Darren Carpizo, M.D.
Overview: This assay is designed to assay a cell's ability to grow unattached to a surface andtherefore suspended in agar. The assays are done in 6cm plates. A bottom layer of enrichedmedia + agar is poured first (2.5ml), after solidifying this is followed by a layer containing alower amount of agar and containing a specified number of cells (cell layer = 5ml), after
solidifying a top layer is poured. The plates are placed in the incubator and after two weeks orso, colonies are counted by naked eye.
1) Make sol'ns of 2X Iscove's Media (Gibco BRL, dissolve one 1L packet in 500ml of water)
and filter sterilize, make about 100 ml of 1X by diluting the 2X, separate from this 100mlmake 100 ml of 1X Iscove's containing 10% FBS
2) Make Noble Agar (Difco) at 1.3% and place in 55° C water bath to keep in liquid phase
3) Determine the number of sample pairs you will be making (a sample pair consists of one
plate control and one plate experimental. I usually made 4 sample pairs or an n of 4. Addone to this, so n of 4 +1 = 5
4) The bottom and top layer solutions are made as one and divided in half. The cell layer
solution is made separately.
5) Determine the volume of reagents that make up each of the above solutions according to the
following formula:
Bottom/Top layer - 2X Iscove's 5ml X n sample pairs (5) = 25 ml
FBS - 1ml X n sample pairs (5) = 5ml
100X Glutamine .1 ml X n sample pairs = 0.5 ml
1.3% Noble Agar - 5ml X n sample pairs = 25ml
pour these volumes into a 50 ml conical and separate the total volume in 1/2 into one tube forthe bottom and the other for the top
**Do Not add the Agar until you are just ready to pour, so separate the total (without theagar) into a bottom and top tubes (the volume of agar that will be added to each will be12.5ml)
Cell Layer media - 2X Iscove's 2 X n = 10ml
1X Iscove's 4 X n = 20ml
FBS 1 X n = 5ml
100X glutamine 0.08 x n = .4 ml
Noble agar 2 X n = 10ml (again do not add this until ready to pour)
6) Pour 12.5 ml of 1.3% Noble agar to the bottom layer tube, mix thoroughly and pipette 2.5 ml
to each of 8 plates, place in 37° C incubator
7) Trypsinize cells, collect disattached cells and spin down, rususpend pellet in 5ml of 1X
Iscove's + 10% FBS for counting. Determine the conc of cells in cells/ml and then calculate
基本原理及实验目的 软琼脂克隆形成实验主要用于非贴壁生长的细胞,某些细胞(如正常成 纤维细胞)在悬浮状态下不能增殖,不适用于此法。某些恶性肿瘤细胞,不 仅在贴...
2.软琼脂克隆形成实验 将 p27Kip1 转染组、 空载体转染组和未转染组细胞以...该方法已广泛用 于一些生物活性因子的活性检测、大规模的抗肿瘤药物筛选、细胞...
soft agar assay protocol软琼脂克隆形成实验_生物学_自然科学_专业资料。1. ...6) 37℃ 5% CO2 培养,约 2-3 周收细胞,0.1%结晶紫染色,计数并比较两...
系强; 二倍体细胞克隆形成率弱,转化细胞系强;正常细胞克隆形成率弱,肿瘤细胞...正常细胞在悬浮状态下不能增 殖,不适用于软琼脂克隆形成试验。 ...
控制细胞迁移 2.软琼脂克隆形成试验: 适用于肿瘤细胞、转化 细胞和悬浮生长细胞...? ? MTT实验实习 2人为1组,每块96孔板共4人操作 预先接种细胞数: 103、3....
常用测定细胞增殖能力的实验方法 :MTT比色试验、克隆形成试验 常用测定细胞增殖...控制细胞迁移 2.软琼脂克隆形成试验: 适用于肿瘤细胞、转化 细胞和悬浮生长细胞...
将体内致 瘤实验和体外软琼脂克隆形成实验相结合来评价干细胞移植前后的安全性。...间充质干细胞组在接种 12 周后,未在裸鼠注射部位形成肿瘤,病理组织学检查未见...
体外克隆形成实验中 可以形成克隆,在异种移植模型中,只有移植人大量的肿瘤细胞... 卵巢癌与神经母细胞瘤细胞有能力在体外软琼脂培养基上形成克隆 (细胞克隆培养)...
细胞培养中涉及到的实验技1_生物学_自然科学_专业资料。细胞培养中涉及到的...如 把这种细胞群稀释分散成单细胞,在软琼脂培养基中进行培养时,细胞克隆形成 ...
热门文档