CHINESE JOURNAL OF MECHANICAL ENGINEERING
·64·
Vol. 22,No. 1,2009
DOI: 10.3901/CJME.2009.01.064, available online at doc.guandang.net; doc.guandang.net
Unsteady Turbulent Simulation and Pressure Fluctuation Analysis
for Centrifugal Pumps
YUAN Shouqi*, NI Yongyan, PAN Zhongyong, and YUAN Jianping
Received May 13, 2008; revised November 20, 2008; accepted November 23, 2008; published electronically November 26, 2008
Research Center of Fluid Machinery Engineering and Technology, Jiangsu University, Zhenjiang 212013, China
Abstract: The pressure fluctuation in the flow passage of both impeller and casing is addressed on design condition. The initial conditions for the unsteady turbulent simulation are resulted from the steady calculations, and the three dimensional unsteady turbulent simulation concerning the rotor-stator interaction is executed by a Navier-Stoke solver embedded with k ε turbulence model and with appropriate moving interface boundary conditions. Detecting points are distributed in the flow passage in different radial and circumferential positions to capture the static pressure fluctuation character for one cycle of the impeller. The time-domain spectrums show that the static pressure curves are periodic and have five peaks and five valleys. With the radius increasing, the pressure fluctuation peak-to-peak values in the impeller are increasing, and reach the maximum value on the interface. In the casing flow passage, those values are about 7% of local static pressure except some ones near the tongue. The values become decreasingly in the diffuser pipe. The frequency spectrums transformed by fast Fourier transform (FFT) show that the dominant frequency is approximate with the blade passing frequency, and the pressure fluctuations in impeller passage have high frequency content while those in casing ones have no such information.
Key words: centrifugal pump, rotor-stator interaction, unsteady turbulent flow, pressure fluctuation
1 Introduction
Centrifugal pumps are usually used in many industrial applications: nuclear industry, petroleum, agrobusiness, chemistry, as well as cryogenic propellant pumping. Centrifugal pumps are designed to produce a fairly constant differential pressure at a given flowrate. Idealized head-flow curves give users the illusion that the centrifugal pumps generate only static pressure. However, in reality, this class of pumps generates a dynamic pressure component along with the static pressure component. The dynamic pressure component, which is called pressure fluctuation and rides on top of the static pressure component like an AC signal, is composed of the effects of suction and discharge recirculation, blade inlet rotating stall, rotor-stator interaction, cavitation, excessive wear ring leakage, etc. In the present study, the main objective is to investigate the flow fields, especially the pressure fluctuation induced by the rotor-stator interaction.
Because of the three dimensional axial asymmetry configuration of the volute, the interaction between the impeller and the volute, i.e., the rotor-stator interaction, inspires unsteady flow in pumps. Unsteady flow is one of
* Corresponding author. E-mail: shouqiy@ujs.edu.cn
This project is supported by National Outstanding Young Scientists Funds of China (Grand No.50825902)
the main excited sources of vibration and noise in pump. In recent years, more and more literatures concerned with rotor-stator interaction in turbomachinery are issued, in which some are experimental investigations[1 3], and with the abrupt development of computational fluid dynamics (CFD) and computer technology, unsteady turbulent simulations for the interaction are not uncommon currently[4 9]. But sound comprehension on this kind of flow instabilities is still not achieved.
By solving the viscous incompressible Navier-Stokes equations within a three dimensional unsteady flow model and by applying a sliding mesh technique to take into account the impeller-volute interaction, GONZALEZ, et al[4 5], calculated the flow characteristics and pressure fluctuation induced by the impeller-volute interaction inside a pump and compared with the experimental results near the volute, he believed that the pressure fluctuation is the main factor which deflects the flow patterns. XU, et al[7 8], analyzed the flow characteristics and pressure fluctuation on the interface between the rotor and stator components to test the CFD solver composed of Navier-Stokes equations and RNG turbulent model. GENG, et al[9], investigated the pressure fluctuation of the pump inlet and outlet for different type of impellers with or without short vanes.
In this paper, the commercial CFD solver, Fluent, is employed to simulate the unsteady flow field in both
热门文档