870
D. Lo Presti/ Construction and Building Materials 49 (2013) 863–881
a standard hot mix asphalt plant through the portable production unit based on the McDonald system. The equipment is typically trailer mounted and is transported into the asphalt plant site. The blending unit receives ground rubber in the hopper, the rubber then moves to the mixing chamber to be blended with virgin liquid bitumen (Fig. 12); the resulting rubberised bitumen is stored in the Portable Reaction Tank (Fig. 13). Once reacted, binder is moved to a second compartment where it is fed to the hot-mix plant to be included in the HMA production. At the end, conventional paving equipment without modi cations is used to place the material. 2.3.4. Terminal blends The terminal blended rubberised binder consists of bitumen with Crumb Rubber Modi er (CRM) binder which is digested into the bitumen at the re nery (Fig. 14) or at a bitumen terminal and then delivered to the plant. These binders are blended with various patented processes and they could present problems of phase separation. 2.3.5. Caltrans terminology The most important distinction among the various rubberised bitumens seems to be related to the ability of obtaining a homogeneous RTR-MBs which do not present the issue of phase separation during storage periods. Based on this distinction, Caltrans[36] divides the wet process into two families linked to two very different types of RTR modi cation currently in use: the‘‘wet process-high viscosity’’ and the‘‘wet process-No-Agitation’’. To promote a clear understanding, a detailed description of these technologies is provided in the next paragraphs. 3. Wet process-high viscosity The original wet process-high viscosity, invented by Charles McDonald, leads to a product with a series of bene ts which are basically all linked to the binder’s increase in elasticity and viscosity at high temperatures that allows greater lm thickness in paving mixes without excessive drain down or bleeding. According to Caltrans[36], the RTR-MB that maintain or exceed the minimum rotational visc
osity threshold of 1500 cPs at 177°C (or 190°C) over the interaction period should be described as‘‘wet process-high viscosity’’. These materials require continue agitation, with special equipment, to keep the RTR particles uniformly distributed. They may be manufactured in large stationary tanks or in mobile blending units that pump into agitated stationary or mobile storage tanks to be used directly at the job site. Phase separation is a big issue of these binders that needs therefore to be produced directly
Fig. 13. Example of mobile reaction tank for Asphalt-Rubber, adapted from[34].
Fig. 14. Terminal blend binder system, adapted from[35].
on the job-site or rarely transported to the eld within tanks equipped with special augers, For this reason, these blends are often well-known as Field blends. Wet process-high viscosity binders typically require at least 15% CRM to achieve the threshold viscosity. However, for some speci cations[36] the viscosity requirements are meet also with less than 15% of RTR content. A number of RTR-MBs and mix speci cations have been developed based on this original idea and each of them is related to a speci c technology. This section will describe each of these technologies listed in Table 5 by providing a step by step framework to operate an appropriate plan production and storage of these materials. At last, this paragraph will provide an overview of the bene ts and limitations related to the wet process-high viscosity.
Table 5 Existing speci cations for rubberised asphalt mixtures. Technologies Asphalt-Rubber binder Bitumen Rubber binder Crumb Rubber binder Speci cations ASTM D6114/D6114 M,[4] Caltrans’ AsphaltRubber user guide,[5] SABITA Manual 19,[6] AsAc Technical Guideline,[7] Austroads,[8] Country USA RSA AUS and NZ
Fig. 12. Example of mobile Mixing unit for Asphalt-Rubber, adapted from[34].

热门文档