文档下载 文档下载导航
设为首页 | 加入收藏
搜索 请输入内容:  
 导航当前位置: 文档下载 > 所有分类 > 医药卫生 > USP35硫酸软骨素钠盐部分
侵权投诉

USP35硫酸软骨素钠盐部分

1248Choline / Dietary Supplements

dilute with Mobile phase to volume. Pipet 2.0 mL of thesolution to a 25-mL volumetric flask, and dilute withMobile phase to volume.Chromatographic system

(See Chromatography 621 , System Suitability.)Mode: LC

Detector: UV 208 nm

Column: 4.6-mm × 25-cm; packing L7Column temperature: 30°Flow rate: 1.0 mL/minInjection size: 20 µLSystem suitability

Sample: Standard solutionSuitability requirements

Capacity factor (k′): NLT 2

Relative standard deviation: NMT 5%, determinedfrom the choline derivative peakAnalysis

Samples: Standard solution and Sample solution

Calculate the percentage of each impurity in the portionof Choline Chloride taken:

Result = (rU/rS) × (CS/CU) × 100

= peak response for each impurity, excluding

that for the choline derivative and 3,5-dinitrobenzoic acid from the Sample solution

rS= peak response for the choline derivative from

the Standard solution

CS= concentration of USP Choline Chloride RS in

the Standard solution (mg/mL)

CU= concentration of Choline Chloride in the

Sample solution (mg/mL)

Acceptance criteria

Individual impurities: NMT 0.3%Total impurities: NMT 2.0%

SPECIFIC TESTS

PH 791 : 4.0–7.0, in a solution (1 in 10)

WATER DETERMINATION, Method I 921 : NMT 0.5%ADDITIONAL REQUIREMENTS

PACKAGING AND STORAGE: Preserve in well-closedcontainers.

USP REFERENCE STANDARDS 11 USP Choline Chloride RSrU

Sample solution: 0.5 g in 10 mL of water

USP 35

COMPOSITION

CONTENT OF CHONDROITIN SULFATE SODIUM

Standard solutions: 1.5, 1.0, and 0.5 mg/mL of USPChondroitin Sulfate Sodium RS in water

Sample solution: Transfer 100 mg of dried ChondroitinSulfate Sodium into a 100-mL volumetric flask, dissolvein 30 mL of water, and dilute with water to volume.Diluent: Weigh about 297 mg of monobasic potassiumphosphate, 492 mg of dibasic potassium phosphate, and250 mg of polysorbate 80, and transfer into a 1-Lbeaker. Dissolve in 900 mL of water, and adjust withpotassium hydroxide or phosphoric acid to a pH of 7.0 ±0.2. Dilute with water to 1 L, and mix thoroughly.Titrimetric system(See Titrimetry 541 .)

Mode: Photometric titration

Titrant: 1 mg/mL of cetylpyridinium chloride in water.Degas before use.

Endpoint detection: Turbidimetric with a photoelectricprobe

Analysis: Transfer 5.0 mL of each Standard solution andthe Sample solution to separate titration vessels, and add25 mL of Diluent to each. Stir until a steady reading isobtained with a phototrode either at 420, 550, or 660nm. Set the instrument to zero in absorbance mode. Ti-trate with Titrant using the phototrode to determine theendpoint turbidimetrically. From a linear regression equa-tion, calculated using the volumes of Titrant consumedversus concentrations of the Standard solutions, deter-mine the concentration of chondroitin sulfate sodium inthe Sample solution.

Calculate the percentage of chondroitin sulfate sodiumin the portion Chondroitin Sulfate Sodium taken:

Result = (C/CU) × 100

= concentration of chondroitin sulfate sodium in

the aliquot of the Sample solution, obtainedfrom the regression equation (mg/mL)

CU= concentration of Chondroitin Sulfate Sodium

in the Sample solution (mg/mL)

Acceptance criteria: 90.0%–105.0% on the dried basisIMPURITIES

RESIDUE ON IGNITION 281 : 20.0%–30.0% on the driedbasis

CHLORIDE AND SULFATE, Chloride 221 : NMT 0.50%; a0.10-g portion shows no more chloride than correspondsto 0.7 mL of 0.020 N hydrochloric acid. CHLORIDE AND SULFATE, Sulfate 221

Sample solution: Dissolve 200 mg in 40 mL of water.Add 10 mL of a solution of cetylpyridinium chloridehaving a concentration of 30 mg/mL, and pass througha filter. Use a 25-mL portion of the filtrate.

Acceptance criteria: NMT 0.24%; the Sample solutionshows no more sulfate than corresponds to 0.25 mL of0.020 N sulfuric acid. ELECTROPHORETIC PURITY

(See Electrophoresis 726 .)

Barium acetate buffer: Dissolve 25.24 g of bariumacetate in 900 mL of water. Adjust with acetic acid to apH of 5.0, and dilute with water to 1000 mL.

Staining reagent: Dissolve 1g of toluidine blue in 1000mL of 0.1 M acetic acid.

Standard solution A: 30 mg/mL of USP ChondroitinSulfate Sodium RS in water

Standard solution B: Dilute 1 mL of Standard solution Awith water to 50 mL.

Sample solution: 30 mg/mL of Chondroitin SulfateSodium in water

Analysis: Fill the chambers of an electrophoresis

apparatus suitable for separations on cellulose acetateC

Chondroitin, hydrogen sulfate, sodium salt [9082-07-9].DEFINITION

Chondroitin Sulfate Sodium is the sodium salt of the

sulfated linear glycosaminoglycan obtained from bovine,porcine, or avian cartilages of healthy and domestic ani-mals used for food by humans. Chondroitin Sulfate So-dium consists mostly of the sodium salt of the sulfate es-ter of N-acetylchondrosamine (2-acetamido-2-deoxy-β-D-galactopyranose) and D-glucuronic acid copolymer. Thesehexoses are alternately linked β-1,4 and β-1,3 in the poly-mer. Chondrosamine moieties in the prevalent glycosami-noglycan are monosulfated primarily on position 4 andless so on position 6. It contains NLT 90.0% and NMT105.0% of chondroitin sulfate sodium, calculated on thedried basis.

[NOTE—Chondroitin Sulfate Sodium is extremely hygro-scopic once dried. Avoid exposure to the atmosphere,and weigh promptly.]

IDENTIFICATION

A. INFRARED ABSORPTION 197K

B. IDENTIFICATION TESTS—GENERAL, Sodium 191 : Meetsthe requirements

第1页

你可能喜欢

  • 硫酸软骨素的作用
  • 药品注册分类
  • 保健食品生产
  • 初一历史期末测试题
  • 氨基葡萄糖的作用
  • 抗肿瘤中药

热门文档

相关文档

站点地图 | 文档上传 | 侵权投诉 | 手机版
本站所有资源均来自互联网,本站只负责收集和整理,均不承担任何法律责任,如有侵权等其它行为请联系我们.
文档下载 Copyright 2013 doc.guandang.net All Rights Reserved.  -  email