强夯加固试验与模拟
CICTP 2012 © ASCE 20122978
Table 1. Basic rock material parameters
Uniaxial

Saturated uniaxial Elastic compressive compressive Softening modulus strength

strength coefficient (GPa) (MPa) (MPa)
73.07-155.54 33.08-120.56 0.453-0.898
27.94-54.50

Shear wave velocity (m/s) 557-765
Figure 1. The compacting machine Figure 2. The tamper hole
The acceleration of the broken stone fills was measured, and the measure
points’ arrangement is shown in Figure 3. The in-situ tests were performed with
three kinds of load cases as shown in Table 2. The settlement of the hammer was
also measured under continuous compactions using a leveling instrument for two
load cases, 200tm and 300tm.
Figure 3. In-situ test measurement points arrangement
Table 2. The load cases for in-situ tests
Loads
1
2
3 Mass of the hammer 19.2t 18.8t 19.2t Compact energy 280tm 300tm 320tm
reinforcement learning_计算机软件及应用_IT/计算机_专业资料。增强学习Reinforcement Learning Peter Bodí k cs294-34 Previous Lectures ? Supervised learning – ...
reinforcement6.1_建筑/土木_工程科技_专业资料。Welcome to Class! Fu Xuejun June, 2012 force in force reinforce reinforcement Reinforcement S...
Reinforcement LearningReinforcement Learning隐藏>> Reinforcement Learning 主讲人:虞台文 大同大学资工所 智慧型多媒体研究室 Content Introduction Main Elements ...
Reinforcement Efficiency Analysis of Geosynthetic-Reinforced Embankment with Different Soil Prop_专业资料。维普资讯 http://www.cqvip.com Tascisfini nvri rnatn ...
学习Learning和强化 Reinforcement 和强化 学习解释经典条件反射, 解释经典条件反射,操作性条件反射和社会 认知理论之间的差异. 认知理论之间的差异 描述随机强化 描述...
学习Learning和强化Reinforcement学习Learning和强化Reinforcement隐藏>> 学习Learning和强化 Reinforcement ? 解释经典条件反射、操作性条件反射和社会 认知理论之间的...
随机强化-Contingent Reinforcement ? 随机强化:行为与影响该行为的事先和事 后环境事件之间的关系。一个随机强化由 三部分组成:前提、行为、结果。 ? 前提:先于...
王梦蛟Rubber_Reinforcement_related_to_tire_-_rolling_resistance_能源/化工_工程科技_专业资料。王梦蛟Rubber_Reinforcement_related_to_tire_-_rolling_...
OCV Reinforcement_机械/仪表_工程科技_专业资料。366 Single-End Roving for Pultrusion and Filament Winding Processes PRODUCT DESCRIPTION Single-End R...
therefore, after the reinforcement, component's supporting capacity was mainly decided in bends under the condition the original component's supporting ...
热门文档