The graph below shows an efficiency plot for two antennas (a headphone antenna and a short antenna) with fixed resonance at the center of the band (98 MHz).

Figure 1: Typical Fixed Resonance Antenna Performance in FM Band
From the above graph, 98 MHz achieves the best efficiency, but the efficiency degrades closer to the band edges. This is not a significant issue for the headphone antenna since the antenna is large enough to collect sufficient electromagnetic energy to transfer a significant voltage to the RF receiver across the whole band; however, the short antenna is small and collects less energy compared to a longer headphone antenna, and the efficiency also rolls off faster as the frequency moves away from resonance. This can present a problem for reception at the band edges using fixed resonance. This is primarily due to the fact that a short antenna will likely have a higher “Q” than a headphone, resulting in the sharper drop at the band edges.
The quality factor, Q, is proportional to the energy stored in the antenna network to the energy lost or radiated, per unit time. For the above antenna equivalent circuit with an antenna resonated network, Q follows below:
2 fL
Q Rrad12 fCres Rloss
A headphone antenna has inherently higher radiation resistance,Rrad, than a short antenna due to its larger
geometry, resulting in a lower Q than the short antenna. The issue of efficiency roll-off is very pronounced with the short high-Q antennas required for embedded implementations.
The antenna’s Q is also related to the bandwidth of the antenna. This relationship is given as:
Q fc BW
wherefc is the resonant frequency, and BW is the 3 dB bandwidth of the antenna. A short high-Q antenna has a smallerBWcompared to a long headphone antenna and increases losses at the band edges.
To overcome the bandwidth limitations of a high-Q, fixed-resonance antenna, a self-tuning resonant circuit is used to change “fixed resonance” to “tuned resonance” so that the circuit is always at the resonant frequency for maximum sensitivity. A higher SNR is achieved with a self-tuning resonant antenna because the gain from the
resonant antenna lowers the system noise figure of the receiver, and the inherent high Q of the embedded antenna helps filter interference that could mix with harmonics of the local oscillator.
Silicon Laboratories’ Implementation of a Tunable Matching Network
6页 免费 Antenna Design 15页 5财富值 Antenna Array 8页 2财富值...Summary, challenges for the future Current status trends quad-band GSM quad...
A. Balanis, “Antenna Theory Analysis and Design”, Ch. 14.2 The resonant resistance: G1 = I1 120π 2 Rin ( y = 0) = 1 2(G1 + G12 ) ...
A NOVEL WIDEBAND ANTENNA DESIGN USING U-SLOT_专业资料。维普资讯 http://www.cqvip.com 、.5No2b1 .2 JOURNALOFELECTRONI CHI CSfNA Mac 08r...
PIFA Antenna Design-chinese traditional_工学_高等教育_教育专区。天线研发初学者启蒙教材,非常不错?长荣硕士毕业?文 中华技术学院电子工程研究所 硕士 ? 文新式...
解决便携式设备中FM天线的设计挑战_信息与通信_工程科技_专业资料。介绍解决便携式设备中FM天线的设计挑战的专业文献Solving FM Antenna Design Challenges 解决便携...
System EMI challenges IC PKG Board Cable Flex Connector -Great IC/PKG EMC/EMI design does not guarantee System EMC/EMI success -Customer specific BRD ...
Design of Low PIM Coaxial Diplexers_信息与通信_...Challenges High Volume – probably over 10,00 pa...pressure ridge (too expensive) Antenna area ...
Thus, one of the main challenges to employ MIMO...In this paper, an UWB MIMO antenna with a ...II. ANTENNA DESIGN Manuscript received January 13,...
White Paper I www.tektronixcommunications.com/LTE ... which support OFDMA and advanced antenna ...As these challenges are met and LTE is deployed...
WHITE PAPER Transmit Smart with Transmit Beamforming...Transmit beamforming avoids some of the challenges ...antenna system beamforming to a 1 receive antenna...
热门文档