8. Cyclone IV器件的配置和远程系统更
新
CYIV-51008-1.4
本章节介绍了Cyclone®IV器件的配置和远程系统更新。CycloneIV(CycloneIVGX和CycloneIVE)器件使用SRAM单元存储配置数据。由于SRAM内存的易失性,每次器件上电后,都必须将配置数据下载到CycloneIV器件中。使用下面其中的一个配置方案配置CycloneIV器件:
■■■■
主动串行(AS)
主动并行(AP)(仅支持CycloneIV E器件)被动串行(PS)
快速被动并行(FPP)(不支持EP4CGX15、EP4CGX22和EP4CGX30 [除F484封装之外]器件)JTAG
■
Cyclone IV器件提供以下配置功能:
■■
配置数据解压缩(“配置数据解压缩”第8-2页)远程系统更新(“远程系统更新”第8-70页)
系统设计师面临着严峻的挑战,如缩短设计周期、不断发展的标准和在偏远地区的系统部署。Cyclone IV器件利用固有的重编程和专用电路来执行远程系统更新,帮助克服了这些挑战。远程系统更新有助于实现功能的增强和错误的修复,无需昂贵的成本,减少产品上市的时间和延长产品的生命周期。
配置
本节介绍了CycloneIV器件的配置,包括以下几方面内容:
■■■■■■■■■
“配置功能”第8-2页“配置要求”第8-3页“配置过程”第8-6页“配置方案”第8-8页
“AS配置(串行配置器件)”第8-10页“AP配置(支持闪存)”第8-21页“PS配置”第8-32页“FPP配置”第8-39页“JTAG配置”第8-45页
© 2011 Altera Corporation. All rights reserved. ALTERA, ARRIA, CYCLONE, HARDCOPY, MAX, MEGACORE, NIOS, QUARTUS and STRATIX words and logos are
trademarks of Altera Corporation and registered in the U.S. Patent and Trademark Office and in other countries. All other words and logos identified as trademarks or service marks are the property of their respective holders as described at doc.guandang.net. Altera warrants performance of its semiconductor products to current specifications in accordance with Altera's standard warranty, but reserves the right to make changes to any products and services at any time without notice. Altera assumes no responsibility or

liability arising out of the application or use of any information, product, or service described herein except as expressly agreed to in writing by Altera. Altera customers are advised to obtain the latest version of device specifications before relying on any published information and before placing orders for products or services.
ISO 9001:2008 Registered
Cyclone IV器件手册,卷1
2011年11月
Subscribe
图 5-8. clkena 信号的实现:输出使能 clkin clkena clk_out 如果系统在 PLL... 8.Cyclone IV器件的配置... 11.Cyclone IV 收发器体...1/2 相关文档推荐...
这一参考设计的目的是帮助您了解 Cyclone III 远程系统更新功能。利用远程系统更新功能,Cyclone III 器件能够接收来自远端源的新配置数据,更新闪存内容,以新配置数据...
16 和 20 bit PMA-PCS—8 或 10 bit f 当对 PCIe 协议的实现配置收发器...下游系统必须能够承受这些差异错误。 Cyclone IV 器件手册, 卷 2 Altera 公司 ...
Cyclone IV 器件旨在用于大 批量,成本敏感的应用,使系统设计师在降低成本的同时...(CPRI) 的 TX 位滑块 电路空闲 动态通道重配置以实现数据速率及协议的即时修改...
Cyclone IV 器件本身,或者作为 DSP 器件的 协处理器,都可用于提高 DSP 系统的...嵌入式乘法器可 以配置成一个 18 × 18 乘法器,或者配置成两个 9 × 9 ...
Cyclone IV 器件 M9K 模块混合位宽配置 ( 简单双端口模式 ) (2/2) 写端口 读端口 8192 × 1 4096 × 2 v v ——— 2048 × 4 v v ——— 1024 ...
要求能 够做到以下两点:■■ 确认存储在 FPGA 器件中的配置数据的准确性 使系统能够警惕配置错误的发生 在 Cyclone IV 器件中使用 CRC 错误检测功能不会对布线及...
f 要了解关于数据解压缩和远程系统更新的详细信息, 请参考 Cyclone IV 器件手册卷 1 中的 Cyclone IV 器件的配置和远程系统更新章节。 要了解关于 SEU 缓解的...
上电期间 I/O 管脚保持在三态 Cyclone IV 器件的输出缓冲器在系统上电或关断期间被关闭。直到器件被配置并在推 荐的操作条件下运行时,Cyclone IV 器件才会驱动...
STM32F108C8 + W5200基于 HTTP的远程配置和固件更新_计算机软件及应用_IT/...图 1 W5200 评估板 该评估板单片机的系统资源:64KB 的闪存和 20KB 的 SRAM...
热门文档