刘敬勇-广东工业大学
Characteristics of Heavy Metals in Urban Sewage Sludge and its Environmental
Capacity for Agricultural Land Use in Guangzhou, China
Liu Jing-yong, *Sun Shui-yu, Xie Wu-ming, Chen Min-ting, Chen Tao
(Faculty of Environmental Science and Engineering, Guangdong University of Technology, Guangzhou, 510006 Guangdong, China)
*www053991@126.com
Abstract: Urban sewage sludge can be applied to the land to serve as a fertilizer and soil conditioner. But the environmental risks for agricultural usage of urban sludge depends on the contents of pollutants in sludge and the properties of soils. The contents of (Zn、Cu、Pb、Cr、Mn、Ni) in seven kinds of sludges were analyzed and the fractionation characteristics of heavy metals in the two sludges were studied. The maximum application and annual application rates of sewage sludge in soil were calculated according to the soil environmental capacity. The results have shown that the contents of Cu, Zn, Mn, Ni were higher and Pb, Cr were lower. Although the contents of heavy metals were higher than the background values of Guangzhou crop soil , they meet the controlled standards of pollutants in sludges for agricultural use (GB18918-2002), except Cu in one sludge. Different heavy metals, as well as the same heavy metal in different sludges, had different forms. The active proportion of Zn, Mn, Ni was large and Cu, Cr existed mainly in reduction forms, but Pb and Fe were in the state of reducible and residual fractions.The main poisonous heavy metals were Cu and Zn according to the calculation of static environment capacity and the dynamic environment capacity of soil. And the maximum application rate of sludge from different sources was discriminative variant .In order to guarantee the safety of urban sludge in agricultural land process, the maximum application and annual application rates of urban sludge in red soil of Guangzhou should be taken into account with the contents of Cu and Zn firstly.
Keywords: urban sewage sludge; heavy metals; fractionation; agricultural land use
1. Introduction
During the process of waste water treatment, various approaches, including bacterial absorption, surface absorption of bacteria and mineral particles, co-precipitation with a number of inorganic salts (such as phosphate, sulfate, etc.), 50%~80% or more of heavy metals were concentrated in the sludge[1]. If the sludge disposed improperly, heavy metals pollution and other serious environmental problems will come out[2-3]. Because of abundant and available organic matters, nitrogen (N), phosphorus (P), potassium (K) and other nutrients in the sludge, agricultural usage would be one of the effective ways in sludge disposal[4-5]. However, there are lots of environmental risks during the process of agricultural usage, such as transferring and releasing of heavy metals[6]. In recent years, with the increasing of sludge production, more and more studies focused on transformation of heavy metals during the agricultural process[7-8].
Standards of the relevant heavy metals pollution control had been enacted after decades of study on the total amount of heavy metals in sludge using in the agriculture[7,9-18], But the standards did not involve the maximum application rate and the the annual application rate of sewage sludge according to the soil environmental capacity . Practices shown that the potential bioavailability of heavy metals and related eco-toxicity to plants are not only related to their total amount, but also determined by their chemical fractions in the environmental media to a greater extent[5-8,19]. Therefore, the more detailed information of heavy metals about the bioavailability and eco-toxicity to plants can be obtained by studying the chemical forms of heavy metals using sequential extraction procedure[2-3].
It was expected that, by 2020, the volume of waste water in the center district of Guangzhou city will reach 430×104m3·d-1[20], and the sewage sludge produced will be 1.29~2.15×104t·d-1 (98% moisture), calculating by the method that the amount of sludge production is 0.3%~0.5% of the volume of waste water. Hence, how to dispose and take use this large numbers of sewage sludge as agriculture usage safely and economically will be a
common environmental problem to be concerned. The main objectives of this study were to: (1) investigate the composition, concentration, distribution, chemical fractions of several common heavy metals (Mn, Cr, Pb, Cu, Ni and Zn); (2) predicate the maximum application rate and the the annual application rate of sewage sludge according to the soil environmental capacity.
2 Materials and Methods 2.1 Samples and pre-treatment
The sludge was taken from four major waste water treatment plants (WWTP) in Guangzhou. The details information about WWTP were shown in Table1. Samples were collected on the terminal conveyor belts of four WWTP at the same day in quarterly of 2008. One kind of sludge was collected at four times, each of which lasted for 2 hours, and samples were collected one by one at intervals of 0.5h, and then were mixed. In order to obtain more information about the other kinds of sludge in Guangzhou more fully, three other types of sludge derived from one paper mill in Guangzhou (ZZ), Zhaoqing WWTP (ZQ) and streams of rivers in Guangzhou(HC), were also collected respectively.
Samples were air-dried at room temperature, and ground and homogenized in an agate mortar, then passed through a 1-mm nylon sieve. After that, samples were placed into a 100±5℃ drying oven till the weight remains constant, bottled and blended completely and kept in plastic bottles at room temperature until analysis. 2.2 Physico-chemical analysis
Moisture content(%), pH, organic matter(LOI), total nitrogen (TN) , total phosphorus (TP) and the major elements such as calcium (Ca), Sodium(Na), potassium(K), magnesium(Mg) and iron(Fe) were determined using the methods of municipal wastewater treatment plant sludge test[21] and the standard analytical methods[22]. Some physico-chemical properties and major elements of sludges from the selective wastewater plants are listed in Table 2.
2.3 The total contents and fractions analysis
Total concentrations of heavy metals (Cr,Cu, Pb ,Mn ,Ni and Zn) in sewage sludge were determined using the modified method presented by [24].
广东工业大学刘敬勇Appl... 11页 4下载券 广东工业大学刘敬勇Case... 14页 4下载券 Characteris刘敬勇-广东... 6页 1下载券 第4章 溶液的热力学性质.....
2 0 1 0 造纸工业污泥燃烧特性及动力学实验研究刘敬勇摘 要 孙水裕 * 许..., character is ticsw ere i proved T he burn ing ti e w as shorten ...
27页 免费 Characteris刘敬勇-广东工... 6页 2财富值 The migration ability of... 8页 1财富值 Accumulation and Distrib... 暂无评价 15页 5财富值喜欢...
Characteris刘敬勇-广东工... 6页 2财富值 Spatial Distribution of ... 暂无评价 8页 5财富值 Heavy metals and Pb isot... 暂无评价 16页 2财富值 ...
Characteris刘敬勇-广东... 6页 1下载券 Limitations for heavy ... 暂无评价 7页 1下载券 An ultrasonic assisted... 10页 2下载券 Principle and Process...
Combustion characteris... 暂无评价 12页 1下载券 Experimental Study on ..... 广东工业大学刘敬勇Comb... 7页 4下载券 Study on the spray and... ...
热门文档