Parallel Flow Regenerative (PFR) Lime Shaft Kilns
Comparison of lime kiln types
Two main types of vertical shaft kilns exist. The single shaftcounter flow heating kiln and the multiple shaft parallel flow heatingkiln. The standard PFR-Kiln is a two-shaft kiln (see Fig. 3) defined byalternating burning and non-burning shaft operation.There are two distinguishing features of the PFR-Kiln:
1) the parallel flow of hot gases and stone in the burning zone, and2) the regenerative preheating of combustion air in the process. This type of kiln is ideally suited to produce soft burned, highreactive lime and dolomitic lime because of the conditions created bythe parallel flow of the stone and the combustion gases in theburning shaft. Additionally, the regenerative process provides thelowest heat consumption of all modern kilns available today. Thedifference in the temperature profile of conventional single shaftkilns and PFR-Kilns is depicted in Fig. 1, where the curves show thetemperatures of the material, of the air and of the combustion gasesflowing through the kiln.
In single shaft kilns usually counter flow heating is applied, a


In parallel flow kilns the fuel is introduced at the upper end of theburning zone and the combustion gases travel parallel to thematerial. Fig. 1b shows a typical temperature profile where the greenline represents the material temperature, the blue lines in the pre-heating and cooling zone the relevant air temperatures and the redline the combustion gas and kiln exhaust gas temperatures. As thefuel is injected at the upper end of the burning zone where the mate-rial can absorb most of the heat released by the fuel the temperaturein the burning zone is typically as low as 950 °C on average. Becauseof this, parallel flow heating is the best solution for the productionof soft burned, reactive lime and dolomitic lime as required in mostapplications.
The second important characteristic of the PFR-Kiln is theregenerative preheating of the combustion air. In kilns with counterflow heating the combustion air is preheated in the cooling zone bythe sensible heat contained in the calcined lime. The amount ofpreheating is limited, however, by the enthalpy of the lime. In thecounter flow heating process there is a surplus of usable sensible
石灰文档 石灰窑选型_专业资料。不错的好东西关于石灰窑型选择做窑多年,做过几种窑型,对窑型的选择说几点个人意见,供大 家参考: 一、介绍窑型 (一)、土...
石灰窑备品备件清单_表格类模板_表格/模板_实用文档 暂无评价0人阅读0次下载举报文档 石灰窑备品备件清单_表格类模板_表格/模板_实用文档。名称 燃烧梁 吸气...
活性石灰窑技改工程可行性分析报告_调查/报告_表格/模板_实用文档。活性石灰窑技改工程可行性分析报告今日推荐 78份文档 笑翻神图...
石灰窑中心学校第十四周工作总结_工作总结/汇报_总结/汇报_实用文档。石灰窑中心学校第十四周工作总结二 0 一四年十二月五日本周以来,学校举行特色化办学研讨会...
realizetheentireMaerzlimekilntoproducetheentireprocess automaticcontrolto Laythefoundation. Keywords:marzlimekiln;simensfrequencychanger:hoist 1 引言莱钢麦尔兹石灰窑工艺...
realizetheentireMaerzlimekilntoproducetheentireprocess automaticcontrolto Laythefoundation. Keywords:marzlimekiln;simensfrequencychanger:hoist 1 引言莱钢麦尔兹石灰窑工艺...
热门文档