diagrams, are a very important tool in the study of alloys. The
interrelationships between the phases, the temperature, and the composition in
an ally system are shown by phase diagrams only under equilibrium
conditions.
Phase rule: the phase rule describes the relationship between degrees of freedom, the
number of components, and number of phases.
Lever rule: a very important relationship, which applies to any two-phase region of a
two-component, or binary , phase diagram, is the so-called lever rule.
Phase diagram: a phase diagram is a graphical representation of the phase present
and the ranges in composition, temperature, and pressure over which the
phases are stable.
5-2 匀晶相图及固溶体结晶
Sec. 5.2 Isomorphous Phase Diagram and Solidification of Isomorphous Alloys
1. Introduction of isomorphous phase diagrams
In isomorphous system only a single type of crystal structure is observed for all ratios of the components.
Liquidus line, solidus line, phase regions
Phase regions: a. the area above the liquidus line is the region of liquid;
b. the area between liquidus and solidus lines is the region of solid
and liquid.
c. the area below the solidus line is the region of solid.
At a given temperature: draw a horizontal line passing through the given temperature,
make the intersecting points by a and b:
We will get information as follow:
a. the alloys whose compositions are lower that point a are in the solid
state;
b. the alloys whose compositions are higher than point b are in the
liquid state;
c. the alloys whose compositions are between points a and b are in the
liquid and solid states, these two phases are in equilibrium, and we
can know the fractions of two phases.
At a given composition: draw a vertical line passing through the given composition,
make the intersecting points by 1 and 2:
We will get information as follow:
a. if the temperature is higher than point 1, it will be in liquid state;
第五章 二元相图与合金的凝固第一节 二元相图概述 第二节 二元相图分析 第三节 复杂二元相图分析 第四节 二元合金的凝固理论 第五节 高分子合金概述 第一节 ...
第五章 二元相图与合金的凝固第一节 二元相图概述 第二节 二元相图分析 第三节 复杂二元相图分析 第四节 二元合金的凝固理论 第五节 高分子合金概述 第三节 ...
第五章 二元相图和合金的凝固 Chapter 5 Binary Phase Diagrams and The Solidification of Alloys 作业 1:An Al-5%Cu ingot is unidirectionally solidified ...
第四章二元合金相图与合金凝固本章主要内容: 相图基本原理:相,相平衡,相律,相图的表示与测定方法,杠杆定律; 二元匀晶相图:相图分析,固溶体平衡凝固过程及组织,...
材料科学基础第五章二元合金相图_电子/电路_工程科技_专业资料。二元合金相图...固溶体合金的非平衡结晶 1. 由于非平衡凝固, 凝固速度远远大于平衡结晶,原子...
第四章 材料的成形凝固与二元合金相图一、解释下列名词 1、凝固 2、过冷度 3、自发形核 4、非自发形核 5、变质处理 6、变质剂 同素异构转变 8、合金 9、...
第四章一、本章主要内容: 本章主要内容: 二元合金相图与合金凝固 相图基本...5 在一般铸造条件下固溶体合金容易产生__枝晶___偏析, 用___均匀化退火__...
第七章 二元相图及其合金的凝固new1_工学_高等教育_教育专区。金属相图材料科学基础绪论 第一章 第二章 第三章 第四章 第五章 第六章 第七章原子结构与键...
材料科学基础第7章 二元相图及其合金的凝固 1 纯金属在人类生活和生产中获得...5 m n m n 7.1.2 测定方法二元相图是根据各种成分材料的临界点绘制的, ...
热门文档