PAPERHalides of Phosphorous Oxyacids Prepared with a-Haloenamines1767
95%, due to the possibility of applying a higher reactiontemperature. For diphenylphosphoric acid (12a; Table1)we were unable to find reaction conditions producing sat-isfactory yields. Only 57% product was obtained at 120°C in tetrachloroethane. Higher temperatures were not ap-plicable since the boiling point of the enamine, 130 °C,constitutes a practical limit unless pressurized equipmentis considered, which was not done due to the toxicity ofthe compounds studied. N-(1-Chloro-2-methylprop-1-enyl)-N,N-diisopropylamine was evaluated as an alterna-tive a-haloenamine due to the higher boiling point butproved to be less effective.
1-Fluoro-N,N,2-trimethyl-1-propenylamine (13) was notcommercially available, which is why it had to be synthe-sized. Only one publication11 on the synthesis of fluoro-enamines was found in the literature. Later articles12 referto the method given, which appeared to be improved bythe use of CsF instead of KF as originally reported. Ex-tremely anhydrous conditions were found necessary forthe synthesis that could be significantly facilitated by theuse of a glove box. With the fluoroenamine 13, pyrophos-phonate formation was less pronounced. On the otherhand over-fluorination occurred to some extent in severalcases. Interestingly the formation of phosphonic difluo-ride was not dependent on the amount of reagent used orthe reaction time and is hence a competitive reaction rath-er than a reaction of the desired product. The mechanismof this reaction has not been fully investigated and clari-fied. Even though the two side reactions could be individ-ually minimized by changing the temperature, raising thetemperature increased the amount of difluoride and low-ering the temperature increased the amount of pyrophos-phonate. These problems did of course affect the yields,which were lower than for most of the chloro compounds.However compounds that could not be fluorinated twice(Table1, entry 1) or were intended to be doubly fluorinat-ed (Table1, entry 2) afforded excellent yields that wereslightly better than those of their chloro analogues. Thelargest difference between the chloro and fluoro counter-parts was obtained with dibutyl phosphoric acid (11a;Table1) which produced a 95% yield of the chloro com-pound 11b but only 22% of the fluoro analogue 11c.We also made an attempt to evaluate chloroenamine as asolid phase reagent. This seemed to be an attractive ap-proach mainly due to the easy work-up procedure thatcould be foreseen but also because the solid phase reagentshould be recyclable since easy reactivation of the matrixtethered amide was a likely option. The enamine was builtstepwise on Merrifield resins, starting with isobutyric acidchloride and an amine linker13 (N,N¢-dimethylethylenedi-amine) to form an amide which was chlorinated withphosphorus oxychloride14 or oxalyl chloride15 in goodyields. The reaction of the immobilized chloroenaminewith phosphorus oxyacids, however, did not proceed aswell as in the homogeneous solution reaction since it re-sulted in the formation of pyrophosphonates in almostquantitative yields. The poor stability of the resin bound
reagent was another factor that made us abandon the useof haloenamines as solid phase reagents.
All NMR spectra were recorded on a Bruker Avance 500 spectro-meter. EIMS spectra were run on a Hewlett-Packard 5972 MSD andCIMS spectra were recorded on an Agilent 5973N MSD. From themass spectra the ten most significant peaks are reported and in thecases where the molecular ion is present even though it is not amongthe ten largest peaks, it is also reported. For novel compounds andcompounds without satisfactory references full identification is pre-sented; for the other compounds references are given. All solventsand glassware were carefully dried before use and the reactionswere run under an Ar atmosphere.
Phosphonic Acids 3a–10a; General Procedure
To a solution of methylphosphonic dichloride (1 g, 7.5 mmol) in an-hyd toluene (10 mL) water (0.136 mL, 1 equiv) was added undervigorous stirring. After 2 h neopentyl alcohol (0.67 g, 7.5 mmol)was added and the mixture heated, at first to 100 °C and after awhile, to 110 °C for 2.5 h. The solvent was evaporated yielding thecrude product (1.3 g, quant.). If further purification was desired thecrude product was dissolved in EtOAc (15 mL) and extracted withsat. NaHCOtraction with EtOAc. The yield was substantially lowered but the3 followed by acidification with 2 M HCl and back ex-purity was excellent. Note that isomeric pure L-menthol was used inthe synthesis of compounds 5a and 9a.
