文档下载 文档下载导航
设为首页 | 加入收藏
搜索 请输入内容:  
 导航当前位置: 文档下载 > 所有分类 > 工程科技 > 机械/仪表 > Design and Modeling of Femto Air Bearing Slider
侵权投诉

Design and Modeling of Femto Air Bearing Slider

Engineering, 2010, 2, 841-854

doi:10.4236/eng.2010.211107 Published Online November 2010 (doc.guandang.net).

Design and Modeling of Femto Air Bearing Slider

1

Ching F. Yong1, Eddie Y. K. Ng1*, Wei D. Zhou2, Wan K. Ng3

School of Mechanical & Aerospace Engineering, Nanyang Technological University, Singapore City, Singapore 2

Data Storage Institute, (A*STAR) Agency for Science, Technology and Research, Singapore City, Singapore

3

The Australian School of Advanced Medicine, Macquarie University, Sydney, Australia

E-mail: mykng@ntu.edu.sg

Received August 6, 2010; revised October 11, 2010; accepted October 12, 2010

Abstract

This paper presents the studies of the performance of an improved femto air bearing slider which is opti-mized based on the past studies and effort. The flying characteristics performance of this novel femto slider is relatively stable over different radii. This optimized slider achieved a flying height of 3 nm, with variation of about 0.2 nm. The variations for pitch and roll values are 6 µrad and 0.9 µrad respectively. In the studies for the effect of side rail on flying characteristics, it was found that there exists transition of pitch value when the side rail is located very close to the leading edge. The modulation of flying height reduces greatly when the areas of double shallow steps increase. The roll variation reduces when the flat double shallow steps pro-file is modified into a “V-Shape” profile.

Keywords: Femto Air Bearing, Performance, Slider Design, Modeling, Simulation, Optimization

1. Introduction

To enhance capacity and performance in meeting the high demands of hard disk drives (HDDs) nowadays, the flying heights of the sliders have to be very low and fly-ing stability is therefore critical for the air bearing sliders design. Pitch is mainly affected by step recess; roll is affected by side rails or side pads while the trailing pad is correlated to the pitch and flying height. The negative pressure design can improve slider performance with high positive pressure generation and therefore result in high air bearing stiffness at the trailing pad in particular. This allows the slider to follow the waviness of the disk surface better. When the step rail area is increased, there is an increase in pitch with higher positive pressure force at the increased step area. There is also an increase in the flying height due to larger air bearing resultant force. When the area of the trailing edge rail (trailing pad) is increased, the flying height increases and pitch reduces. In track seeking simulation, it is found that the addition of side pads (beside the trailing pad) increases the roll stiffness which stabilizes the slider. The amplitude of the slider oscillation depends on the air bearing stiffness. The rate of decay of the oscillations depends on the damping ratio of the slider.

Liu et al’s experimental result on flying height modu-lation due to disk waviness suggests a better flying height

modulation performance using femto slider as compared to pico slider [1]. By introducing a mini high-pressure trailing pad and double shallow steps, the performance is significantly improved due to a sharp pressure profile footprint is achieved, thus increases the slider’s dynamic response. A negative pressure slider design has the best performance with low sensitivity to skew and manufac-turing tolerances. However, this negative pressure slider design has larger altitude sensitivity which can be reduced by optimizing the pitch angle through rail shaping [2]. Two sliders with shallow step air bearing pads are simu-lated and compared with experimental results. Wada et al conclude that to achieve good flying stability in a very low flying condition, high air bearing stiffness is neces-sary [3]. For dynamic simulation, three sub-25nm flying height sliders are simulated to determine their suitability for near contact recording. The results show that a slider with higher air bearing stiffness and smaller slider will decrease the flying height modulation of the slider. Dur-ing track seeking process, the flying height modulation is found to be dependent on the effective skew angle, seek-ing velocity, seeking direction and the roll motion caused by the inertia of the moving head. Lu et al report that a larger roll stiffness and roll damping ratio can produce a smaller roll motion effect on the flying height modulation [4]. Lee et al studied the effect of head parameters on the take-off velocity of a slider and they found that an in-

Design and Modeling of Femto Air Bearing Slider

第1页

你可能喜欢

热门文档

相关文档

  • 综合过程Design Compiler

    Design Compiler 使用简要说明 综合过程 Design Compiler可以针对层次化的组合电路或者时序电路的速度、面积和可布 性进行优化。按照所定义的电路的测量特征所要达到的...

  • Design

    Design by Robert Frost Maqingxue u200917075 Routine 1、The author(writing background) 2、The poem 3、Why this poem is a Modernism? 2012-6-23 Robert ...

  • design & workmanship control

    日本 ? 马来西亚 DESIGN & WORKMANSHIP CONTROL 设计及工艺质量控制 CONTENT 目录 ? Design & Workmanship Control System Review 设计及工艺质量控制体系检讨 ? ...

  • 中文教程-Design_Expert设计

    4 Design Expert 软件的历史 1982年,统计学家Pat Whitcomb 决心开发一个简单易用的试验设计软件,取 名为Design-Easy,1985年这个软件开发出来并卖出了第一个拷贝。...

  • DESIGN AND BUILD CONTRACTS

    Design and Build Contracts Nicholas Longley Partner Design and Build What is design and build? Anatomy of a Design and Build Contract? Advantages Main ...

  • Design Compiler简介

    在你调用 Design Compiler 的窗口里,显示程序标题和 dc_shell 提示符。 图 2-3 显示了一个程序标题和默认提示符的例子: 图 2-3 程序标题和默认提示符 (2)...

  • Organization Design

    Organization Design_经管营销_专业资料。ORGANIZATION DESIGN 2 Diamensions to apply Organization Design 组织架构设计中的五项考量因素 Strategy: Determine...

  • Ergonomics and Design

    Ergonomics and Design_建筑/土木_工程科技_专业资料。Ergonomics and Design Modern high-tech society of rapid development, is gradually changing to the pr...

  • Design For Manufacturability

    可制造性设计 Design For Manufacturability DFM - 1 Teresa Wang 整理 2010-9 影响阴影图表 100 90 80 70 60 50 40 30 20 10 0 70 70% 在早期设计阶段...

  • InDesign工具简介

    InDesign工具简介_电脑基础知识_IT/计算机_专业资料 暂无评价

站点地图 | 文档上传 | 侵权投诉 | 手机版
本站所有资源均来自互联网,本站只负责收集和整理,均不承担任何法律责任,如有侵权等其它行为请联系我们.
文档下载 Copyright 2013 doc.guandang.net All Rights Reserved.  -  email