ICL7135C, TLC7135C 4 1/2-DIGIT PRECISION ANALOG-TO-DIGITAL CONVERTERS SLAS074B– DECEMBER 1986– REVISED MAY 1999
operating characteristics, VCC+= 5 V, VCC–= 5 V, Vref= 1 V, fclock= 120 kHz, TA= 25°C (unless otherwise noted) PARAMETERαFS EL ED EFS Full-scale temperature coefficient (see Note 4) Linearity error Differential linearity error (see Note 5)± Full-scale symmetry error (rollover error) (see Note 6) Display reading with 0-V input Display reading in ratiometric operation TEST CONDITIONS VID= 2 V, 0°C≤ TA≤ 70°C– 2 V≤ VID≤ 2 V– 2 V≤ VID≤ 2 V VID=± 2 V VID= 0, 0°C≤ TA≤ 70°C– 0.0000 0.9998 0.9995 MIN TYP 0.5 0.01 0.5± 0.0000 0.9999 0.9999 1 0.0000 1.0000 1.0005 MAX 5 UNIT ppm/°C count LSB count Digital Reading Digital g Reading
VID= Vref, TA= 25°C 0°C≤ TA≤ 70°C
NOTES: 4. This parameter is measured with an external reference having a temperature coefficient of less than 0.01 ppm/°C. 5. The magnitude of the difference between the worst case step of adjacent counts and the ideal step. 6. Rollover error is the difference between the absolute values of the conversion for 2 V and– 2 V.
timing diagrams End of Conversion BUSY
B1– B8
D5
D4
D3
D2
D1
D5
STROBE 200 Counts
D5 201 Counts 200 Counts
D4 200 Counts
D3 200 Counts D2 200 Counts D1 200 Counts Delay between BUSY going low and the first STROBE pulse is dependent upon the analog input.
Figure 1
4
POST OFFICE BOX 655303
DALLAS, TEXAS 75265

//ICL7135 STROBE signal sbit OVR = P1^4;//ICL7135 Over Range signal sbit UNR = P1^5;//ICL7135 Under Range signal sbit LED = P1^6;//LEDs ...
模拟条图大致分成三类:①液晶(LCD)条图,呈断续的...本系统所设计的四位半数字电压表由 ICL7135(4 1/...共阳极 LED 发光数 码管、 基准电源、 时钟及量程...
共阳极 LED 发光数码管 、基准电源 、时钟及量程...模拟条图大致分成三类:①液晶(LCD)条图,呈断续的...ICL7135 为全 MOS 工艺四位半双积分式 A/D 转换...
ICL7135 和单片机芯片 AT89S52 设计 四位半数字万...LED 点阵显示器件可以显示数字,英文字 符,中文字符...LCD 显示 结束 20 数字万用表设计 三、项目准备 ...
使用 LCD1601 液晶模块显示,并可以与 PC 机进行...ICL7135 为全 MOS 工艺 4 位半双积分式 A/D ...通过与 LED 显示值相比较, 其最大偏差即为线性...
使用 LCD1601 液晶模块显示,并可以与 PC 机进行...ICL7135 为全 MOS 工艺 4 位半双积分式 A/D ...通过与 LED 显示值相比较, 其最大偏差即为线性...
ICL7106 3位ADC/驱动LCD ICL7107 3位半ADC/驱动LED ICL7109 4位半ADC/驱动LED ICL7129 4位半ADC/LCD驱动 ICL7135 ADC/LCD驱动BCD输出 ICL7136 3位半CMOS...
使用 LCD1601 液晶模块 显示,并可以与 PC 机进行...通过与LED显示值相比较,其最大偏差即为线性误差。 ...[11] http://www.ic-on-line.com/ ICL7135....
用ICL7135CPL制作高精度... 5页 免费 四位半...LCD 显示电路设计 10 3.信号调理总体设计电路图 10...采用 8 位 LED 动态扫描显示的优点是 能改善外部...
四位半数字电压表【摘要】本文介绍一种数字电压测量电路,该电路采用 ICL7135 ...(4)检查超量程溢出功能,调节输入电压值,当超出测量范围时观察 LED 数 码管...
热门文档