电力电子 外文期刊
Power Electronics in Wind Turbine Systems
F. Blaabjerg, Z. Chen, R. Teodorescu, F. Iov
Aalborg University, Institute of Energy Technology Pontoppidanstraede 101, DK-9220 Aalborg East, Denmark fbl@iet.aau.dk, zch@iet.aau.dk, ret@iet.aau.dk, fi@iet.aau.dk
doc.guandang.net
Abstract – The global electrical energy inexhaustible resources of the primary energy. However, consumption is still rising and there is a steady demand to increase the power capacity. The production, distribution and the use of the energy should be as technological efficient as possible and incentives to save energy at the end-user should be set up. The deregulation of energy has lowered the investment in larger power plants, which means the need for new electrical power sources may be very high in the near future. Two major technologies will play important roles to solve the future problems. One is to change the electrical power production sources from the conventional, fossil (and short term) based energy sources to renewable energy resources. The other is to use high efficient power electronics in power systems, power production and end-user application. This paper discuss the most emerging renewable energy source, wind energy, which by means of power electronics is changing from being a minor energy source to be acting as an important power source in the energy system. By that wind power is also getting an added value in the power system operation. I. INTRODUCTION In classical power systems, large power generation
plants located at adequate geographical places produce
most of the power, which is then transferred towards
large consumption centers over long distance transmission lines. The system control centers monitor
and control the power system continuously to ensure the
quality of the power, namely the frequency and the
voltage. However, now the overall power system is
changing, a large number of dispersed generation (DG)
units, including both renewable and non-renewable sources such as wind turbines, wave generators,
photovoltaic (PV) generators, small hydro, fuel cells and
gas/steam powered Combined Heat and Power (CHP)
stations, are being developed [1]-[2] and installed. A
wide-spread use of renewable energy sources in distribution networks and a high penetration level will be
seen in the near future many places. E.g. Denmark has a
high penetration (> 20%) of wind energy in major areas
of the country and today 18% of the whole electrical
energy consumption is covered by wind energy. The
main advantages of using renewable energy sources are the elimination of harmful emissions and the
1-4244-0449-5/06/$20.00 ©2006 IEEE IPEMC the main disadvantage, apart from the higher costs, e.g. photovoltaic, is the uncontrollability. The availability of renewable energy sources has strong daily and seasonal patterns and the power demand by the consumers could have a very different characteristic. Therefore, it is difficult to operate a power system installed with only renewable generation units due to the characteristic differences and the high uncertainty in the availability of the renewable energy sources. The wind turbine technology is one of the most emerging renewable technologies. It started in the 1980’es with a few tens of kW production power to today with Multi-MW range wind turbines that are being installed. This also means that wind power production in the beginning did not have any impact on the power system control but now due to their size they have to play an active part in the grid. The technology used in wind turbines was in the beginning based on a squirrel-cage induction generator connected directly to the grid. By that power pulsations in the wind are almost directly transferred to the electrical grid. Furthermore there is no control of the active and reactive power,
which typically are important control parameters to
regulate the frequency and the voltage. As the power
range of the turbines increases those control parameters become more important and it is necessary to introduce power electronics [3] as an interface between the wind turbine and the grid. The power electronics is changing
the basic characteristic of the wind turbine from being an energy source to be an active power source. The electrical technology used in wind turbine is not new. It has been discussed for several years [6]-[46] but now the price pr. produced kWh is so low, that solutions with power electronics are very attractive.
This paper will first discuss the basic development in power electronics and power electronic conversion. Then different wind turbine configurations will be explained both aerodynamically and electrically. Also different control methods will be explained for a turbine.
Wind turbines are now more often installed in remote areas with good wind conditions (off-shore, on-shore) and different possible configurations are shown and compared. Finally, a general technology status of the wind power is presented demonstrating a still more efficient and attractive power source. 2006
power electronic4 16页 免费 power electronic1 12页 免费 power electronic7 15页 免费 power electronic8 31页 免费 power electronic5 11页 2财富值...
40页 1财富值 power electronic1 12页 免费 Power Circuit 暂无评价 5页 免费 Power Supply Circuit 44页 1财富值喜欢此文档的还喜欢 交流转直流 29页 1财富...
5 Power Electronic Systems Block diagram Power Processor along with its controller including the corresponding measurement and interface circuits, is also called...
power fuel cell/electrolyser A newly developed Virtex 5 FPGA (Field Programmable Gate Array) for advanced real time control of power electronic converters. ...
Power Electronics 2005.8 1 Power Electronics Ch1. Power Electronic Systems 2 Outline 1. 2. 3. 4. 5. What is power electronics? The history Scope ...
Ch1_第一章 Power Electronic Systems_工学_高等教育_教育专区。电力电子英文...Resonant and quasi-resonant converters 1-32 1-5 About the text 1-33 ...
Ch1 Power Electronic systems 隐藏>> Power Electronics 1 Power Electronics ?Introduction 2 Outline 1. 2. 3. 4. 5. What is power electronics? The ...
1.5 Other new power electronic devices 1.1 An introductory overview of power electronic devices 1) The concept and features Power electronic devices: are...
power converter: --Power converter --Converter --Switching converter --Power electronic circuit --Power electronic converter Introduction 6 备课笔记 5. ...
电力电子技术 Power Electronic Technology 杜少武 第五讲 电力电子器件(四) 4....关断时施加一定幅值的负驱动电压(一般取 -5 ~ 15V)有利于减小关断时间和关...
热门文档