Design and Implementation of a Robust System to Measure GSM Radiation using Microstrip Antenna on a

24th

NATIONAL RADIO SCIENCE CONFERENCE (NRSC 2007) March 13-15, 2007
Faculty of Engineering, Ain shams Univ., Egypt DESIGN AND IMPLEMENTATION OF A ROBUST SYSTEM TO MEASURE GSM RADIATION USING MICROSTRIP ANTENNA ON A FOAM SUBSTRATE
Tarief Elshafiey, Omar Hosny, Judy Sirafim and Ramy Gamal
October University for Modern Sciences and Arts, 14 Amer St., El-Dokki, Cairo, Egypt
Email: telshafiey@gmail.com
Abstract This work presents design, analysis and implementation of a robust system to measure the power of the signal in the GSM range varying from 890 to 960 MHz. The system is composed of microstrip antenna on a foam substrate, RF detector, low pass filter, amplifier, analog to digital converter, and finally digital interface with a PC. As for the antenna, we designed and implemented microstrip antenna with bandwidth of 8% using foam as dielectric substrate. We used the system to measure the power of the signal in different places at different times during the day. Using the system we assured that the signal varies depending on the traffic at different times and the location with respect to the base station.
I. Introduction
The frequency spectrum in the GSM application is considered the most crowded range from the number of users’ point of view which reached 9 million users of mobiles in Egypt for instance. In recent years there has been a developing awareness that EM fields produced by everything ranging from power lines to mobile phones are implicated in a variety of illnesses including cancer [1] and [2]. It has been proven that EM radiation has a lot of hazards depending on the power and the frequency of the signal [3]. There are many ways listed in the literature describing the measurements of the EM strength in the far-field such as measurements on CW signals, modulation measurements and spectrum and network analyzers. Good references for these methods can be found in [4] and [5]. Unfortunately, most of these methods are complicated and not robust. The purpose of this work is to design, implement and analyze a simple, robust and portable system to measure GSM radiation. This work presents an extension of our previous work [6].
II. System Overview
The system is simply composed of a microstrip antenna with a central frequency of 925 MHz, followed by the direct RF detector and a low pass filter (LPF) ended by the digital system interface with the PC as detailed in Fig. 1.
demonstration of a practical implementation of the ... robust and responsive than the design alternatives...Radiation) 3 employs a NeuMotors 1115/1.5D ...
research about the implementation of advanced ...using solar radiation pressure and magnetotorquer, ...Yan, Adaptive robust PID controller design based ...
In this paper we describe the implementation of ... convection and radiation from the face of the ...ability to measure subtle surface temperature ...
How to measure radiation 暂无评价 8页 1财富值...warrant a working design Wavecrest 2 Outline ? ...BER curves are essential to quantify system ...
a new two-dimensional S=1 quantum spin system...Cu-Kα1 radiation (λ = 1.54060 ?) was ...using a Quantum Design SQUID magnetometer on ...
fabrication for dual-polarization implementation [3]...The simulated and measured radiation patterns of ...rms that this is a robust design. Good ...
plans for intensity-modulated radiation therapy (...A plan subscore is a measure for the deviation ...The clinical implementation of respiratory-gated ...
plans for intensity-modulated radiation therapy (...A plan subscore is a measure for the deviation ...The clinical implementation of respiratory-gated ...
热门文档