文档下载 文档下载导航
设为首页 | 加入收藏
搜索 请输入内容:  
 导航当前位置: 文档下载 > 所有分类 > 高等教育 > 理学 > IITA2010_332_Investigation of Optical filter in direct-detected OFDM transmission
侵权投诉

IITA2010_332_Investigation of Optical filter in direct-detected OFDM transmission

Investigation of optical filter in direct-detected orthogonal frequency division

multiplexing transmission

Cao Ye Chen Qian Tong Zhengrong Yang Xiufeng

School of Computer and Communication Engineering, Tianjin Key Laboratory of Film Electronic and Communication Devices

Tianjin University of Technology, 300384,

Tianjin, China

E-mail:

Abstract—In this paper, we explore intermediate-frequency architecture direct-detected orthogonal frequency division multiplexing (DD-OFDM). In the simulation experiment of 10Gb/s DD-OFDM transmission over 640km standard single mode fiber (SSMF), the performance of optical signal to noise ratio(OSNR) and bit error rate(BER) have been analyzed by adjusting the bandwidth and order of the optical filters at transmitter and receiver. To achieve a BER of -3dB at receiver-end, OSNR of DD-OFDM can be improved 1dB by using high order optical filters instead of common single-sideband (SSB) filters, and then ultimate performance of the filter has been researched when filter order gets 8 orders. The equivalent relationship between FBG filter and Gaussian band-pass optical filter has been given in DD-OFDM. Meanwhile, the selection of radio frequency can influence the performance of DD-OFDM. Comparing the frequency efficiency with the system sensitivity, the result shows that an optimization performance has been obtained by varying bandwidth gap.

Keywords-Direct Detected; optical filter; OFDM; optical transmission

I. INTRODUCTION

Optical orthogonal frequency division multiplexing (OOFDM) has attracted great attention because the fiber chromatic dispersion (CD) and polarization-mode dispersion (PMD) can be compensated through digital signal processing (DSP) at the receiver. There are two mainly methods for OFDM: Coherent Optical orthogonal frequency division multiplexing (CO-OFDM) and Direct-Detected orthogonal frequency division multiplexing (DD-OFDM)[1-2], alternately. Compared with CO-OFDM, construction of receiver in DD-OFDM is much simpler and easy to be applied in long-haul transmission, which is an alternative candidate for next-generation optical communication and optical access networks.

Because of extra local oscillation (LO), complex frequency-offset and phase noise compensation algorithms, the complexity of CO-OFDM system has been rapidly increased. On the contrary, DD-OFDM receiver-end just needs a photoelectric detector to realize optical receiver[3], it is easy to implement. Recently, in order to enhance frequency- efficiency of DD-OFDM, single-sideband (SSB) OFDM has appeared, its architecture can usually be achieved by dual-drive MZM or optical IQ mixing modulation[4]. In this paper, we explore intermediate-frequency architectures with the assistance of a radio frequency tone to achieve electrical IQ mixing modulation. In the simulation experiment, 10 Gb/s data propagate in 640km of SSMF DD-OFDM transmission system. In addition, single-drive

MZM is used to realize intensity modulation, and SSB-filters are used to filter upper sideband and amplified spontaneous emission (ASE) noise in optical links. Meanwhile, we analysis channel model of DD-OFDM, and simulate tunable optical bandpass filter. The optimization parameters could be given by varying fiber length, when the parameters of bandwidth and orders are adjusted. High order optical filter can reduce transmitter power of ~1.5dBm, and extra OSNR penalty of ~1dB compared with normal SSB-optical filter. High order filter is able to converge to OSNR, when parameter of order gets to 8 orders. When ratio between bandwidth gap and BOFDM gets a value above Wg/BOFDM=1.2, the influence of noise reacting on baseband signal would decrease substantially, and the improvement of the receiver-end performance would be close to saturation.

II. CHANNEL ESTIMATION

First of all, diagram of DD-OFDM transmission system is shown in Fig. 1(a). After P/S and DAC, OFDM symbols access into intermediate-frequency architecture finishing RF modulation, then radio frequency (RF) signals upload to optical links through MZM and an optical bandpass filter, Before photodiode at receiver-end, optical signal must filter ASE noise by optical bandpass filter, Fig. 1(b), (c) is spectra of the optical signal before the optical links and after the optical links. Electrical signals after photodiode are demodulated by RF resource and output baseband signal. We indicate the discrete frequency responses of the transmitter, fiber CD, optical filter and receivers asHT(k),HCD(k),HO(k),HR(k), alternately. The fiber CD linearly distorts the optical phase on each subcarrier and can be simply modeled as

HCD(k) exp(j

DL 2

c(k f)2)

(1)

Where D=17ps/ns is the fiber chromatic dispersion,

L(km) is the fiber length, f is the operating wavelength, is the frequency spacing of the subcarriers, k is the ordinal of the subcarriers, c is the speed of light in vacuum.

The response of optical filter HO(k)optical filters at transmitter consists of the whole effect of and receiver. Response before the photodiode could be modeled by the multiplication of frequency responses of transmitter, fiber CD, and all the optical filters: HC HTHCDHO. Therefore the discrete-time optical waveform Et(n) can be given as

第1页

你可能喜欢

热门文档

相关文档

  • Generation of optical OFDM signals

    Generation of optical OFDM signalsGeneration of optical OFDM signals隐藏>> ...I. Killey, ‘Experimental investigation of SPM in long-haul direct-detection...

  • Generation of optical OFDM signals

    Generation of optical OFDM signalsGeneration of optical OFDM signals隐藏>> ...I. Killey, ‘Experimental investigation of SPM in long-haul direct-detection...

站点地图 | 文档上传 | 侵权投诉 | 手机版
本站所有资源均来自互联网,本站只负责收集和整理,均不承担任何法律责任,如有侵权等其它行为请联系我们.
文档下载 Copyright 2013 doc.guandang.net All Rights Reserved.  -  email