A Upgrade Mechanism Designed for Signal Processing Systems
J Mucklow1
Production Editor, Journal of Physics: Conference Series,
IOP Publishing, Dirac House, Temple Back, Bristol BS1 6BE, UK
E-mail: jacky.mucklow@iop.org
Abstract. All articles must contain an abstract. The abstract text should be formatted using 10 point Times (or Times Roman, or Times New Roman) and indented 25 mm from the left margin. Leave 10 mm space after the abstract before you begin the main text of your article. The text of your article should start on the same page as the abstract. The abstract follows the addresses and should give readers concise information about the content of the article and indicate the main results obtained and conclusions drawn.
1. Introduction
As the SDR (Software Defined Radio) technology has been widely used in signal processing systems, upgrades of the systems become possible. The upgrade methods for existing signal processing systems are mainly on-site. But for the devices mounted on a high altitude, underground, and other rough terrain, on-site upgrades are extremely difficult, or even impossible. Meanwhile, the devices need to be upgraded are of great quantity. For these reasons, the upgrade processes are tedious and costly. Therefore, an introduction of remote update mechanism to signal processing systems is of great significance. Most of the existing remote update mechanisms are designed for embedded systems [1], [2], and some researches only analyze the upgrade mechanisms for DSP [3], [4]. However, there lack an integral and specific discussion on remote upgrades of the signal processing systems in these researches.
In view of existing problems in the researches, a safe and reliable remote upgrade mechanism designed for signal processing system is proposed in this paper. In this remote upgrade mechanism, three critical points are discussed. The first one is upgrade mechanism between OMC (Operation and Maintenance Center) and terminals. The second one is a suitable terminal hardware and memory structure for remote upgrading. The last one is procedure designed for upgrading and loading program. The second and the last points will be discussed carefully in the sections below.
2. Upgrade mechanism between OMC and terminals
The system with remote upgrade mechanism is composed of one OMC (Operation and Maintenance Center) and several terminals as shown in figure 1. During the upgrade operation, the OMC is responsible for transmitting upgrade packages to terminal. When a terminal received the upgrade
1
To whom any correspondence should be addressed.
Ding, H.S. Tzou / Mechanical Systems and Signal Processing 18 (2004) 367–380 Table 1 Cases of free boundary paraboloidal shell for micro-sensing ...
Mechanical Systems and Signal Processing Journal of Computational and Applied MathematicsJournal of Computational and Applied Mathematics隐藏>> In order to ...
Generalized Approach to Signal Processing in CollaborativeWireless Sensor Systems for Target Det_专业资料。Cmpt ehooyadpitn2(0 3839oueTcnlg lai 21)5-6 ...
Lei_2008_Mechanical-Systems-and-Signal-Processing_物理_自然科学_专业资料。ARTICLE IN PRESS Mechanical Systems and Signal Processing Mechanical Systems and ...
Generalized Approach to Signal Processing in CollaborativeWireless Sensor Systems for Target Det_专业资料。Cmpt ehooyadpitn2(0 3839oueTcnlg lai 21)5-6 ...
热门文档