文档下载 文档下载导航
设为首页 | 加入收藏
搜索 请输入内容:  
 导航当前位置: 文档下载 > 所有分类 > 自然科学 > 化学 > 1-s2.0-0260877495000682-main
侵权投诉

1-s2.0-0260877495000682-main

Rheology oj’ aqueous alginate dispersions

285

Experimental Four samples of sodium alginates were used in this work. Three of which, being extracted from Mucrocy.stis pyrifera, were of type M (mannuronate content of ca. 61% w/w) at high (HV), medium (MV) and low (LV) viscosity and were obtained from Sigma Chemical Co. (St Louis, USA). The other sample, being extracted from Laminariu hyperborea, was of type G (guluronate content of ca. 69% w/w) and was obtained from BDH Ltd (Poole, UK). A series of capillary Cannon-Fenske viscometers with size numbers ranging from 50 to 400 was used for the determination of kinetic viscosity (v) (ASTM, 1964) on 0.1 M NaCl dispersions containing O-05-1.25% w/v of any alginate at 29816 K (Kelvin degree). Once having measured the density (/-)) of each corresponding dispersion with calibrated volumetric flasks, it was possible to determine its dynamic viscosity (cc) and then to estimate the intrinsic viscosity[p] of all the alginates under study, as suggested by Launey et al. (1986). The rheological behaviour of the aqueous dispersions of sodium alginates was assessed at different alginate concentrations and temperatures in the ranges 0.125-1.5% w/v and 278.16-308.16 K, respectively, by using a HAAKE rotational viscometer, type RV12, equipped with: a measuring drive unit, type M150, which can transmit a maximum torque of 1.47 N.cm; a coaxial cylinder sensor system, type NV, previously described (Moresi& Spinosi, 1984); and a jack

eted vessel which connects the sensor system to the measuring drive unit, centres the bell-shaped rotor (‘bob’) and the stator (‘cup’) and allows the temperature of the sample examined to be kept constant during the measurement. By varying the test speed (N) from 1.66 x lop4 to 4.26 s-‘, the fow curves (shear stress, z, vs shear rate,;‘) were constructed as follows: T=‘ZO -1 i= I,‘N (1) (2)

where 0 is the viscometer dial reading, while x and fi are the characteristic constants of the instrument, the former depending on the position of the stationary surface and the latter on the ratio of cup to bob radius (S) and the slope of the logarithm plot of torque vs N (Krieger& Maron, 1954). Since S was equal to 1.02,[I reduced to a constant dimensionless value, that was estimated by means of Calderbank and Moo-Young’s (Calderbank& Moo-Young, 1959) simplified expression. Moreover, the values of Z(= 0.534 Pa) and b(= 323.6) were determined once the torque and shear rate scales of the viscometer had been calibrated by using the Newtonian oil PSL D5000 (p,_= 4.384 Pa.s and ill,= 876 kg.m-‘) obtained from Poulten Selfe and Lee (Wickford, UK). RESULTS AND DISCUSSION

Average molecular weight of sodium alginates The intrinsic viscosity[cl] is a characteristic property of a single macromolecule in a given solvent and is a measure of the hydrodynamic volume occupied by the polymer itself. It depends primarily on molecular weight (MW), chain rigidity and solvent quality. For the anionic polyelectrolytes under study, the presence of

1-s2.0-0260877495000682-main

1-s2.0-0260877495000682-main

1-s2.0-0260877495000682-main

1-s2.0-0260877495000682-main

1-s2.0-0260877495000682-main

1-s2.0-0260877495000682-main

1-s2.0-0260877495000682-main

1-s2.0-0260877495000682-main

1-s2.0-0260877495000682-main

1-s2.0-0260877495000682-main

1-s2.0-0260877495000682-main

1-s2.0-0260877495000682-main

1-s2.0-0260877495000682-main

1-s2.0-0260877495000682-main

1-s2.0-0260877495000682-main

1-s2.0-0260877495000682-main

1-s2.0-0260877495000682-main

1-s2.0-0260877495000682-main

1-s2.0-0260877495000682-main

1-s2.0-0260877495000682-main

上一页第3页

TOP相关主题

你可能喜欢

热门文档

站点地图 | 文档上传 | 侵权投诉 | 手机版
本站所有资源均来自互联网,本站只负责收集和整理,均不承担任何法律责任,如有侵权等其它行为请联系我们.
文档下载 Copyright 2013 doc.guandang.net All Rights Reserved.  -  email