文档下载 文档下载导航
设为首页 | 加入收藏
搜索 请输入内容:  
 导航当前位置: 文档下载 > 所有分类 > 工程科技 > 信息与通信 > MHF_Plus_DC_DC_Converters
侵权投诉

MHF_Plus_DC_DC_Converters

Crane aerospace & electronics Power solutions

MHF+ Single, dual and triple dC/dC Converters

28 VOlT inPuT – 15 WATT

Features

Only 0.33 inches (8.38 mm) high in a hermetically sealed case

input voltage 16 to 40 vdC - MHF+281r9S 20 to 32 vdC

- triple output models16 to 48 vdC transient protection

- Single and dual: 50 v for 50 ms - triple: 80 v for 120 ms Fully isolated

Fixed high frequency switching operating temperature –55° to +125°C

MHF_Plus_DC_DC_Converters

inhibit and synchronization functions indefinite short circuit protection

MHF_Plus_DC_DC_Converters

up to 84% efficiency

the MHF+ Single and dual Series of high frequency dC/dC converters offers a wide input voltage range of 16 to 40 volts (MHF+281r9S, 20 to 32 volts) and up to 15 watts of output power. the units are capable of withstanding short term transients up to 50 volts. the converters are offered with standard screening, “eS” screening, or fully compliant to “883” Mil-PrF-38534 Class H screening. Standard microcircuit drawings (SMd) are available.

DESCRIPTION

MHF+ Single and dual dC/dC ConverterS

enabled when the pin, which is internally connected to a pull-up resistor, is left unconnected or is connected to an open-collector gate. the open circuit output voltage associated with the inhibit pin is 8.5 to 12 v. in the inhibit mode, a maximum of 4 ma must be sunk from the inhibit pin. See Figure 3.

synChronization

Converter Design

the MHF+ converters are switching regulators that use a

quasi-square wave, single-ended forward converter design with a constant switching frequency of 550 kHz typical. isolation between input and output circuits is provided with a transformer in the forward path and a temperature compensated optical link in the feedback control loop. See Figure 1.

For the MHF+ dual output models, good cross regulation is maintained by tightly coupled output magnetics. up to 90% of the total output power (80% on 2805d) is available from either output, providing the opposite output is simultaneously carrying 10% of the total output power (20% on 2805d models). Predictable current limit is accomplished by directly monitoring the output load current and providing a constant current output above the overload point.

an external synchronization feature is included that allows the user to adjust the nominally 550 kHz operating frequency to any frequency within the range of 500 kHz to 600 kHz. this is initiated by applying a signal input of the desired frequency to pin 5. the capacitively coupled sync input will synchronize on a differential signal of as low as 4 volts to as high as 5 v. For single and dual output models, if the sync function is not used, connect the terminal to input common.

short CirCuit ProteCtion

MHF+ Series single and dual output converters provide short

circuit protection by restricting the output current to approximately 115% of the

full load output current. the output current is sensed in the secondary stage to provide highly predictable and accurate current limiting, and to eliminate foldback characteristics.

unDervoltage loCkout

inhibit FunCtion

MHF+ converters provide an inhibit terminal that can be used to disable internal switching, resulting in no output current and very low quiescent input current. the converter is inhibited when an active low of ≤0.8 V is applied to the inhibit pin. The unit is

undervoltage lockout prevents the single and dual output converters from operating below approximately 14 vdC input voltage to keep system current levels smooth, especially during initialization or re-start operations.

第1页

你可能喜欢

热门文档

相关文档

  • MHF+2812S中文资料

    ? ? ? MHF+ SERIES? SINGLE & DUAL DC/DC CONVERTERS The MHF+ Single ...Full power operation at -55° C to +125° C plus the ability to with...

  • MHF+2805S中文资料

    MHF+ Single, Dual and Triple DC/DC Converters 28 VOLT INPUT – 15 WATT...Full power operation at -55° C to +125° C plus the ability to with...

  • IXFK24N100_07中文资料

    ID25 Note 2 Applications l DC-DC converters l Battery chargers l Switched...PLUS 247TM package for clip or spring mounting l Space savings l High ...

  • 产品选型指南LTC_Selector_Guide

    Module DC/DC Converters Battery Chargers LED Drivers Hot Swap Interface ...Plus DC/DC ...109 Battery Chargers – 4.1V Float Voltage ......

  • MHF+285R2S中文资料

    MHF+ Single, Dual and Triple DC/DC Converters 28 VOLT INPUT – 15 WATT...Full power operation at -55° C to +125° C plus the ability to with...

  • MHF+283R3S中文资料

    ? ? ? MHF+ SERIES? SINGLE & DUAL DC/DC CONVERTERS The MHF+ Single ...Full power operation at -55° C to +125° C plus the ability to with...

  • IXTB62N50L-PLUS264

    g PLUS 264TM (IXTB) G D S (TAB) G = Gate D = Drain S = Source...DC-DC converters Battery chargers DC choppers Temperature and lighting controls...

  • MAX1634AEAI中文资料

    The MAX1631/MAX1634 include a secondary feedback input (SECFB), plus a ...DC-DC Converters +3.3V 3.3V SMPS 5V SMPS +5V Pin Configurations and ...

  • IXFK24N90Q中文资料

    250 ns PLUS 247TM (IXFX) Maximum Ratings 900 900 ±20 ±30 24 96 24...DC-DC converters l Battery chargers l Switched-mode and resonant-mode power...

站点地图 | 文档上传 | 侵权投诉 | 手机版
本站所有资源均来自互联网,本站只负责收集和整理,均不承担任何法律责任,如有侵权等其它行为请联系我们.
文档下载 Copyright 2013 doc.guandang.net All Rights Reserved.  -  email