文档下载 文档下载导航
设为首页 | 加入收藏
搜索 请输入内容:  
 导航当前位置: 文档下载 > 所有分类 > 工程科技 > 电子/电路 > 74740-0001中文资料
侵权投诉

74740-0001中文资料

74740-0001中文资料

元器件交易网doc.guandang.net

1000BASE-T RJ-45 GBIC FEATURES

1000Base-T RJ-45 GigabitEthernet GBIC CopperTransceiver

GBIC Mode

When the internal gigabit Ethernet transceiver (PHY) is configured to GBIC mode, the PHY can interface directly with the host serial/deserial(SERDES) interface. The host interface transmits and receives serial data differentially at 1.25Gbps. The copper interface is full featured and advertises full/half duplex, and 1000Base-T wire speed. Auto-Negotiation

Auto-Negotiation is supported over both the twisted pair copper link and SERDES interface as defined in the IEEE 802.3 standards and is performed as part of the initial set-up of the link. The copper link is negotiated according to the IEEE 802.3 Clause 28, and Clause 37 is used in the negotiation of the SERDES interface. The two interfaces advertise 1000Base-T full-duplex, and master/slave relationships. The master establishes the time control from its local clock source.The slave however recovers the clock from the received data stream. The GBIC application is limited to 1000Base-T wire speed only. Auto-Negotiation on the SERDES link is always restarted when a changeis detected on copper link (see Link Monitor and Loss-of-Signal for further details).Automatic MDI Crossover

The 1000Base-T GBIC transceiver performs a MDI crossover during Auto-Negotiation eliminating the need for crossover cables or cross-wired (MDIX) ports.

Loss of Signal -Link Monitor

Following Auto-Negotiation, the master and slave begin sending data over the twisted pair link. The master and slave continuously monitor the copper link for quality of data. The link status bit is setafter one microsecond of quality data. If the quality of copper link drops below factory PHY minimums, the GBIC will drop the SERDES link, and assert the LOS I/O interface (optional) in less than 200 milliseconds. Auto Power Savings Mode

When the copper link is lost, the GBIC automatically enters a low power mode reducing the chip power requirements. Full power mode resumes once the copper link is re-established.Not Implemented in GBIC Auto-Negotiation

Next page exchange and detection of remote faults are not auto-negotiated.

上一页第2页

你可能喜欢

热门文档

相关文档

  • 74552-0001中文资料

    HFA3-0001-5中文资料 10页 免费 74530-0001中文资料 暂无评价 2页 免费 74741-0001中文资料 暂无评价 4页 免费 74740-0001中文资料 暂无评价 11页 免费 ...

  • 74740-0003中文资料

    74740-0002中文资料 暂无评价 11页 免费 74740-0001中文资料 暂无评价 11页 免费 atmega16中文资料.0003 80页 5财富值 74742-0003中文资料 暂无评价 2页 免费...

  • 74740-0002中文资料

    74740-0002中文资料_电子/电路_工程科技_专业资料。元器件交易网www.cecb2b....ORDERING INFORMATION Order Number 74740-0001 74740-0002 74740-0003 Description...

  • 74742-0003中文资料

    74742-0002中文资料 2页 免费 74742-0001中文资料 暂无评价 2页 免费 atmega16中文资料.0003 80页 2下载券 74740-0003中文资料 暂无评价 11页 免费 74530-...

  • 74727-0002中文资料

    74741-0002中文资料 暂无评价 4页 免费 74740-0002中文资料 暂无评价 11页 ...Description *Lightpipe Location Mates with 74726-0001 74726-0002 74727-0001 ...

  • 71243-0003中文资料

    71061-0003中文资料 暂无评价 5页 免费 74740-0003中文资料 暂无评价 11页 ... Help 6 Matching Products 71243-3001 71243-3002 71243-0008 71243-0001 ...

  • 74726-0002中文资料

    74740-0002中文资料 暂无评价 11页 免费 74712-0002中文资料 暂无评价 2页 ...Description *Lightpipe Location Mates with 74726-0001 74726-0002 74727-0001 ...

  • 74530-0003中文资料

    74740-0003中文资料 暂无评价 11页 免费 74441-0003中文资料 暂无评价 2页 ...74530-0001 74530-0002 74530-0003 74530-0004 74530-0005 26awg 24awg 28awg...

  • 75800-0002中文资料

    74741-0002中文资料 暂无评价 4页 免费 74740-0002中文资料 暂无评价 11页 ...Comment Tail Plating Height PCB Peg 75800-0001 75800-0002 75908-0001 75908...

  • 74530-0002中文资料

    74741-0002中文资料 暂无评价 4页 免费 74740-0002中文资料 暂无评价 11页 ...74530-0001 74530-0002 74530-0003 74530-0004 74530-0005 26awg 24awg 28awg...

站点地图 | 文档上传 | 侵权投诉 | 手机版
本站所有资源均来自互联网,本站只负责收集和整理,均不承担任何法律责任,如有侵权等其它行为请联系我们.
文档下载 Copyright 2013 doc.guandang.net All Rights Reserved.  -  email