文档下载 文档下载导航
设为首页 | 加入收藏
搜索 请输入内容:  
 导航当前位置: 文档下载 > 所有分类 > 工程科技 > 信息与通信 > Pseudo-dynamic analysis of seismic stability of reinforced slopes considering non-associated flow
侵权投诉

Pseudo-dynamic analysis of seismic stability of reinforced slopes considering non-associated flow

J. Cent. South Univ. Technol. (2011) 18: 2091 2099 DOI: 10.1007/s11771 011 0948 3

Pseudo-dynamic analysis of seismic stability of reinforced slopes considering non-associated flow

Pseudo-dynamic analysis of seismic stability of reinforced slopes considering non-associated flow rule

A. Eskandarinejad1, A. H. Shafiee2

1. Civil Engineering Department, University of Hormozgan, Bandar Abbas 7193619411, Iran;

2. Civil Engineering Department, Shiraz University, Shiraz 7134851156, Iran

© Central South University Press and Springer-Verlag Berlin Heidelberg 2011

Abstract: The required reinforcement force to prevent instability and the yield acceleration of reinforced slopes are computed under seismic loading by applying the kinematic approach of limit analysis in conjunction with the pseudo-dynamic method for a wide range of soil cohesion, friction angle, dilation angle and horizontal and vertical seismic coefficients. Each parameter threatening the stability of the slope enhances the magnitude of the required reinforcement force and vice versa. Moreover, the yield acceleration increases with the increase in soil shear strength parameters but decreases with the increase in the slope angle. The comparison of the present work with some of the available solutions in the literatures shows a reasonable agreement.

Key words: reinforced slope; seismic stability; pseudo-dynamic approach; non-associated flow rule; cohesive slope

1 Introduction

Nowadays, various tools are available for stabilizing the slopes such as retaining walls, chemical grouting and using reinforcements which perhaps is the most significant one. Thus, the study of stability of reinforced slopes especially under seismic condition is of great importance. In the last three decades, the stability analysis of reinforced slopes has drawn the attention of researchers. The analytical study of stability of reinforced slopes under static condition has been carried out extensively by using the limit equilibrium method [1 2], the upper bound limit analysis [3 4], the lower bound limit analysis [5], and the slip line method [6 7]. Under seismic loading, LING et al [8] used the pseudo-static approach in conjunction with the limit equilibrium method to assess the stability and permanent displacement of geosynthetic reinforced soil structures subjected to horizontal earthquake acceleration. Later, LING and LESHCHINSKYI [9] extended LING et al’s [8] study by taking into account the effect of vertical earthquake acceleration. NOURI et al [10] applied a new limit equilibrium method named as the horizontal slice method to investigate the seismic stability of reinforced slopes. JAHANANDISH and KESHAVARZ [11] developed the slip line method to investigate the seismic bearing capacity of foundations on reinforced soil slopes. MICHALOWSKI [12] and AUSILIO et al [13] used the

kinematic approach of limit analysis to compute the reinforcement strength required to prevent failure. Their solutions are based on the associated flow rule. However, the soil dilation angle (ψ) often has values much smaller than its friction angle (φ), in practice.

Some experimental investigations are also available in the literature corresponding to the stability evaluation of reinforced slopes. HUANG et al [14] performed a series of tilting table tests to study the factors that may influence the failure mechanism of reinforced slopes. Centrifugal tests [15], full-scale model tests [16], and shaking table tests [17] are other common types of experimental researches to investigate the behavior of reinforced soils.

Numerical methods have been widely used in various geotechnical problems. The complicated and advanced softwares as well as powerful computers facilitate the solution of rigorous problems. ROWE and SODERMAN [18], and LING et al [19] applied the numerical methods to assess the stability and/or displacements of reinforced slopes. LING et al [19] conducted finite element analysis to simulate the construction response of a reinforced soil retaining wall with a concrete block facing. They observed satisfactory agreement between the predicted and measured results.

Cohesive slopes can also be used in reinforced soil structures. SAWICIKI and LESNIEWSKA [20] stated that one of the most important reasons for applying such soils is that the cost of locally available soils is much

Received date: 2011 02 21; Accepted date: 2011 06 27

Corresponding author: A. H. Shafiee, PhD Candidate; Tel: +98 711 6265149; E-mail: amshafiee@shirazu.ac.ir

第1页

你可能喜欢

热门文档

相关文档

站点地图 | 文档上传 | 侵权投诉 | 手机版
本站所有资源均来自互联网,本站只负责收集和整理,均不承担任何法律责任,如有侵权等其它行为请联系我们.
文档下载 Copyright 2013 doc.guandang.net All Rights Reserved.  -  email