大学毕业论文上的英文翻译部分,关于“SCADA和DCS系统的网络安全风险评估”的英文翻译材料。
a combination of basic events. The set of minimal cut sets for the top event represents all the ways that basic events can cause the fault or top event. Quantification of FTA happens when top event probability is determined from basic event information by assigning probabilities to the basic events. Uncertainties in any quantified result can be determined. These top event probabilities can be used to calculate risk in financial or other terms. Several importance measures can be calculated to determine the change in the risk metric of interest such as the change in the top event probability when a basic event probability is set to zero.
Inductive approaches such as FMEA and FMECA are forward stepping and begin with an initiating event, then induce the end effects. It is important to note that these methods analyze single component faults and their system effects and do not consider combinations of faults. Walker, makes a strong case for using FMEA in the early design phase of all engineering projects to determine the project’s technical risk.
The basic difference between FTA and inductive methods is the direction of the analysis. FTA starts with the undesired event and traces backward to causes, whereas inductive methods start with an initiating event and trace forward to consequences. Thus, FTA is the appropriate analysis to carry out if a given undesired event is defined and the goal is to determine its cause. Inductive approaches should be used if a given set of causes are identified and the goal is to determine the consequences. A comprehensive PRA might use both inductive and deductive approaches to obtain a complete set of accident sequences, depending on the complexity of the system.
2.4. PRA extensions or modifications
Yacoub and Ammar present a methodology for architecture-level risk analysis. Their approach is based on dynamic risk metrics that define complexity factors for architecture elements obtained from simulation of the software architecture specifications. FMEA is used with simulation to determine the effects of a failure, and these results are used to develop heuristic risk factors for all components and connectors. The risk factors are aggregated and used with component dependency graphs to analyze the overall risk for the architecture.
Wyss et al. describe how features of event tree analysis and Monte-Carlo discrete event simulation can be combined with concepts of object-oriented analysis to form a new risk assessment technique (OBEST, object-based event scenario tree), though related to PRA. This OBEST method was developed to enable risk assessment study of systems and scenarios that exhibit strong time dependence (not a characteristic of SCADA systems).
Madan et al. applied a stochastic model to a computer network system to capture attacker behavior and analyze and quantify the security attributes. They determined steady-state availability of quality of service requirements and mean times to security failures based on probabilities of failure due to violations of different security attributes.
Taylor et al. merged PRA with survivability system analysis (SSA) with minor modification of what would be considered traditional PRA, but it is still dependent on obtaining estimates of probabilities.
暂无评价0人阅读0次下载举报文档 SCADA与DCS_信息与通信_工程科技_专业...2. 在网络方面,DCS 网络是整个系统的中枢神经,它是安全可靠双冗余的高速通讯...
关键词:DCS 系统安全;防火墙;网络架构 1 DCS 系统安全及现状 典型的DCS控制...SCADA(Supervisory Control And Data Acquisition)数据采集与监控系 统,是工业控制...
暂无评价0人阅读0次下载举报文档 SCADA系统中存在的安全风险及对策_能源/化工_工程科技_专业资料。SCADA系统管理,应用,技术与网络结构...
工业控制系统和SCADA系统的信息安全问题_计算机硬件及网络_IT/计算机_专业资料。...一旦网络流量异帯,戒者网络中传输栺式数据正确、但负载 过高,有可能致使DCS、...
流量计算,调峰调 谷等 SCADA 是调度管理层,DCS 是厂站管理层,PLC 是现场设备...2. 在网络方面,DCS 网络是整个系统的中枢神经,它是安全可靠双冗余的高速 通讯...
可编程逻辑控制器(PLC)、集散控制系统 (DCS)、远程测控终端(RTU)、智能电子...网络:SCADA系统的网络是最为复杂的,一般包括:连接各 个现场设备的现场总线网络,...
The President’s Critical Infrastructure Protection Board, and the SCADA 系统安全完全攻略 介绍 监控和数据采集(SCADA)网络包含为了给所有美国人提供基本服务和大宗...
DCS ICS ? ? ? OPC, Modbus, ProfiNet/ ProfiBus...SCADA2 Application Network Server Printer To Office... 控制系统的网络安全防护... 11页 免费 工业控制...
根据 安全性要求,上位机系统还可以实现冗余, 即配置...3、通信网络通信网络实现SCADA系统的数据通信, 是...四、SCADA、PLC与DCS SCADA系统集中了PLC系统的现场...
暂无评价0人阅读0次下载举报文档?关键词:SCADA,防火墙(Firewall),入侵检测系统(IDS),企业网(Corporate?Network)?? 在SCADA系统安全性问题上,管理人员通常有...
热门文档