Technical Digest of the International PVSEC-14, Bangkok, Thailand, 2004 P-196
A Method for the Determination of Dynamic Resistance
of Photovoltaic Modules under Illumination
J. Thongpron, K. Kirtikara and C. Jivacate,

King Mongkut’s University of Technology Thonburi, Bangkok, Thailand.
Corresponding Author : J. Thongpron <t_jutturit@yahoo.com>
Solar cell dynamic resistance rd has been determined from a dark IV characteristic curve. In the determination it is often assumed that series resistance Rs is small and the shunt resistance Rsh very large, so that their effects can be neglected. This paper presents a new method to determine rd from an illuminated I-V characteristic curve and take into account finite Rs and Rsh. Measured results from a 4.5 Wp module are illustrated. Comparison is also Fig. 2 Static IV curve of a solar cell or module. made on Rs and Rsh determined from Single- and Two- IV Curve methods. An IV curve of a solar cell/module, under dark or illuminated conditions, can be schematically shown as
Figure 2. In determining dynamic resistance, 1. Introduction
measurement is made between terminals of the In general, series resistance Rs of a solar cell or cell/panel. The dynamic resistance obtained under module can be determined by over 20 methods under such measurement, called RD, is taken to be the slope various illumination conditions. They yield different V/ I of an IV curve. In fact, RD is the result of Rs in results [1]. In the measurement methods of standards series with Rsh, which is parallel to the internal for solar cells, Rs is normally determined by using 2 dynamic resistance rd. RD is sometimes referred to as different illumination levels, a Two-Curve Method, incremental diode resistance [4]. Unless Rs is very whereas Rsh can be obtained from only one small and Rsh very large, rd and RD can be markedly illuminated IV curve, or a Single Curve Method [2]. different. For a cell or module, from the relationship rd, being voltage dependent, has been determined between the photocurrent Iph, the diode current Id and from a dynamic model under dark condition [3]. The the load current IL, and the diode characteristic effects of finite Rs and Rsh have usually been equation, we can write the load voltage VL under one neglected in determining rd. We present here a new illumination level as follows: method to determine rd from one illuminated IV Rsh(Iph+Io IL)1
VL=*ln[ ILRS] ILRscharacteristic, and properly account for finite Rs and λRIshoRsh.
Io is the diode reverse saturation current and 2. Calculation Method λq/nNkT. The diode curve fitting factor n is

assumed to be unity in our case. N is the number of cells connected in series in a module. Io and Iph can be calculated from measurement at open circuit and short circuit conditions. At any 2 operating points (V1,I1) and (V2,I2) on a single IV curve, the relationships between V and I are: Rsh(Iph+Io I1)1
V1=*ln[ I1RS] I1Rs (2) λRIshoFig.1 AC equivalent circuit of a solar cell/module.
Rsh(Iph+Io I2)1
=V*ln[ I2RS] I2Rs (3) Figure 1 represents an AC equivalent circuit of a 2
λRshIo
solar cell or module [4]. In the model, Iph is the
Rs can be written as photocurrent. The voltage independent components
Rsh(Iph+Io I1) I1RsV V1are Rs and Rsh. The transition capacitance CT and Rd (4) *Rs=12
are voltage dependent. The diffusion capacitance CD Rsh(Iph+Io+I2) I2RsI2 I1λ(I2 I1)is frequency and voltage dependent.
ABSTRACT
905
Int'l PVSEC - 14
a method for the determination of dynamic resistance of photovoltaic modules under illumination solarcellsolarcell隐藏>> ARTICLE IN PRESS A method for the ...
A new method based on ch... 14页 免费 OVER... Series resistance; Shunt resistance Kandil, K.M...Photovoltaic Modules under Different Environmental ...
Photovoltaic Modules and Arrays FSEC ? 2002 1 Photovoltaic Modules and ...! A: From Ohm’s Law, the resistance is equal to the voltage divided ...
Method for Determination of the Spectral Mismatch Parameter Between a PV ...Resistance of PV Modules to Hail by Impact with Propelled Ice Balls E ...
ciency, or degradation, of photovoltaic modules ...These parameters, together with shunt resistance ...method,8,9 allowing for the complete ...
(V) is: the simulation of photovoltaic modules ...method presented above, a set of measurements has...The effect of reduced Shunt Resistance and shading...
Rs means the resistance of photovoltaic cells, the internal value is less ...Dynamic maximum power injection control of AC photovoltaic modules using ...
An analysis of the dynamic resistance and the instantaneous energy of the CO2 arc welding proce_专业资料。维普资讯 http://www.cqvip.com Anaayi0 ...
, the series resistance and the load resistance....It discusses the determination of the circuit ...of photovoltaic cells, and then dynamic simulating...
热门文档