文档下载 文档下载导航
设为首页 | 加入收藏
搜索 请输入内容:  
 导航当前位置: 文档下载 > 所有分类 > 教学研究 > VA7028_100_1.2_EN
侵权投诉

VA7028_100_1.2_EN

选填,简要介绍文档的主要内容,方便文档被更多人浏览和下载。

FUNCTION DESCRIPTION

VA7028 is a high precision protection circuit for the one-cell Li-ion or Li-polymer battery. Under normal conditions, during the battery charging, VA7028 may get into the over-charge or excess-current charge protection. It resets to the normal condition when it reaches the release condition. During the battery charging, VA7028 may get into the over-discharge or excess-current discharge protection. It can also reset to the normal state when it reaches the release condition. Figure 3 shows the typical application schematic. The state conversion diagram is shown in Figure 4. The detailed description of each condition is followed.

After VA7028 enter into Over-charge protection, if a charger is still connected to cause the voltage of VM lower than Excess-current Charge threshold (VECI), it will never release to normal condition even the voltage of VDD is lower than over-charge release threshold (VOCR). Only when the charger is disconnected, VA7028 can release to normal condition.

Over-discharge Protection/Low Power Consumption Mode

Protection condition

Under normal conditions, if the voltage of VDD pin is lower than the over-discharge protection threshold (VOD) and this state lasts more than the over-discharge protection delay time (tOD ), the voltage of DOUT pin goes to low(VSS) from a high level. The discharge controller N-MOSFET, Q2, is turned off, shutting off the discharging loop. VA7028 gets into the over-discharge protection. The voltage of VM pin is pulled up to VDD through the internal resistor, RVMD. During over-charge protection, the voltage of VM pin(equal to VDD) is always higher than the battery short protection threshold (VSHORT). Thus, the circuit gets into a low power consumption or “Power saving” mode. In this mode, the current of VDD pin is less than 0.7μA.

Release condition

In the low power consumption mode, the battery should be charged to make the voltage of VM pin lower than the battery short protection threshold (VSHORT), and then VA7028 can recover to the over-voltage discharge protection.(The charging circuit is still available due to the diode in Q2). Under this condition, the output level of DOUT is held low, and Q2 is still turned off. If stopped from charging, VA7028 returns to the low power consumption mode, because the voltage of VM pin is still pulled up to VDD by the RVMD resistor and the voltage is higher than the battery short protection threshold (VSHORT). Only when the battery is charged continually until the voltage of VDD pin rises above the over-discharge protection threshold (VOD), VA7028 can recover to the normal condition from the over-discharge protection.

VA7028 also can release to the normal condition from the over-discharge protection, if the battery’s self-voltage lifting feature makes the voltage of VDD higher than the over-discharge release threshold (VODR).

After VA7028 recovers to the normal condition, the output of DOUT pin goes to a high level. The charge controller N-MOSFET, Q2, is turned on again.

Normal Condition

Under normal conditions, VA7028 is powered by the battery. When VDD is between the protection thresholds of over-charge (VOC) and over-discharge (VOD), VM is between the protection threshold of excess-current charge (VECI) and excess-current discharge (VEDI), the outputs of COUT and DOUT become high and turn on the charge controller N-MOSFET Q1 and the discharge controller N-MOSFET Q2. Thus, the battery can be charged through a charger or

VA7028_100_1.2_EN

discharged through a load.

Note: If it is the first time for the battery to connectwith VA7028, VA7028 might not get into the normal state even though Vis between the protection thresholds of over-charge (V

) and

DD

OC

over-discharge (VOD). Let VM pin short to VSS pin. It can get into the normal state.