Dimethylphosphinic Chloride (1b)
The reaction procedure was the same as that used for the phospho-nochloridates (see below) and the reaction was completed within 1min with a yield of 88%.
1
H NMR (500 MHz, CDCl).
3): d = 2.04 (d, JPH = 13.5 Hz, 6 H, 2 ×CH331P NMR (202 MHz, CDCl3): d = 60.5.
Spectra correspond to published data.16
Methylphosphonic Dichloride (2b)
The methylphosphonic acid (10 mg, 0.10 mmol) was added to a so-lution of 1-chloro-N,N,2-trimethyl-1-propenylamine (100 mL, 0.76mmol) in CHCl3 at 50 °C. Within 5 min the reaction was completeyielding methylphosphonic dichloride (86%).
1
H NMR (500 MHz, CDCl3): d = 2.04 (d, JPH = 13.7 Hz, 3 H, CH3).31
P NMR (202 MHz, CDCl3): d = 43.6.
Spectra correspond to published data.17
Phosphonochloridates 3b–10b; General Procedure
1-Chloro-N,N,2-trimethyl-1-propenylamine (100 mL, 0.76 mmol)was dissolved in anhyd CHCl3 (1 mL) at 50 °C. The phosphonicacid (0.3 mmol) was added under Ar atmosphere and allowed to re-act for 2 min. The products were analyzed by 31P NMR and 1HNMR spectroscopy. The obtained yields were between 80–95%(Table1).
Ethyl Methylphosphonochloridate (3b)
1H NMR (500 MHz, CDCl3): d = 1.41 (t, J = 7.1 Hz, 3 H, CHJ = 7.2 Hz, J3), 1.98(d, PH = 17.5 Hz, 3 H, CH3), 4.24 (dd, JPH = 9.7 Hz, 2H, CH2).
31
P NMR (202 MHz, CDCl3): d = 40.2.
Spectra correspond to published data.18
Neopentyl Methylphosphonochloridate (4b)
1
H NMR (500 MHz, CDCl3): d = 0.98 (s, 9 H, CHJ3), 2.00 (d, JPH =17.5 Hz, 3 H, CH3), 3.77 (dd, J = 7.2 Hz, PH = 9.4 Hz, 2 H, CH2).
Synthesis 2005, No. 11, 1765–1770© ThiemeStuttgart·New York
A开头英语单词_英语学习_外语学习_教育专区。首页
纸张的规格A3.A4.A5.A6纸的尺寸大小_思想汇报/心得体会_党团工作_应用文书。纸张的规格A3.A4.A5.A6纸的尺寸大小国家规定的开本尺寸是采用的国际标准系列,...
各种标准纸张大小A1,A2,A3,A4纸的尺寸_专业资料。有需要查看各种纸张尺寸的朋友,请下载此文档。最标准的各种纸张尺寸,比如A0\A1\A2\A3\A4的各种尺寸都有...
Change management a_企业管理_经管营销_专业资料。Managing Change Module 10 LIS 580: Spring 2006 Instructor- Michael Crandall Roadmap ? ? ? ? ? ? ? ...
不定冠词a an的用法_英语学习_外语学习_教育专区。不定冠词 a\an 的用法冠词分不定冠词(The Indefinite Article)和定冠词(The Definite Article)a, an 是不...
告诉你什么叫A++屏幕 不懂别装_计算机软件及应用_IT/计算机_专业资料。告诉你什么叫 A++屏幕 不懂别装液晶面板按照品质可以分为 A、B、C 三个等级,其等级...
轻松解决excel中找不到Macro1$A$2_电脑基础知识_IT/计算机_专业资料。在打开excel表格的时候,是不是总是弹出“找不到macro1$A$2”的对话框呢,下面的方法...
它就 是定义了知名的 A4 纸张尺寸的标准。 ISO 216 定义了 A、B、C 三组纸张尺寸。C 组纸张尺寸主国际标准化组织的 ISO 216 定义了今日世界上大多数国家所...
详解lol 英雄联盟 走A技术及操作_互联网_IT/计算机_专业资料。lol走a技巧详解lol 英雄联盟 走 A 技术及操作走 a,走砍都是一种较为通俗的说法,它们来自于 ...
滚子链A、B系列的区别以及基本参数尺寸_工程科技_专业资料。滚子链 A、B 系列的区别以及基本参数尺寸 滚子链分为 A、B 两大系列。A 系列是符合美国链条标准的...
热门文档