(UNSW). His current research interests are in modeling, quality control, algorithm and software development for precise positioning using GPS, Glonass, pseudolites and INS. He holds a Ph.D. from the Curtin University of Technology, Australia, and has autho
INTRODUCTION
Attitude determination is an important component innavigation, guidance and control systems used for a widerange of moving platforms such as spacecraft, air planes,robotics, land vehicles, and vessels. The potential of GPSfor addressing attitude determination applications wasrecognized even before the launch of the GPS satellites(Spinney, 1976). In a GPS-based attitude determinationsystem two or more antennas are mounted on a platform.The precise relative positions between these antennas aredetermined using the carrier phase measurements. Withboth the relative positions of these antennas in both thebody and local-level coordinate systems, the attitudeparameters of the platform can then be estimated. Duringthe past two decades, various hardware designs and dataprocessing algorithms for GPS attitude determination havebeen extensively investigated (for example, Brown et al.,1982; Cohen, 1992; Kruczynski et al., 1989; Lu, 1995;Van Graas & Braasch, 1991; Tsujii, 1998).
For attitude determination, if the known baseline lengthsare used, the minimum number of satellites can be threewhen conventional GPS receivers are used (Van Grass &Braasch, 1991; Euler & Hill, 1995), or even as few as twowhen special receivers are used (Cohen 1996). It has beendemonstrated that even tracking the minimum number ofsatellites, instantaneous ambiguity resolution and attitudedetermination are possible (Van Graas & Dutton, 1997).However, in such circumstances, the approximatecoordinates of the antennas have to be provided by othersensors. In addition, there are two valid solutions whichsatisfy the baseline length constraint. To identify thecorrect solution, the information regarding whether aspecific baseline component has a positive or negativevalue is necessary. When four or more satellites aretracked, these additional requirements will not have to befulfilled. In general, the more satellites that are tracked,the more reliable the attitude solutions.
On the other hand, the geometric distribution of thesatellites being tracked will have a significant impact onthe accuracy of the estimated attitude parameters. It iswell known that the horizontal components of the baselinesolutions are much better determined than the heightcomponent, which may result in a less accurate attitudesolution. The reason for this is that there usually are nolow elevation satellites to track. Even when some lowelevation satellites can be tracked, the measurements fromthese satellites are not of high quality.
Therefore, similar to the problem of carrier phase-basedGPS kinematic positioning, the dominant factors in GPSattitude determination are the number and geometricdistribution of the satellites tracked by the receivers. Toimprove the reliability and accuracy of the attitudesolutions in poor operational environments, integration ofGPS with another satellite system such as GLONASS, orother sensors including gyros and INS, has beeninvestigated. Examples in this regard are Cannon et al.
(1992); Han & Rizos (1999); Harvey (1998); Keong &Lachapelle (1999); Lu (1995); Mathes & Groten (1997);Phillips et al. (1998). Another potential technique foraugmenting GPS for attitude determination is through theuse of ground-based 'pseudo-satellites' (or pseudolites).The use of pseudolites can be traced back as early as 1976during the initial GPS user equipment tests at the U.S.Army Yuma Proving Ground, Arizona (Harrington &Dolloff, 1976). In the mid 1980s, the RTCM committeeSC-104 ('Recommended Standards for DifferentialNavstar GPS Service') designated the Type 8 Message forthe pseudolite almanac, containing the location, code andhealth information of pseudolites (Kalafus et al., 1986).During the last decade, pseudolites have been tested foraviation, marine and land navigation and positioningapplications (for example, Bartone, 1996; Choi et al.,2000; Dai et al., 2000; Cobb et al., 1995; Ford et al., 1996;Hein et al., 1997; Morley, 1997; Stone & Powell, 1998Zimmerman & Cannon, 1996). The use of pseudolites forattitude determination is discussed in this paper.
Unlike the situation with GPS-only attitude determination,an integrated GPS/pseudolite attitude determinationsystem is sensitive to the initial coordinates of both endsof the moving baselines. The reason for this is that,compared with the GPS satellites, the pseudolites are veryclose to the platform. Thus, biases in the initialcoordinates may lead to model errors. To develop anintegrated GPS/pseudolite attitude determination system,all these and other potential problems need to beaddressed.
This paper is organised as follows. The next sectionbriefly summarizes the attitude determination principles.A theoretical analysis of the model errors caused bylinearizing the measurement equations is then presented.An expression has been derived to describe the impact ofthe (satellite and pseudolite) orbital errors. Next, someresults from integrated GPS/pseudolite attitudedetermination experiments are presented. Finally, severalremaining issues will be discussed.ATTITUDE DETERMINATION
The attitude of a rigid body platform is defined by arotation transformation between the body-fixed coordinatesystem and the earth-fixed local-level coordinate system(North-East-Down). The ration matrix is expressed as
c(θ)c(ψ)s(φ)s(θ)c(ψ) c(φ)s()c(φ)s(θ)c(ψ)+s(φ)s(ψ) Re= ψ c(θ)s(ψ)s(φ)s(θ)s()c(φ)s(θ)s(ψ) s(φ)c(ψ) (1)b
ψ)+c(φ)c(ψ
s(θ)s(φ)c(θ)c(φ)c(θ)
where c() is a cosine function and s() is a sine function;
φ,θ and ψ are roll, pitch and yaw (heading) parametersrespectively. If the relative positions of (baseline vectorsbetween) the antennas mounted on the platform aredescribed as bi in the body system, and as ei in the local-
of the International Association of Geodesy (IAG) Special Study Group (SSG)...He is a member of the Editorial Advisory Board of the journal GPS ...
Shaowei is Chairman of the International Association of Geodesy (IAG) Special Study Group (SSG) 1.179 "Wide Area Modelling for Precise Satellite ...
Solutions, and Chairman of the study group on pseudolite applications in positioning and navigation within the International Association of Geodesy's Commission...
Chairman of the IAG's Special Study Group 1.179 Wide November 1998. ...multiple reference stations, International Association of Geodesy Symposia, vol....
He is Chairman of the Working Group "Pseudolite ...the International Association of Geodesy's Special ...In this study, we apply a method based on ...
study of engineering structures; and Maintain links...of the International Association of Geodesy (IAG) ...Working Group 6.2, Special Equipment for ...
例如,与 GRS75(Geodetic Reference System, GRS75)托球体, recommended by the International Association of Geodesy (IAG)比较,Krassovsky的长半轴比GRS75长了约...
The IGS is an approved service of the International Association of Geodesy since 1994 and is recognized as a member of the Federation of Astronomical and...
The International Association of Geodesy (IAG) ...? The study of the natural and social ... has a special position and role as a promoter...
(GRS80) Adopted by the International Association of Geodesy (IAG) during the General Assembly 1979 equatorial radius of the Earth a 6378137 m f:=1 : ...
热门文档