Reaver v1.4 参数说明
-i, --interface=<wlan> Name of the monitor-mode
interface to use
网卡的监视接口,通常是 mon0
-b, --bssid=<mac> BSSID of the target AP AP 的
MAC 地址
Optional Arguments:
-m, --mac=<mac> MAC of the host system
指定本机 MAC 地址,在 AP 有 MAC 过滤的时候需要使用
-e, --essid=<ssid> ESSID of the target AP 路由器的
ESSID,一般不用指定
-c, --channel=<channel> Set the 802.11 channel for
the interface (implies -f) 信号的频道,如果不指定会自动扫
描
-o, --out-file=<file>Send output to a log file [stdout]
标准输出到文件
-s, --session=<file> Restore a previous session file
恢复进程文件
-C, --exec=<command> Execute the supplied
command upon successful pin recovery pin 成功后执行
命令
-D, --daemonize Daemonize reaver
设置 reaver 成 Daemon
-a, --auto Auto detect the best advanced options
for the target AP 对目标 AP 自动检测高级参数
-f, --fixed Disable channel hopping
禁止频道跳转
-5, --5ghz Use 5GHz 802.11 channels 使用 5G 频道
-v, --verbose Display non-critical warnings (-vv for
more) 显示不重要警告信息 -vv 可以显示更多
-q, --quiet Only display critical messages 只显示关键信息
-h, --help Show help 显示帮助 Advanced Options:
-p, --pin=<wps pin> Use the specified 4 or 8 digit
WPS pin
直接读取 psk(本人测试未成功,建议用网卡自带软件获取)
-d, --delay=<seconds> Set the delay between pin
attempts [1]
pin 间延时,默认 1 秒,推荐设 0
-l, --lock-delay=<seconds> Set the time to wait if
the AP locks WPS pin attempts [60] AP 锁定 WPS 后
等待时间
-g, --max-attempts=<num> Quit after num pin
attempts
最大 pin 次数
-x, --fail-wait=<seconds> Set the time to sleep after
10 unexpected failures [0]
10 次意外失败后等待时间,默认 0 秒
-r, --recurring-delay=<x:y> Sleep for y seconds every
x pin attempts
每 x 次 pin 后等待 y 秒
-t, --timeout=<seconds> Set the receive timeout
period [5] 收包超时,默认 5 秒
-T, --m57-timeout=<seconds> Set the M5/M7
timeout period [0.20] M5/M7 超时,默认 0.2 秒
-A, --no-associate Do not associate with the AP
(association must be done by another application)
不连入 AP(连入过程必须有其他程序完成)
-N, --no-nacks Do not send NACK messages
when out of order packets are received
不发送 NACK 信息(如果一直 pin 不动,可以尝试这个参数)
-S, --dh-small Use small DH keys to improve crack
speed
使用小 DH 关键值提高速度(推荐使用)
-L, --ignore-locks Ignore locked state reported by the
target AP 忽略目标 AP 报告的锁定状态
-E, --eap-terminate Terminate each WPS session with
an EAP FAIL packet
每当收到 EAP 失败包就终止 WPS 进程
BT5 Reaver v1.4 参数说明 超详细+PIN不动及重码的原因分析和应对措施_计算机软件及应用_IT/计算机_专业资料。BT5 Reaver v1.4 参数说明 超详细+PIN不动及...
Reaver1.4参数分析 Reaver v1.4 WiFi Protected Setup Attack Tool Copyright (c) 2011, Tactical Network Solutions, Craig Heffner <> Required Arguments: -i...
Reaver1.4 参数分析 Reaver v1.4 WiFi Protected Setup Attack Tool Copyright (c) 2011, Tactical Network Solutions, Craig Heffner <> Required Arguments: -...
Reaver1.4参数分析_计算机软件及应用_IT/计算机_专业资料。无限破解软件参数分析Reaver1.4 参数分析 Reaver v1.4 WiFi Protected Setup Attack Tool Copyright (c...
reaver参数说明_计算机硬件及网络_IT/计算机_专业资料。Reaver 参数 ---天天 必须...--5ghz -v, --verbose -q, --quiet -h, --help Advanced Options:高级...
/ 【免骨头】BT5 Reaver v1.4 参数说明 超详细+PIN 不动及重码的原因分析 和应对措施 [复制链接] 电梯直达 1# 四川吃货 发表于 2013-9-28 19:22:11 ...
Reaver_参数解析_计算机软件及应用_IT/计算机_专业资料。破解WAP 破解AP reaver参数Reaver v1.4 WiFi Protected Setup Attack Tool Copyright (c) 2011, Tactical ...
【免骨头】BT5 Reaver v1.4 参数说明超详细+PIN 不动及重码的原因分析和应对措施 在坛子里和群里,经常遇到朋友问 PIN 不动和重码严重如何解决的问题,这的确...
Reaver 基本命令参数详解及应用 Reaver 基本命令参数 XiaoPanOS 下: 选择“终端”输入 sudo thunar 这里是为了取得超级权限,选择系统文件-usr-local-ect-reave ...
热门文档