文档下载 文档下载导航
设为首页 | 加入收藏
搜索 请输入内容:  
 导航当前位置: 文档下载 > 所有分类 > 工程科技 > 信息与通信 > A DWDM-ROF system base on frequency interleaving and SSB modulation
侵权投诉

A DWDM-ROF system base on frequency interleaving and SSB modulation

A DWDM-ROF System Base on Frequency

Interleaving and SSB Modulation

Xinqiao Chen, Ruitao Li, Mingming Bai, Lingfan Zhang

Communication University of China

Beijing, China

Abstract- A frequency-interleaved DWDM-ROF system was designed to improve the optical spectrum efficiency. Meanwhile, a possible demultiplexing (DEMUX) schemes using arrayed-waveguide grating (AWG) was proposed. In the experiment, 25-GHz-separated four-channel optical single sideband signals modulated by a 60-GHz millimeter-wave carrying 2Gbit/s data were optically multiplexed by the frequency interleaving. Over 50-km standard single-mode fiber transmission, the results showed that interchannel-crosstalk had little effect on the system, and verified the feasible of designed demultiplexer.

Key word: AWG; dense-wavelength-division multiplexing (DWDM); frequency interleaving; single-sideband (SSB) modulation; radio over fiber (ROF)

I. INTRODUCTION

Radio over fiber (ROF) communication technology that had the advantages of optical fiber communication technology and mobile communication technology was an effective method to transmit broadband wireless signal. It used the advantage that optical fiber had almost unlimited bandwidth and low loss to make the transmission distance of multiple broadband wireless signal up to tens of kilometers. And the high-frequency equipments that were placed in base station formerly could be placed in the central station to make the resource sharing, so the base station can be simplified and the system cost was reduced.

Because the coverage of single base station was limited in ROF system, the form of micro-cellular that composed of base stations should be used to achieve a wide range of coverage. If each base station was allocated one wavelength, then many wavelengths of light would be used for uplink or downlink transmission. Although optical fiber had great bandwidth, DWDM technology was needed to use. Each channel was occupied by wide bandwidth because the RF signal was millimeter wave in ROF system. So if the ordinary way of multiplexing was used, the bandwidth spacing between the carriers must be wider than the bandwidth spacing between signal and carrier. On the other hand, after the millimeter-wave signal modulated, there was a wide free space between the optical carrier and sideband, optical spectrum efficiency was very low. For these reasons, frequency interleaving [1] - [2] can be used to improve the optical spectrum efficiency.

978-1-4244- 7618-3 /10/$26.00 ©2010 IEEE

In this paper, a frequency-interleaved DWDM-ROF system was designed. It can transmit four millimeter-wave channels that were single-sideband modulated, greatly improved the optical spectrum efficiency.

II. THE THEORY OF FREQUENCY

INTERLEAVING

Frequency interleaving meant that the spacing between the adjacent optical carriers was less than the spacing between the carrier and sideband in a channel. In this way, Number of adjacent channels were mixed, the free space between the carrier and sideband has been used in each channel.

Fig.1 (a) was an optical spectrum of conventional DWDM-ROF system with single-sideband modulation format. Millimeter-wave carrier frequency was in a 60GHz band. Using the optical SSB modulation, the spectral efficiency could be doubled compared to the optical DSB modulation. In the sense of cost reduction, it was preferable to use the channel separation in accordance with ITU grid because of the availability of optical components. Therefore, the minimum channel separation in this case was 100 GHz. However, the optical spectrum cannot be fully utilized because the bandwidth of the millimeter-wave signal was much narrower than the millimeter-wave carrier frequency. This shortcoming could be overcome simply by interleaving the optical frequency as show in Fig.1 (b). The channel separation was 25GHz. From the figure, it was clearly that using frequency interleaving could improve the optical

A DWDM-ROF system base on frequency interleaving and SSB modulation

spectrum efficiency.

Fig.1 (a) conventional DWDM-ROF system with optical SSB modulation format

第1页

你可能喜欢

热门文档

相关文档

  • DWDM试题与答案

    DWDM试题与答案_信息与通信_工程科技_专业资料。WDMDWDM 试题一、单项选择题: 1. 下面哪种情况下 DWDM 设备的 APR 功能一定会启动: A. 线路光功率下降; B....

  • 100G DWDM,深度优化OSNR的技术

    100G DWDM,深度优化OSNR的技术_信息与通信_工程科技_专业资料。WDM又叫波分复用技术是新一代的超高速的光缆技术,所谓波分复用技术,就是在单一光纤内同步传输多...

  • DWDM

    飞宇光电DWDM设备介绍产品介绍(DWDM系列) 2U机架式DWDM 珠海飞宇光电科技有限公司 DWDM设备介绍 OTU波长转换板卡 4.25G OTU板卡 采用光—电—光变换的方法实现波长...

  • DWDM系统习题答案

    2004-06-226 内部资料,请勿扩散 第 6 页, 共 31 页 DWDM 系统习题册 文档密级 DWDM系统组网与应用 4、请列举DWDM系统中的设备类型? 答: A. 光终端复用...

  • DWDM和OTN基本原理介绍

    ? 新的光纤:全波、真波、LEAF、G.654光纤等 课程内容第一章 波分复用技术概述 第二章 DWDM 系统的传输媒质 第三章 DWDM系统的组成 DWDM系统结构图总体结构...

  • DWDM的技术规范

    通路分配表 DWDM的技术规范 绝对频率参考和最小通路间隔选择193.1THz作为频率栅隔的参考频率比基 于任何特殊物质的绝对频率参考(AFR)更好, 193.1THz值处于几条AFR...

  • OptiX BWS 320G骨干DWDM光传输系统设备手册

    1-3 i OptiX BWS 320G 骨干 DWDM 光传输系统 设备手册 第1章 机柜 第1章 机柜 1.1 结构 OptiX BWS 320G 系统采用 ETSI 标准机柜,符合 ETS300-119-3 ...

  • 员工培训-DWDM和OTN

    ? 新的光纤:全波、真波、LEAF、G.654光纤等 课程内容第一章 波分复用技术概述 第二章 DWDM 系统的传输媒质 第三章 DWDM系统的组成 DWDM系统结构图总体结构...

  • DWDM试题答案

    5、请写出DWDM设备组网时必须考虑的三大要素:色散受限距离;功率预算; 光信噪比。 6、 传统的 2.5G 的 SDH 信号是满足 G.957 规范的光信号, 而应用于 DWDM ...

  • DWDM原理

    中兴通讯 中国兴旺 http://www.zhongxing.com 传输产品本部用服 DWDM产生背景 ? 利用TDM方式扩容已经日益接近技术的极 限 ? 已经铺设的 G.652 光纤的高色散...

站点地图 | 文档上传 | 侵权投诉 | 手机版
本站所有资源均来自互联网,本站只负责收集和整理,均不承担任何法律责任,如有侵权等其它行为请联系我们.
文档下载 Copyright 2013 doc.guandang.net All Rights Reserved.  -  email