文档下载 文档下载导航
设为首页 | 加入收藏
搜索 请输入内容:  
 导航当前位置: 文档下载 > 所有分类 > 工程科技 > 信息与通信 > FM_Antenna_Design_Challenges-Whitepaper
侵权投诉

FM_Antenna_Design_Challenges-Whitepaper

FM_Antenna_Design_Challenges-Whitepaper

Solving FM Antenna Design Challenges

in Portable Devices

Natalian Zhai, Silicon Laboratories Inc.

Introduction

FM radio has witnessed an explosion of interest from the market for its applications in mobile and personal media players; however, the traditional FM design approach requires a long antenna, such as a wired headphone, which limits its usefulness and usability. This whitepaper provides a description of an FM radio receiver solution that enables the antenna to be integrated or embedded inside the portable device enclosure, making the headphone cable optional. This paper covers techniques for maximizing sensitivity, including maximizing efficiency at the resonant frequency and maximizing efficiency across the FM band with a tunable matching network.

Maximizing Sensitivity

Sensitivity can be defined as the weakest signal that an FM receiver system can receive while achieving a certain signal-to-noise ratio (SNR). It is an important parameter of FM receiving system performance and is related to both signal and noise. The received signal strength indicator (RSSI) indicates only the RF signal strength at a particular tuned frequency. It does not provide any information about noise or signal quality. The audio signal-to-noise ratio (SNR) is perhaps a better measure for comparing receiver performance with different antennas. Therefore, maximizing SNR is essential for listeners to experience good audio quality.

Antennas are the connection between the RF electrical circuits and electromagnetic waves. For FM reception, an antenna is a transducer that converts energy from electromagnetic waves to a voltage that can be used by an electrical circuit, such as a Low Noise Amplifier (LNA). The sensitivity of an FM receiving system is directly related to the electrical voltage received by the internal LNA. To maximize sensitivity, the electrical voltage must be maximized.

There is a variety of antennas, including headphone, stub, loop, and chip antennas, on the market, but all antennas can be analyzed using equivalent circuits. Figure 1 shows a generalized equivalent antenna circuit model:

FM_Antenna_Design_Challenges-Whitepaper

Figure 1: Antenna Equivalent Circuit Model

In Figure 1, X can be either a capacitor or an inductor. The choice of X is determined by the antenna topology, where the value of the reactance (inductive or capacitive) is related to the antenna geometry. The loss resistance, Rloss, is related to the power dissipated in the antenna as thermal energy. The radiation resistance,Rrad, is related to the voltage generated from the electromagnetic wave. For simplicity, we will analyze the loop antenna model in the remainder of this article. Similar calculations can be made for other antenna types, such as the short monopole and headphone antennas.

Maximizing Efficiency at the Resonant Frequency

In order to maximize energy from the antenna, a resonant network is used to cancel out the reactive impedance of the antenna, which would otherwise attenuate the amount of voltage the antenna transfers to the internal LNA. For an inductive loop antenna, a capacitor,Cres, is used to resonate the antenna at the desired frequency:

fres 1

2 LCres

第1页

你可能喜欢

热门文档

相关文档

  • antenna_Filtronic

    6页 免费 Antenna Design 15页 5财富值 Antenna Array 8页 2财富值...Summary, challenges for the future Current status trends quad-band GSM quad...

  • 1. Agilent_Adavanced_antenna_design-March-30

    A. Balanis, “Antenna Theory Analysis and Design”, Ch. 14.2 The resonant resistance: G1 = I1 120π 2 Rin ( y = 0) = 1 2(G1 + G12 ) ...

  • 【论文】A NOVEL WIDEBAND ANTENNA DESIGN USING U-SLOT

    A NOVEL WIDEBAND ANTENNA DESIGN USING U-SLOT_专业资料。维普资讯 http://www.cqvip.com 、.5No2b1 .2 JOURNALOFELECTRONI CHI CSfNA Mac 08r...

  • PIFA Antenna Design-chinese traditional

    PIFA Antenna Design-chinese traditional_工学_高等教育_教育专区。天线研发初学者启蒙教材,非常不错?长荣硕士毕业?文 中华技术学院电子工程研究所 硕士 ? 文新式...

  • 解决便携式设备中FM天线的设计挑战

    解决便携式设备中FM天线的设计挑战_信息与通信_工程科技_专业资料。介绍解决便携式设备中FM天线的设计挑战的专业文献Solving FM Antenna Design Challenges 解决便携...

  • 6_EMPro2013_and_ EMI EMC Design Methodology using S...

    System EMI challenges IC PKG Board Cable Flex Connector -Great IC/PKG EMC/EMI design does not guarantee System EMC/EMI success -Customer specific BRD ...

  • Design of Low PIM Coaxial Diplexers

    Design of Low PIM Coaxial Diplexers_信息与通信_...Challenges High Volume – probably over 10,00 pa...pressure ridge (too expensive) Antenna area ...

  • mimo antenna 天线

    Thus, one of the main challenges to employ MIMO...In this paper, an UWB MIMO antenna with a ...II. ANTENNA DESIGN Manuscript received January 13,...

  • LTENetworkEvolutionandTechnologyOverview_CMW-26012-...

    White Paper I www.tektronixcommunications.com/LTE ... which support OFDMA and advanced antenna ...As these challenges are met and LTE is deployed...

  • Marvell-TX-Beamforming

    WHITE PAPER Transmit Smart with Transmit Beamforming...Transmit beamforming avoids some of the challenges ...antenna system beamforming to a 1 receive antenna...

站点地图 | 文档上传 | 侵权投诉 | 手机版
本站所有资源均来自互联网,本站只负责收集和整理,均不承担任何法律责任,如有侵权等其它行为请联系我们.
文档下载 Copyright 2013 doc.guandang.net All Rights Reserved.  -  email