10页 1财富值 Optical-parametric...(PPLN) pumped by an acousto-optically Q-switched cw-diode-end-pumped Nd:...
15页 免费 3.4-μm ZGP RISTRA nanos... 暂无评价 10页 1财富值...optical parametric oscillator (OPO) pumped internally to a diode-pumped, -...
3.4-μm ZGP RISTRA nan... 暂无评价 10页 1下载券 2007.05 Simple ...Optical Parametric Oscillator around 860 nm and the Beam Quality This article...
Laser-Diode-Pumped Doubl... 暂无评价 6页 免费... 3.4-μm ZGP RISTRA nanos... 暂无评价 10页...optical parametric oscillator, which exhibits the ...
Laser-Diode-Pumped Doubl... 暂无评价 6页 免费... 3.4-μm ZGP RISTRA nanos... 暂无评价 10页...optical parametric oscillator, which exhibits the ...
热门文档