文档下载 文档下载导航
设为首页 | 加入收藏
搜索 请输入内容:  
 导航当前位置: 文档下载 > 所有分类 > 工程科技 > 信息与通信 > 2014-OE-Super-Nyquist-WDM transmission over
侵权投诉

2014-OE-Super-Nyquist-WDM transmission over

Super-Nyquist-WDM

Based on the measured back-to-back performance, we design the OSNR and the launched power into the MCF transmission line required for long-haul transmission over 7,000 km. Using an SD-FEC with a 20% overhead, the error-free operation can be achieved as long as the BER is less than 2.7 × 10 2 corresponding to a Q factor of 5.7 dB [12]. Supposing a margin of about 1.5 dB for the Q factor, we set the target Q factor at 7.2 dB which corresponds to the BER of 1.1 × 10 2. Using our PDM-QPSK transmitter and receiver, the OSNR would be required to be over 13 dB for a BER of less than 1.1 × 10 2, as shown in Fig. 6. Assuming a 2- ~3-dB penalty after transmission, the required OSNR after transmission is estimated to be over 15 ~16 dB. Figure 7 shows the calculated launched power required for an OSNR of 15 ~16 dB as a function of the transmission distance. The launched powers required for 7,000-km transmission are calculated to be 2.6 and 3.6 dBm/ch required for an OSNR of 16 dB and 15 dB, respectively. In our experiment, the launched power per channel was set at 2 dBm/ch corresponding to a total power of all 201 super-Nyquist-WDM channels of 21 dBm.

4.3 Results of transmission experiments

Figure 8 shows the Q factors and OSNRs of the channel at the frequency of 193.4625 THz as a function of the transmission distance with a fiber launched power of 2 dBm/ch as mentioned in Section 4.2. The Q factors are calculated from the measured BERs. The Q penalty is estimated to be 2.2 dB and 2.0 dB by referring to the OSNR at 6,370-km and 7,326-km transmission, respectively. Therefore, the significant performance degradation due to core-to-core crosstalk and fiber nonlinearity could not be observed even in ultra-long-haul transmission. Note that since the crosstalk of the optical switch in each loop input was relatively larger, the penalty caused by the crosstalk of the input optical switch was included in this Q factor penalty in particular for the shorter transmission distance.

The optical spectra before and after 7,326-km transmission are shown in Fig. 9. After transmission, the power differences of all channels were maintained to be less than 2 dB thanks to precise gain equalization. The measured Q factors after 7,326 km transmission are shown in Fig. 10. The inset shows the typical constellation of the received signal before MLSE. The Q factors of all 201 channels for seven cores of MCF were confirmed to be over 6.0 dB, which exceeds the limit of the 20%-overhead LDPC-based SD-FEC with the

2014-OE-Super-Nyquist-WDM transmission over

maximum number of iterations of 12, namely 5.7 dB [12].

14Qfactor [dB]

121086

2000

40006000Distance [km]

8000

20

OSNR [dB]18161412

Fig. 8. Measured Q factors and OSNRs as a function of transmission distance.

#200695 - $15.00 USD(C) 2014 OSAReceived 7 Nov 2013; revised 4 Jan 2014; accepted 7 Jan 2014; published 13 Jan 201427 January 2014 | Vol. 22, No. 2 | DOI:10.1364/OE.22.001220 | OPTICS EXPRESS 1227

上一页第8页

你可能喜欢

热门文档

相关文档

站点地图 | 文档上传 | 侵权投诉 | 手机版
本站所有资源均来自互联网,本站只负责收集和整理,均不承担任何法律责任,如有侵权等其它行为请联系我们.
文档下载 Copyright 2013 doc.guandang.net All Rights Reserved.  -  email