Originalarbeit
BHM (2012) Vol. 157(5): 187 – 193DOI 10.1007/ s00501-012-0076-xPrinted in Austria
© Springer-Verlag 2012
Berg- und
Hüttenmännische

Monatshefte
Extended Tensile Ductility of a Formable High-Performance High-Manganese Steel
Ludovic Samek1, Enno Arenholz1 and Johannes Gentil2
1voestalpine Stahl GmbH, Research & Development, Linz, Austria2Buderus Edelstahl GmbH, Research & Development, Wetzlar, Germany
Received: April 2, 2012; accepted: April 13, 2012
Abstract: The aim of the contribution is to review the struc-nachgewiesen werden. Der untersuchte FeMnN Stahl bie-ture/property relationship of a high-performance FeMnN tet eine hervorragende Kombination von Zugfestigkeit und steel composition. In this work the influence of the Mn con-Duktilität an. Dieser FeMnN Stahl hat eine bemerkenswert tent ranging from 12 wt.-% to 24 wt.-% on the Fe-C phase hohe Bruchdehnung von etwa 100 % mit einer hohen Zug-diagram was calculated by thermodynamic simulations. festigkeit von 1100 MPa bei Raumtemperatur. Das Produkt The influence of coiling temperature on the microstructure von Bruchdehnung und Zugfestigkeit erreicht, proportional of the FeMnN steel was studied by annealing treatments zur Zähigkeit, einen außergewöhnlichen Wert von etwa from 350 °C up to 750 °C. It showed the possible presence 110000 % MPa. Die erweiterte Zug-Duktilität des Hochleis-of cementite and martensite/pearlite after long annealing tungs-FeMnN Stahl wird der Nano-Zwillingsbildung indu-treatments at temperatures close to 500 °C. The steel was zierten Plastizität (NS-TWIP) zugeschrieben, die durch Trans-observed to exhibit outstanding combinations of tensile missionselektronenmikroskopie nachgewiesen wurde.
strength and ductility. The FeMnN steel exhibited at room temperature a remarkably high total elongation of about 100 % with a high tensile strength level of 1100 MPa. This product, proportional to toughness, achieved an outstand-1. Introduction
ing value of about 110000 %MPa. The extended tensile duc-Since their discovery in 1882 by Robert Abbott Hadfield1 tility of the high-performance FeMnN steel was attributed high-Mn steels (HMnS) have been subject to numerous to the nano-size twinning induced plasticity (NS-TWIP), research studies. Recent trends in automotive industry which was observed by in-depth transmission electron mi-have led to a great interest in steels with high-Mn con-croscopy study.
tents due to their superior toughness and ductility2. Ten-sile strengths of over 800 MPa with elongations greater Erweiterte Duktilität von formbarem than 50 % can be readily achieved by HMnS, which makes Hochleistungsmanganhartstahl
them very attractive for hot- and cold-rolled light-weight automotive applications. Because of their superior form-Zusammenfassung: Das Ziel dieser Publikation ist eine
ability they are ideally suited for manufacturing complex Übersicht über den Einfluss der Struktur auf die Eigen-automotive parts, e. g. side members. They allow to man-schaften eines Hochleistungs-FeMnN Stahls zu geben. Im ufacture components with only one or limited number of Rahmen dieser Arbeit wurde der Einfluss vom Mn-Gehalt required forming operations. Due to their high specific en-von 12 Gew.-% bis 24 Gew.-% basierend auf dem Fe-C-Pha-ergy absorption they can be employed to absorb high en-sendiagramm durch thermodynamische Simulationen be-ergy in vehicle crash events3. Challenges with respect to rechnet. Der Einfluss der Temperatur beim Haspeln auf die hydrogen-embrittlement and anti-corrosion coating are Mikrostruktur des Stahls wurde durch FeMnN Glühbehand-under investigation.
lungen von 350 °C bis 750 °C untersucht. So konnte das HMnS are composed of a single austenitic phase or mul-mögliche Auftreten von Zementit und Martensit / Perlit nach tiphase matrix with a major volume fraction of austenite. langen Glühbehandlungen für Temperaturen nahe 500 °C
They can be classified according to their characteristic de-formation mechanisms occurring during plastic deforma-Corresponding author:
Dr. L. Dipl.-Ing. Ludovic Samek, M.Sc.tion. Depending on their composition and deformation Research & Development, voestalpine Stahl GmbH,
mechanism, they are often referred to in literature as TRIP/Voestalpine-Straße 3, LTWIP (transformation induced plasticity and twinning in-E-Mail: Ludovic.Samek@voestalpine.com
-.BG04.1155 , 4020 Linz, Austria. duced plasticity steels) or TWIP (twinning induced plasticity
BHM, 157. Jg. (2012), Heft 5© Springer-Verlag
Samek et al.
187
High tensile ductility in a nanostructured metal_化学_自然科学_专业资料。...highperformance structural applications including microelectromechanical and ...
Development and Validation of a Reverse-phase High Performance Liquid Chromatography Method for_专业资料。CERSCNEEUVEIIS21,613—3 HM.E.HIS NIRSTE 002()37...
机械通用,外文翻译Development of a high-performance laser-guided deep-holeboring tool_机械/仪表_工程科技_专业资料。Development of a high-performance laser-...
Flexural Strength and Ductility of Extended Pile-...Introduction Seismic performance of a bridge ...high-strength steel tie-down rods, each stressed...
Contraception 76 (2007) 228 – 232 Original research article Development of a high-performance liquid chromatographic method for the determination of ...
Design, analysis and realisation of a highperformance magnetic gear K. Atallah, S.D. Calverley and D. Howe Abstract: Magnetic gears offer signi?cant ...
Reliability Assessment of a High Performance Flip-Chip BGA Package (organic...states of stress that are dominated by tensile stress and tensile fatigue. ...
Facile synthesis of large-area manganese oxide nanorod arrays as a high-performance electrochemical_化学_自然科学_专业资料。Facile synthesis of large-area ...
-FFECT OF VELOCITY ON DUCTILITY JNDER HIGH VELOCITY FORMING_专业资料。维普资讯 http://www.cqvip.com CHIS 0URNALOFMECNEEJ HANICAL NGIERIENENG ?3 ? 2 V12...
-FFECT OF VELOCITY ON DUCTILITY JNDER HIGH VELOCITY FORMING_专业资料。维普资讯 http://www.cqvip.com CHIS 0URNALOFMECNEEJ HANICAL NGIERIENENG ?3 ? 2 V12...
热门文档