Over-charge Protection

Protection condition

During the battery charging and under the normal condition, if the voltage of VDD exceeds the over-charge protection threshold (VOC) and this state lasts more than the over-charge protection delay time (tOC), the voltage of COUT pin is equal to the voltage of VM pin. The N-MOSFET’s charge controller Q1 is turned off. The charge current is “shut off”. VA7028 gets into over-charge protection. Release condition

VA7028 can recover from over-charge protection when it meets one of the following two conditions. 1) The battery discharges itself to make VDD lower than the over-charge release threshold (VOCR); 2) The battery is discharged through an extra load (Note: Even though Q1 is turned off, discharge loop is still available due to its body diode), VDD is lower than the over-charge protection threshold (VOC), and the voltage of VM pin is higher than the excess-current discharge protection threshold (VEDI). (Before Q1 is turned on, the voltage of VM is one diode voltage higher than the voltage of VSS).

After VA7028 recovers to normal condition, the output of COUT pin goes to a high level. The charge controller N-MOSFET, Q1, is turned on again.

Excess-current Discharge/Battery Short Protection

Protection condition

VA7028 supplies two-step excess-current protection. Under normal conditions, during the battery discharging through a load, the voltage of VM pin rises with the discharge current increasing. If the discharge

上一页第5页

TOP相关主题

你可能喜欢

热门文档

相关文档

  • VA7020_100_1.0_CH

    VA7020_100_1.0_CH_电子/电路_工程科技_专业资料。今日推荐 ... VA7028_100_1.2_EN VA7282_DS_1.0_CH VA7916_100_1.2_CH VA7930_...

  • MF52A1 104F3950_P209-15A_无封面

    100V/DC 1min / / / 单位 KΩ 性能要求 100±1% 4.2 4.3 4.4 4....7028.140 5.332 -5.072 6158.700 6481.950 5.248 -4.996 5691.440 ...

  • 小学二年级上数学第二单元100以内加减法复习

    小学二年级上数学第二单元100以内加减法复习_数学_小学教育_教育专区。尖子生...7、先估一估,再笔算 50 42+17 ≈ 60 42+28 ≈ 7028+17 ≈ 42+17 = ...

  • 1到100寸LED屏幕尺寸表

    1到100寸LED屏幕尺寸表_机械/仪表_工程科技_专业资料。本人整理的1到100寸...489880.7028 504838.0337 520020.2869 535427.4623 551059.5601 566916.5801 ...

  • R-T分度表100K3950±1%

    R-T分度表100K3950±1%_电力/水利_工程科技_专业资料。深圳市科蓬达电子有限...0.7028 0.6898 0.6766 0.6632 0.6492 0.6023 0.5923 0.5818 0.5709 ...

  • 干湿球与湿度对照表(干球2~100度)2

    干湿球与湿度对照表(干球2~100度)2_电子/电路_工程科技_专业资料。湿干球...D7028 61 D7029 62 D7030 62 D7031 63 D7032 64 D7033 64 D7034 65 D...

  • 总清单1

    40VA 16 变压器,220V/24V AC, 100VA 三、现场设备 中央冷冻站 开关式...868.74 24023.52 12804.48 9603.36 7028.64 1.2 1.2 1.2 1.2 ¥7,...

  • 小学数学毕业复习资料1-4

    160.8;6.426;31.7028;49;3050;2;4.8;10;112;38;2;1 ; ;3;17.5;...分;5.88 天;6.388 面;7.100 7 3 2 根;8.54500 元;9.336 页;10....

  • 二年级数学《100以内加减法复习与整理》ppt课件2

    二年级数学《100以内加减法复习与整理》ppt课件2_数学_小学教育_教育专区。...7、先估一估,再笔算 50 42+17 ≈ 60 42+28 ≈ 7028+17 ≈ 42+17 = ...

  • matlab语言基础2.1

    1,n2,n) ?在线性空间上,行矢量的值从n1到n2, 数据个数为n,缺省n为100...r=roots(p) p=poly(r) r= p= 11.7473 1 -12 -0 25 116 2.7028 -...

站点地图 | 文档上传 | 侵权投诉 | 手机版
本站所有资源均来自互联网,本站只负责收集和整理,均不承担任何法律责任,如有侵权等其它行为请联系我们.
文档下载 Copyright 2013 doc.guandang.net All Rights Reserved.  -  email